R1Cellww Pooblem .a) Using the capautor voltige v e) andthe inductor current i)" as state vaviablet,write a set of state equations for thecircuit.b) Let R, = 2h, Rz = 42,L=1H and C=}F,Find the state transition matriy ē t).c) For Ni @) =0 and Li0) = 0, determine vE E)and Li) for t20 when e fe) = 10 V.

The state equation is given by: [X'] = A[X] + B[U] [Y] = C[X] + D[U] where, [X']= derivative of…

Problem a) Using the capauto voltige vite) and the inductor current i as itate vañables, write a set of state equatins fot the circuit. b) Let R, = 2n, Rz = 4h, L=1 H and C= F, Eud ta statu teansition matriy ē te).

Problem a) Using the capauto voltige vite) and the inductor current i as itate vañables, write a set of state equatins fot the circuit. b) Let R, = 2n, Rz = 4h, L=1 H and C= F, Eud ta statu teansition matriy ē te).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Find the total inductance at the terminals of the network in the figure below. 22 mH 12mH 6 mH 4 mH…

A: In the given question the 22mH is short circuited while 12mH and 6mH are in parallel which gives…

Q: The current source at the terminals of the 2 capacitors is of 120e-5 FA for the initial values of V1…

A: In this question we will find voltage across capacitor 1...

Q: 6. An inductive circuit of 50-2 resistance and 0.08-H inductance is connected in series with a…

A: The solution is given below

Q: The parallel capacitor combination shown in the figure is connected across a 12 V source. Determine…

Q: the circuit below assuming an ideal switch, preform transient analysis to predict the voltage oss…

A: given

Q: 1. Find the voltages across the following components (a and b) after 1 second. The Capacitor is…

Q: A3-nF capacitor with a 12-uC charge on it is discharged through a 3-kO resistor. What is the current…

Q: A series RL with R = 49-2 and L = 8-H connected across a 24 VDC source for a LONG TIME, how much…

A: Given series R-L circuit With R= 49 ohms. L= 8H

Q: A 250-V circuit, consisting of a resistor, an inductor and a capacitor in series, resonates at 50…

Q: A circuit contains series combination of a resistance of value 10 ohm, an inductance of value 40 mH…

A: The total impedance of the series RLC circuit is given as,

Q: A resistor with a resistance of 50 Q is connected in parallel with an inductor with an inductance of…

A: Inductive reactance of inductor = 2×pi×frequency ×inductance. If two impedances Z1 , Z2 are…

Q: Please show your detailed solution Number 17 A 100-mH inductor is connected across a supply of 50 V…

Q: Problem: 2.6.12.

Q: 6. The waveform of the current in a 40mH inductor is shown in following Figure. Find the waveform of…

A: The waveform of the current through the inductor, L= 40 mH isWe need to find the waveform of the…

Q: A 20-µF (C1) and a 40-µF (C2) capacitor are connected in parallel to a 480-V, 60-Hz source. What is…

A: Given: C1=20 μFC2=40 μFV=480 Vf=60 Hz C1 and C2 are in parallel to V

Q: What is the correct explanation for the voltage seen at Va in Figure C5? Vaz We will assume that the…

Q: Q6: Find the values of resistance R and inductance L in the circuit of Figure R 40 μF AI=1.54-35°A…

A: Fig: Given circuit In tyhe above circuit Zeq is given by…

Q: 1. A 2F capacitor is connected in series with a diode and a 60 resistor. The voltage of the battery…

Q: Determine the voltage across each capacitor in the circuit figure below. (VD₂ = 0.68 V, VD₂ = 0.56…

Q: An inductor of 230 milli Henry, a capacitor of 15 micro farad and a 200 ohm resistor are in series…

Q: Given the circuit with input of 80HZ, • Find the turns ratio • Find Vp(sec) • Find Vo when capacitor…

Q: A capacitor is connected into a 277-V, 400 Hz circuit. The circuit current is 12 A. What is the…

A: Here, Voltage V = 277 V Frequency f = 400 Hz Current = 12 A

Q: Problem 4: Determine the capacitor voltage after the switch is dosed if the capacitor initially is…

Q: The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M2 resistor, a 9.00-V…

A: Given a series RC circuit. with the following dataV = 9VC = 3.3 microFR = 4.4M OhmsAsked to find the…

Q: Vcc = +12 V a. Determine the following values for the fixed-bias configuration in the figure to the…

Q: a series rl with r = 31ohm and l = 2-h connected across a 24 vdc source for a long time, how much…

Q: Develop relation for unknown capacitance Cx and Unknown Resistance Rx for the AC Bridge circuit…

Q: Question 1 The current source at the terminals of the 2 capacitors is of 120e-St uFA for the initial…

A: In this question, Current in the capacitor is given. Find the voltage across the V2. All…

Q: A capacitor is connected into a 1250-V, 1000-Hz circuit. The current flow is 80 A. What is the…

A: Given data, The value of voltage is V = 1250 V. The value of frequency is f = 1000 Hz. The value of…

Q: OUTPUT VOLTAGE (V) 2.0 1.8 1.6 1.4 1.2 1.0 0.8 0.6 0.4 0.2 0 -50 a. TMP35 b. TMP36 c. TMP37 +Vs=3V…

Q: A 1kQ resistor, a 5mH ideal inductor, and a 1nF capacitor are connected in parallel. Find the total…

Q: An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so…

Q: (b) Find the equivalent inductance of the circuit in Figure Q3(b). 8mH 6mH a 5mH 12mH 8mH 4mH 6mH…

A: In this question we need to find a equivalent inductance of the given circuit across the terminal a…

Q: Find the equivalent inductance of the circuit shown in the figure. 0.06 H u 0.04 H 0.06 H 0.06 H u

A: Given circuit,

Q: Example 4: Determine the Q waveform and compare it with the input waveform. Assume Q = 0 initially.

Q: Consider the following. (LetC, = 24.60 µF and C2 = 18.60 µF.) 6.00 µF C, 9.00 V (a) Find the…

A: As we have given: C1=24.60 μF C2=18.60 μF

Q: Consider the parallel RLC circuit of Figure 2 with the source a 1-kHz sinusoid having an amplitude…

A: Redraw the given circuit as shown in Figure 1.

Q: A series circuit consists of a resistor, a coil, and a capacitor connected across a 300V, 60Hz AC…

Q: 07. Tice capacitors, a 12 µF, a 20 µF, and a 30 µF. are connected in series to a 60-Hz source. What…

A: In this question we will find reactance of series disconnected capacitors...

Q: Please show you detailed solution Number 44 A capacitor passes a current of 12.6 mA when supplied…

A: Given: Irms=12.6 mA, Vrms=20 V and f=1000 Hz. Required: Capacitance.

Q: Assume the passive sign convention. Consider the current waveform. i(0) (A) 2 10 1 2 3 -r(s)…

A: We need to find out Voltage across capacitor for given current through capacitor.

Q: An inductor is connected in parallel with a 120Ω resistor and a function generator. The applied…

Q: The total capacitance for this circuit is C₁ 5 F A. .035 farad. B. .06 farad. C. .026 farad. D.…

A: We have to find total capacitance for the given circuit.

Q: TLO TLO 1 A 100-mH inductor is connected in parallel to the series connection of a variable resistor…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Pooblem .
a) Using the capautor voltige v e) and
the inductor current i)" as state vaviablet,
write a set of state equations for the
circuit.
b) Let R, = 2h, Rz = 42,L=1H and C=}F,
Find the state transition matriy ē t).
c) For Ni @) =0 and Li0) = 0, determine vE E)
and Li) for t20 when e fe) = 10 V.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How should four 2.0 (F capacitors be connected (draw and name the circuit type) to have a total capacitance of (a) 8uF, (b) 2uF, (c) 1.5uF (d) 0.5uF?
. An inductance of 15mH has a current drawing I = 15sin(650t - 300) A. Determine the equation of voltage in the circuit
QUESTION 4 A 1kO resistor, a 5mH ideal inductor, and a 1nF capacitor are connected in parallel. Find the total impedance if a 12kHz voltage is applied across the circuit. O 1.26KNL79.9* O 1.890412.4° O 1.61kQ<-74.4° O 3620268.8°
In the diagram below, the switch S has been closed for a long time. A) What is the output voltage Vout? What is the charge on the capacitor? b) The switch is opened, so the output voltage increases. What is the time constant that describes the charging of the capacitor in terms of R and C? c) When Vout reaches 10 V, the switch closes and the capacitor begins to discharge. What is the time constant that describes the discharging in terms of R and C? Hint: Apply Kirchhoff's Rules to both loops and the sum of the currents at the junction above the capacitor in the diagram, and use I=dq/dt. If the switch opens when Vout reaches a lower value, say 5V, the capacitor will charge again, and thus one can cycle the voltage with a time constant determined by the circuit: this demonstrates the principle of operation of an electronic timer. 4R S 15 V Vout R
An impedance of 100 - j50 ohms in a network operating at 50 Hz represents a) A resistor of 100 ohms and an inductor of 0.159 Henrys b) A resistor of 100 ohms and a capacitor of 63.66 microfarads c) A 100 ohm resistor and a 1 Henry inductor d) A 100 ohm resistor and a 400 microfarad capacitor e) None of the above
A capacitor that is connected parallel to the inductor is added to the circuit image below to correct the power factor to unity. What would be the rating of the capacitor (answer should be in VARs) Thank you !!
An inductor with L = 150mH and r = 200(Omega) is in series with a capacitor, a resistor, and a generator of w = 1000 rad / s The voltage across the inductor Vind is measured to be 10.87 V, VR is measured to be 4.65 , and Vc is measured to be 5.96 V. What is the generator voltage V? (Hint: This is the measurement to be performed in this laboratory for LCR circuits. Use the appropriate equations to find VL and Vr' and then use them and the values of VR and VC to calculate V.)
Note this circuit below is of 4th order. Plot the voltages across capacitor C1 and C2. On a separate graph, plot the currents through the inductors.
2. Find the energy stored in inductor Lx for the circuit shown in figure C2 if total inductance of the circuit is 33mH. The current through Lx is 5 A 5 mH 9 mH LT 80 mH 70 mH 8 mH Figure C2
II. Suppose the voltage across the inductor is ΔvL = ΔVmax= RVmax sin wtFind the current through this inductor and draw the waveforms of both current and voltage R is equal to 4
The circuit in Figure Q5 consists of six(6) inductors. Find the net inductance between teminal a – b. 5 mH 5 mH 5 mH 5 mH 5 mH 5 mH Figure Q5
QUESTION 6 A resistor, a capacitor, and an inductor are connected in series with a mystery component. The resistor has a resistance of 5002, the capacitor has a reactance of 1002, and the inductor has a reactance of 1kQ. The total impedance of the circuit is 500+j1kO. What is the mystery component? O capacitor O there is no mystery material O inductor O resistor