Problem 9 -37 Find the thrust developed when water is pumped through a 300-mm-diameter pipe in the bow of a boat at 2 m/s and emitted through a 200-mm-diameter pipe in the stern. Ans: 354 N

Q: Fluid Mechanics Question

A:

Q: EXAMPLE 10.5. A pump delivers 2.5 cfs of 70°F water from a reservoir at elevation 50-ft to a…

A:

Q: 4- Air at 105 kPa and 37°C flows upward through a 6-cm-diameter inclined duct at a rate of Q (L/s).…

A: Answer  To determine the differential height between the fluid levels of the two arms of the…

Q: Water flows steadily with negligible viscous effects through the pipe shown in the figure below.…

A: Given: Required  Diameter at outlet

Q: The 50 cm diameter pipe shown below transfers water from reservoir A to a pressure turbine and…

A: Given Data Determine the power (in HP) from the turbine (P).

Q: A 75mm diameter orifice discharges 26 L/s of liquid under a constant total producing head of 3m. The…

A: ⁰0⁰⁰0⁰

Q: Q4/ In a Francis turbine, the flow velocity of water at inlet ( Vn1= 5m/sec) and its 2m outer…

A: Given:- Vn1=5m/sec diameter=2m guide vane angle = 20 degree n=120 rpm To find:- a) Vw1 b) absolute…

Q: Q1. A rectangular water tank of length 10m and width 6m has a free surface 15m above a 300mm…

A: Given data  Cross sectional area  Length Diameter  Coefficient of discharge

Q: Water flows through a 90° bend in a horizontal plane as depicted in the figure.

A:

Q: A pump is located near the edge of the horizontal platform shown. The nozzle at A discharges water…

A: Given data,  V = 28 ft /s Theta = 50°   To find out the range of value of height for which water…

Q: Water flows downward in a pipe at 30°. The pressure drop P₁ - P2 is partly due to gravity and partly…

A: Given- Height difference=50 cm, Water flow in the pipe with parameter shown in the figure. It is…

Q: Q20) For the steady flow of gas in the conduit shown, what is the mean velocity at section 2? Answer…

A:

Q: Discharge from an orifice of 75 mm diameter is 0.02 m³/s under a consta xternal mouthpiece of the…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.