Q1. A rectangular water tank of length 10m and width 6m has a free surface 15m above a 300mm diameter sharp edged nozzle that discharges to atmosphere. Ignoring friction, calculate: a). Velocity through the nozzle (m/s) b). Actual discharge of the nozzle (discharge coefficient of nozzle : 0.96) (m³/s) c). Mass flow rate of the nozzle (kg/s) %D

Q1. A rectangular water tank of length 10m and width 6m has a free surface 15m above a 300mm diameter sharp edged nozzle that discharges to atmosphere. Ignoring friction, calculate: a). Velocity through the nozzle (m/s) b). Actual discharge of the nozzle (discharge coefficient of nozzle : 0.96) (m³/s) c). Mass flow rate of the nozzle (kg/s) %D

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Water enters a pipe of length 10ft and diameter 2 inch with a mass flow rate of 150 kg/min. The density of water at a pressure of 2 bar is 961.5 kg/m³. Determine the work done at the entrance of pipe.
The nozzle which furnished the water to a certain hydraulic turbine 275mm in diameter and has coefficients of velocity and discharge of 0.98 and 0.96, respectively. The nozzle is supplied from a 60cm pipe in which the water approached the nozzle with a total head of 330m. Compute the following: a. Energy per second delivered by the jet to the turbine. b. Energy measured in hp lost in passing through the nozzle.
Addtl Qs. Determine the flow in line DC
Q, nozzle.
Water at 100 kPa flowing in a 10-cm-diameter pipe passes through a 2-cm-diameter flow nozzle equipped with a manometer across the nozzle. 10 cm 8 cm S = 10 12 cm S- 13 16.0 Determine the flow of water through the nozzle if coefficient of discharge is 0.7 a.) 1498 mL/s b.) 1433 mL/s c.) 4488 mL/s d.) 4539 mL/s e.)
6) Turbulent water flows from a tank to a pipe. The head loss relationship in the pipe can be 25 (-)). What is the discharge of water? described as h₁=0.025 몰 Water T = 60°F Elevation 100 ft D = 1 ft ↓ ↑ L = 1000 ft Elevation 60 ft 6 in. diameter jet
Determine the friction loss if the friction factor is 0.4 and velocity of the flow is 40 m per sec. Given length of the pipe is 20m, inner diameter 0.3m. Use friction loss formula. Using the calculated friction loss, solve for the ffg: a. What is the pressure drop due to the Bernoulli effect as the water goes into a 3.00-cm-diameter nozzle froma 9.00-cm-diameter fire hose while carrying a flow of 40.0 L/s? b. To what maximum height above the nozzle can this water rise? (To actual height will be significantly smaller due to air resistance.)
A cylindrical tank 1m in diameter and 6m high contains 2m of water, 1.50m of oil (specific gravity = 0.8) and air under pressure of 20 KPa. If the 10cm diameter orifice located at the vertical side is 30 cm above the bottom of the tank, find the actual discharge at the orifice if C = 0.95. A) No Answer among the choices B) 79.11 L/s 59.95 L/s D) 54.40 L/s E) 73.45 L/s
A closed tank contains 20 m deep water. A hose is connected as shown such that the nozzle (diameter = 1cm) is directed straight up, If the air gage pressure inside the tank is 20©kPa, solve the actual mass flowrate if the coefficient of discharge through the nozzle is 0.6. AIR 20 m O 1.59kg/s O 1.22kg/s O 1.86kg/s O 1.33kg/s
Fluid mechanics