Problem 6: Water at 20 ̊C is siphoned from a reservoir as shown in the Figure. For d = 7.5 cm and D=15 cm, determine the following: (a) the maximum flow rate (in m3/s) that can be achieved without cavitation occurring in the pipe system, (b) the maximum elevation (in m) of the highest point of the piping system to avoid cavitation. (c) Also, discuss the ways of increasing the maximum elevation of the highest point of the piping system to avoid cavitation

Q: Problem 7: The two pumps in problem 6 are now arranged in parallel. The static head is 40 ft. The…

A: Given that the two pumps are connected in parallel. The static head is 40ft. Hs = 40ft Diameter, D =…

Q: Two tanks A and B have 80 m difference in water levels, and are connected by a pipe 0.3 m diameter…

A: Friction factor f = 4F = 4×.002 = .008 Total inflow = Total net flow at junction CQ1 = Q2 + Q3Q1 =…

Q: Water transfer from down reservoir to upper reservoir Water is pumped from the reservoir for…

A: Given, Flow rate, Q = 600 m3/hr or 0.167 m3/s Vapor pressure of water = 2340 Pa The pump efficiency…

Q: Water is pumped from the river through a 45-mm-diameter hose having a length of 3 m. The friction…

A: Diameter of the pump hose = 45mm = 0.045mLength                                   = 3mFriction…

Q: 3. If the flow rate through a 10 cm-diameter wrought iron pipe is 0.04 m/s as shown in figure below,…

A:

Q: Determine the elevation of the free surface in Tank B if the total discharge into Tank B is 5.00…

A: ###Determination of Elevation of Tank B###

Q: Problem 6-76 Oil is flowing upward through a Venturi meter as shown. Assuming discharge coefficient…

A:

Q: When the three reservoirs are connected by a pipeline as shown in the following figure, (1) use the…

A: z1 - hf1 = z2 - hf2      and    z2 - hf21 = z3 - hf3  80 - hf1 = 100 - hf2  and  100 - hf2  = 70 -…

Q: A pump delivers water at a flow of 10 cubic feet per second (cfs) from a lower reservoir to an upper…

A: Discharge  Q=10 ft3/s=0.283168 m3/sec     diameter d=16 in=1.33 ftarea A=π4×d2=π4×16122=1.396 ft2…

Q: The elevations of water surfaces in reservoirs A and B are 300 ft and 250 ft, respectively, and…

A: g =9.81m/s2 = 32.185 ft/s2  Q1 = 50ft3/s

Q: ISTINYE ISU UNIVERSITY Question 2: A steel pipe is used to drain water from a reservoir that is 50 m…

A:

Q: The water surface in reservoir X is 6 m higher than that in reservoir Y. A 150 mm diameter pipe 270…

A: Bernoulli's equation generally defines the total mechanical energy of the flowing fluid comprising…

Q: 3.18. Water is pumped from a supply reservoir to a ductile iron water transmission line, as shown in…

A: Given : Dia of pipe == 750 mm Pressure at A = 350 kPa

Q: he head-discharge relationship for a certain pump can be represented by the equation H = 28 - 9Q2.…

A:

Q: Târee reservoirs A, B, and C are connected respectively with pipes 1, 2, and 3 joining at a common…

A: Given : Elevation of reservoir A = 80 m Elevation of reservoir B = 70 m Elevation of reservoir C =…

Q: 10. Water is flowing in a straight 150 mm diameter, high density polyethylene (HDPE) pipe installed…

A:

Q: PROBLEM 3 An 85-percent-efficlent pump is used to Increase the pressure of water in a 10-cm-diameter…

A: To find out the  A) Head Added by pump.  B) Required horse power of the pump for discharges 0.015…

Q: (viscosity: v = 1 × 10-6 m² /s, SG = 0.9) flows from the upper voir at a rate of 0.028 m³/s in the…

A:

Q: Pipes 1, 2, and 3 are parallel with each other as shown.If the energy at the inflow pipe A is 147…

A:

Q: H.W(2):Water flows steadily from a large tank through a pipe that splits into two smaller pipes as…

A: Given data in question  Water Depths Diameter  To find out  Pressure at point 1 Discharge through…

Q: The three water-filled tanks shown in the figure below are connected by pipes as indicated. If minor…

A:

Q: Flow of a liquid in a smooth 3 cm pipe yields a head loss of 2 m per meter of pipe length when the…

A: Given- a pipe carrying a liquid with the mean velocity of 1m/s. Required- to  find friction…

Q: 2. It is known that an irrigation channel has a rectangle with width (b) = 4.5 m, height (h) = 5 m,…

A:

Q: The discharge of the pipe system shown is 0.9 m³/s. the length of pipes 1, 2, 3, 4, and 5 are 1000…

A:

Q: Water flows in a 1-m-diameter pipeline from a reservoir through a turbine and discharges freely as…

A: To Determine a) Power extracted by the Turbine, P b) Flow Rate (Q) through the system

Q: Water is going to be pumped between point A and B as shown in Figure below. Calculate the maximum h…

A: Given, Q = 90 L/s or 0.09 m3/s D = 0.30 m

Q: 2. A nozzle 3 m long has a diameter of 1.3 m at the upstream end and reduces linearly to 0.45 m…

A: Figure is as shown

Q: The three water-filled tanks shown are connected by pipes as indicated. If minor losses are…

A: Pipe 1: Elevation: Diameter of pipe: Length of pipe: Friction coefficient: Pipe 2: Elevation:…

Q: Problem 3 A reservoir with water is pressurized as shown. The pipe diameter is 1 in. The head loss…

A: Detailed solution is given below, still if you have any query please feel free to contact me.Thanks…

Q: In the branched pipe system shown, 850 L/min of water at 10°C is flowing in a DN 100 Schedule 40…

A: Data given Q =  850 L/min  = 0.0141 m3/s Total length of pipe in the lower branch, L2 = 60 m L1 = 30…

Q: Reservoirs A and D are connected by a pipeline system as shown below. The water surface elevations…

A: Given, Surface elevation of reservoir A = 100 ft Surface elevation of reservoir B = 80 ft

Q: What is the required pump power (Pa) for the system below?

A:

Q: Determine the flow in each pipe in the reservoir shown below. Use the values provided in the table.…

A: To Determine the flow in each pipe in the reservoir shown.

Q: A 5 cm diameter siphon tube is used to empty the pool and discharged it into air (figure below).…

A:

Q: Q2/B /Water is transported from a reservoir at higher elevation to another reservoir through a…

A:

Q: 0 ft (assume this is 1000.00 ft). The flowrate in the system from ervoir is 5 cfs. Assume the water…

A: Solution-   (a)  Hazen williams equation:        hf =4.73lQC1.852-1d4.87    here , For first 1000 ft…

Q: s and the friction factor f is equal for all pipes, then:

A: Solution  The pipes are connected in parallel then - we know that   Q=Q1+Q2+Q3........1   And…

Q: 2. A nozzle 3 m long has a diameter of 1.3 m at the upstream end and reduces linearly to 0.45 m…

A: As per Bartleby policy i can answer  only one question at a time. Please upload other questions…

Q: Water is being discharged from an upper reservoir to a lower reservoir through a turbine (assume 80%…

A: Given  Discharge = 0.15 cumec Efficiency = 80%  Height difference = 197.3- 50 = 147.3 m To calculate…

Q: Water at 20°C is pumped at a rate of 15 L/s into a reservoir as shown in the Figure below. Between…

A: The rate of flow into the pipe, Q = 15L/sThe diameter of the pipe, D = 100mmThe length of the pipe…

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.