PROBLEM 502 Block A us=0.2 Determine the maxımum force P that can WA=450 KN be applied to block A without causing either block to move. Block B Ms=0.1 Figure. WB= 1000 KN %3D

Q: Determine the maximum force P that can be applied to block A without causing either block to move.

A: free body diagram of Blocks

Q: Determine the weights W for which the 100 Ib block is in equilibrium. H 0.30 H = 0.25 100 lb 20

A: For a system  to be in equilibrium, the net external force and torque on the body should be zero. To…

Q: If blocks D and F weigh 5 lb each, determine the weight of block E if the sag s=3 ft. Neglect the…

A:

Q: When two flat surfaces are pressed together by an axial force, they are capable of transmitting a…

A:

Q: In the figure shown, the blocks weigh 200 N each. Both are connected by a horizontal bar weighing…

A:

Q: Chain AB is 1-m long and chain AC is 1.2-m long. If the distance BC is 1.5 m, and AB can support a…

A: The schematic diagram for the following condition is

Q: A B -1 ft- 4 ft +1 ft-

A: We have to find normal force

Q: Q2: The 80-lb block C rests on the uniform 15-lb bar AB. The cable connecting C to B passes over a…

A: The free body diagram of the block C is as follows: The force in the vertical direction is as…

Q: Determine the force P needed to cause the impending motion of the block

A:

Q: Determine the force P for impending sliding motion of block A 30° IMPENDING MOTION B 50lb ALUMINUM A…

A:

Q: The three forces, each of magnitude F, are applied to the crate. Determine F so that the three…

A: Given The magnitude of three forces is equal to F. The resultant of three forces is R=400 lb The…

Q: Find the friction and the tension in A and B

A: ven

Q: 3)The 200-kg crate a is suspended using the ropes AB and AC. Each rope can withstand a maximum force…

A:

Q: A block R of mass 100 kg is placed on a block Sof mass 150 kg as shown in the figure. Block R is…

A:

Q: Determine the maximum weight of the bucket that the wire system can support so that no single wire…

A:

Q: A fixed crane in Figure Q2(a) has a weight of 11 kN is used to lift a 25 kN crate. It is held in…

A:

Q: force in each cable

A:

Q: Determine the forces in each cable if P = 10kN.

A:

Q: A 480-lb lawn roller is to be pulled over a curb with a height of 8 in. as shown. Determine the…

A: Given: The weight of the roller is, W=480 lb. The diameter of the roller is, d=4 ft× 12 in1 ft=48…

Q: B -2 ft x 3 ft Z F 1 ft D .3 ft 6 ft Aft 2 ft

A:

Q: THE 500LB BOX IS RAISED USING ROPES AB AND AC. EACH ROPE CAN WITHSTAND A MAXIMUM TENSION OF 2500LB…

A:

Q: magnitude of the vertical reaction force developed at the point B

A: Given; Two steel truss members, AC and BC, each having cross-sectional area=100 mm2It is subjected…

Q: Determine the force in each cable needed to support the 500-lb load. 6 ft 6ft 3 ft 50 6 ft 2ft

A: Given that: A load of 500 lb is supported by three wires. It is required to determine the forces in…

Q: Solve for the force P that would cause motion if the top and bottom block remain stationary and the…

A:

Q: The two 200-N blocks are pushed apart by the 15 degrees wedge of negligible weight. The angle of…

A:

Q: Block B is on top of an inclined plane and is being supported by Rod AB, which is attached to Block…

A: Given Blocks under tension with a rod To find Magnitude of normal of the blocks

Q: 200 N 6. 15 E= 100 6pa V= 0.a5 0:5 m

A:

Q: Determine the smallest required remove force. the wedge.

A:

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.