Problem 5 Knowing that the ultimate stress at points A, B and D are 30 MPa, 155 MPa and 140 MPa respectively, what is the maximum allowable couple M that can be applied onto the beam of the shown cross section forming an angle ß with the vertical plane. B = 15° B M so mm 20 mm so mm 30 mm

Q: A rigid beam is supported by bar DE. If the vertical displacement of point D is to be less than 0.1…

A: Let FDE be the force on the bar DE.Vertical displacement at point D will be equal to the change in…

Q: When an axial load is applied to the ends of the bar shown in the figure, the total elongation of…

A:

Q: The triangular plate is fixed at its base, and its apex A is given a horizontal displacement of 5…

A: The triangular plate with dimensions as shown in the figure below,Horizontal displacement,

Q: The grain of the wooden member forms an angle 15° with the vertical. For the state shown in Figure…

A: Mohr's circle Mohr's circle is a graphical depiction of a point's overall condition of stress. It is…

Q: Problem 5.9 A solid steel bar has a cross section of side b and is supported as shown. Knowing that…

A: To Determine Depth of the beam, b

Q: The rectangular plate is subjected to force P that causes elongation in the horizontal direction and…

A:

Q: Problem 1. From the given beam and loading in the figure. a. Determine the neutral axis of the beam…

A:

Q: What is the max shear stress in the shaft? Input your answer as a value only in MPa to one decimal…

A:

Q: The differential element above represents the state of plane stress at a pont J steel beam. Which of…

A: Given data: σX=60 ksiσY=-20 ksiζXY=40 ksi

Q: 3. b) The state of stress at a point is shown on the element. Using Mohr's cicle, determine The…

A:

Q: Consider a point in a structural member that is subjected to plane stress. Normal and shear stresses…

A:

Q: Problem#1 A cantilever beam along with its cross-section is shown in the figure below. 1) Determine…

A:

Q: 3. The shaft in the figure below consists of 75 mm diameter bronze segment that is rigidly joint to…

A: Solution:- We know that, torsion equation is TJ=τr=GθL by using this relation, the stress in AB…

Q: The horizontal beam is supported by a pin at A and the pin-connected link BC. It has a uniformly…

A:

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.