Problem 4: The U-tube manometer is also widely used to measure the difference in pressure between two containers or two points in a given system. As an example a manometer connected between containers A and B is shown in Figure. Pipe A is filled with the diesel fuel has a specific gravity Yaiesel fiel-8.326 kN/m and pipe B filled with engine oil has a specific gravity Ymeine oil -8.955kN/m' If the pressure in pipe A is 105.49kN/m2 Determine the pressure at B. (Ymercury=133KN/m') (Munson and Young, 1998) %3D

Problem 4: The U-tube manometer is also widely used to measure the difference in pressure between two containers or two points in a given system. As an example a manometer connected between containers A and B is shown in Figure. Pipe A is filled with the diesel fuel has a specific gravity Yaiesel fiel-8.326 kN/m and pipe B filled with engine oil has a specific gravity Ymeine oil -8.955kN/m' If the pressure in pipe A is 105.49kN/m2 Determine the pressure at B. (Ymercury=133KN/m') (Munson and Young, 1998) %3D

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Can you give me an example of laying out compound curves, please include explanation for each process/procedure of the solving.
Q5 Explain by sketch only 5 of the following: 1- the effect of heat rolling on grain size 2- three high rolling mill. 3- the forces acting on turning machine during cutting 4- continues drawing of wire. 5- Stress types of forming process 6- Deep drawing process
Please answer 7-10 only Thank u!
The piston diameter of a 6-stroke 1-cylinder gasoline engine is given as 4.25 inch mm, the piston stroke is given as 3.75 inch. Since the compression ratio of this engine is 9.5, find the stroke volume, combustion chamber volume and cylinder volume in cm3.
Answer this please. Thank you very much
An electric hot water heater consumes 3.1 kilowatts of electricity and converts it to heat. How long will it take the water heater to heat a 67 gallon tank of water from 10 degrees Celsius to 50 degrees Celsius? (1 kilogram of water is 0.37 gallons, 1 Calorie = 4200 J). It may be helpful to refer back to the weekly handout for guidance on this problem. Your final answer should be in minutes (rounded to the nearest 10 minutes).
Q1/A) Answer only Seven_of the following multiple choice: 1- Brass can be classified in one of the following materials categories: a- Ferrous material. b- Non-ferrous material. c- Composite material. d- Non-metallic. 2- The crystal lattice has a --- a- One dimensional. b- Two dimensional. c- Three dimensional d- Four dimensional. 3- The coordination number for FCC structure is: arrangement а- 2 b- 4 с-8 d- 12 properties c-Mechanical 4- Material density classified as a- Physical. 5- The ability of materials to resist impact is named a- Ductility. 6- One of the following hardness tests are not classified as a macro hardness test: b- Chemical. d- Thermal. b- Toughness. c- Strength. d- Elasticity. a-Brinell hardness. b-Vickers hardness. c- Knoop diamond. d-Rockwell hardness. 7- Due to Allotropy phenomenon, Iron in range of temperature varried between 769 and 910 C° has one of the following names and crystal strutures: a- Gamma (BCC). 8- One of the following hardening processes not need to…
You need to find out the maximum NPV of a hypothetical iron ore open pit as shown below. The iron ore grade is 72% and recovery is 90%. The market price of iron ore is $100/ton. The ore and waste block size are 30 by 30 by 30 m3 and annul production of six blocks (mining + stripping) is there. The mining cost is $35/ton and the stripping cost is $25/ton. The density for the ore and waste is 4.5 ton/m3 and 2.5 ton/m3 respectively. Assuming initial investment $50 million the interest rate is 5% per year.
Show answer in detail calculation and explanation.
What’s the correct answer please?
Can you solve this with steps?
So, what is the answer of Ra ?