Problem 3 Consider the system function 1 +2z−1 + z−2 H(z) 10.75z1 + 0.125z-2 and sketch the system block diagram using (a) direct form I structure (b) direct form II structure (c) parallel form structure.

Problem 3 Consider the system function 1 +2z−1 + z−2 H(z) 10.75z1 + 0.125z-2 and sketch the system block diagram using (a) direct form I structure (b) direct form II structure (c) parallel form structure.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.8P: Consider the circuit shown in Figure 2.23 in time domain. Convert the entire circuit into phasor...

See similar textbooks

Related questions

Q: A 2-MVA, 4400-V, 25-Hz, Y-connected, three-phase, synchronous generator is tested at its rated speed…

Q: 9. Clock, S, R and clear waveforms are shown below for a positive edge-triggered SR flip flop with…

A: Truth table : Output Q :

Q: 02. Do as required: (4 1. Evaluate: f(x)=fdx 3. Evaluate: lim ( to sing 2. Find the Taylor series of…

Q: wwwww & Analyze in details the operation of the following circuit, write its truth table, then find…

A: The given circuit is;Write the trouth table and logic function.

Q: 6. The instantaneous value of an alternating current is 5 mA at a displacement angle of 60°.…

A: Step 1: Step 2: Step 3: Step 4:

Q: Using mesh analysis please show how to determine the current i10 if it is -2.29 A.

Q: Please answer in typing format

A: Initial Current ((i(0))):Before the switch closes, the inductor current ((i_L)) remains constant.…

Q: The three-phase full-bridge inverter in the next figure has a Y-connected resistive load of R = 6.5…

A: Step 1: Step 2: Step 3:

Q: 7. Prove that the output (Vo) of a differentiator is given by: Vo=-RC (dvin)

A: Step 1: Step 2: At node X,Vx=0 [ virtually concept] Step 3: Apply KCL at node…

Q: Please see attached. Thank you for the help on this. I think I got it right but just want to make…

A: Step 1:

Q: Compute the average power delivered by the source.

A: Step 1: Since the given impedances are at 50 Hz as per the question, we need to simplify them…

Q: Solve for avg power

Q: 1. This circuit has two ideal OPAMs. Find Vout as a function of the signal Vsi. Since the OPAMs are…

Q: x(t) = (A+m(t)) cos(100πt) m(t) is a low-pass signal with B<<50. A=10. Write down Fourier transform…

A: Step 1: Step 2: Step 3:

Q: I need the expert's solution handwritten.

A: A:Answer:B:C:

Q: In the figure, R = 22.50, C=4.31 μF, and L = 35.1 mH. The generator provides an emf with rms voltage…

A: Certainly, I can assist you with analyzing the circuit in the image to determine the RMS current and…

Q: A capacitor may open if you: discharge it too fast. apply voltage in excess of the rating. allow it…

A: The question is asking about the conditions under which a capacitor may open or fail. A capacitor is…

Q: Find v(t) for this figure w 12cos(2t) ΙΩ ง 2F -2 H ww m ΖΩ 1F + v(t)

A: Step 1: Step 2:

Q: Solve a to c handrwitten step by step solution by also showing the inverse z transform if necessary…

A: Step 1: Step 2: Step 3: Step 4: Step 5:

Q: 4. The transistor in the amplifier below has been biased such that IC - 0.3mA (no need to do DC…

A: Step 1:Step 2:Step 3:

Q: blem... Videos Set Notation (soluti... Required documents O Sign in In Quiz - Final σ In the…

A: For an op-amp phase shift oscillator, the frequency of the circuit is given by the following…

Q: Videos Set Notation (soluti... Required documents Sign in C In t - Final In the following circuit…

Q: In the amplifier circuit shown in Fig. Q5, the BJT Q1 has ẞ= 100 and V₁ = 100 V. The MOSFETs, M1 and…

A: Step 1:Step 2:Step 3:Step 4:

Q: GMR calculate

A: Step 1:Step 2:Step 3:Step 4:

Q: Whenever lines of magnetic force cut across a conductor: Select one: a. a voltage will be induced in…

A: The question is asking about the phenomenon that occurs when lines of magnetic force cut across a…

Q: Please answer in typing format

A: Let's start with part (a): Given:Pavg=100mWVs=3VRs=20ΩRL=1kΩ We'll use the formula…

Q: 9. For practice question only need reference. Thanks for the help! show solution.

Q: Use the voltage divider rule to calculate the voltage Vab and record it in the second column of…

A: Step 1:

Q: Needs Complete solution with 100 % accuracy don't use chat gpt or ai i definitely upvote you.

Q: Needs Complete solution.

A: The objective of this question is to find the voltage drop across resistor R3 in a series circuit.…

Q: Using Kirchhoff's Theorem, write the complete, but SIMPLIFIED loop equation for LOOP 1 (May use…

A: Kindly see attached photo for your guidance.

Q: The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert…

A: Ohms law V = IRGiven R = 15 kohmFor i1 = 3.5sin(2500t) mACurrent in polar form = 3.5<0° mAMath in…

Q: Needs Complete solution with 100 % accuracy.

A: The objective of this question is to find the voltage drop across resistor R3 in a series circuit.…

Q: For the following circuit, determine:a) the equivalent resistance (please note that the values of…

A: Step 1: Step 2: Step 3: Step 4:

Q: Higher AC frequency in an inductor results in: Select one: voltage lagging current. shorts in the…

A: The question is asking about the effect of increasing the frequency of an alternating current (AC)…

Q: Coiling a current-carrying wire: Select one: distributes the magnetic poles over the whole coil.…

A: Coiling a current-carrying wire creates inductance. This happens because the magnetic field produced…

Q: A boost converter is modeled by including a switch resistance, sw = 0.08 an inductor resistance, r₁…

A: a) To derive the relation for ( Vo/Vin ) considering the non-ideal effects of the boost converter,…

Q: "The topic is electromagnetic fields. I need an expert solution in written form."

Q: If a clock pulse is needed to generate a frequency of 5.64 kHZ with a duty cycle of 60%, what must…

A: Another method using online calculator

Q: Provide complete solution of the given problem in the image.

A: Step 1:

Q: Q1: Part b) The switch in Figure 1 b has been closed for a long time. At t = 0, the switch is…

A: The objective of the question is to determine the voltage across the capacitor vc(t) and the current…

Q: Please answer in typing format and don't be AI solution either i will dislike

A: When you're measuring power in a three-phase system, the phase sequence matters because it affects…

Q: I need the expert's solution clearly and fully handwritten.

A: Step 1:Step 2:Step 3:Step 4:

Q: Get the electromechanical analog model (torque-voltage or torque-current) of the system. With all…

A: Step 1:Γ=kΘ+BΘ'+JΘ''is equation of Rotational mechanical system. Where Tau = Torque,J =Moment of…

Q: Adding a core of magnetic material to an electromagnet: Select one: allows greater current to flow.…

A: The objective of the question is to understand the effect of adding a core of magnetic material to…

Q: Draw the Output Waveforms: Analyze and draw the output waveforms for the following digital circuits,…

A: D Latch (Active-High Enable):Step 1: Enable Check (E High):If the Enable signal (E) is high, the…

Q: In the following Wien bridge oscillator, assume, R2 = 40 kQ R3 R4 90 kQ C1 C2 = 20 nF What is the…

A: Step 1:In Wein bridge oscillator, For sustained oscillations the conditions are…

Q: Needs Complete solution with 100 % accuracy. Don't use chat gpt or ai i definitely upvote you.

A: The objective of this question is to find the voltage drop across resistor R3 in a series circuit.…

Q: I need an expert solution using Noodle's theory of simplification.

A: Step 1: Step 2: Step 3: Step 4:

Q: None

A: EMG Recording Setup:(a) Diagram:Electrodes: Two electrodes will be placed on the skin over the…

Question

100%

please solve a to c in handwriting showing each step also showing steps for the inverse z transform thank you

Problem 3
Consider the system function
1 +2z−1 + z−2
H(z)
10.75z1 + 0.125z-2
and sketch the system block diagram using
(a) direct form I structure
(b) direct form II structure
(c) parallel form structure.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then what is the capacitance in micro Farads? Answer in micro Farads.
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
QUESTION 3 An inductor, a capacitor, and a resistor are connected in series with a function generator. The inductor drops 5V RMS, the capacitor drops 20V RMS, and the resistor drops 2V RMS. Find the magnitude of the total voltage. O 27V RMS O 15V RMS O 38V RMS O 9V RMS
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
What's 23
Calculate values of asked physical quantities of the circuit in the figure. What is the capacitance of system 23? C23 C₁ = 3.0 F What is the capacitance of system 123? C123 = F C₁ = 2.0 F What is the capacitance of system 45? C45 = F Your last answer was interpreted as follows: 1 Your last answer was interpreted as follows: 1 What is the charge in the capacitor system? C Your last answer was interpreted as follows: 1 What is the total capacitance of the system? F Value 8.8500 x 10 EO Quantity permittivity of free space capacitance capacitance capacitance capacitance capacitance Your last answer was interpreted as follows: 1 capacitance of system 23 capacitance of system 123 capacitance of system 45 Your last answer was interpreted as follows: 1 Do not leave any fields blank. If you don't know the answer, insert 1 for example. Insert the answer with 3 significant digits without rounding the answer. Constant U = 7.0 V Unit E Symbol €0 C₁ = 3.0 F C1 C₂ C3 C4 C5 C23 C₂ = 9.0 F C₂ = 3.0 F…
If the resistors used for charging and discharging were the same, the charging anddischarging waveform would be ________.a. Symmetricalb. Nonsymmetrical
Pls. write solution neatly
Question 4
3-10 A0.25-F capacitor has a current waveform i(t) as shown in Figure P3–10. Determine and plot the voltage waveform v(t) as a function of time. The capacitor is initially a and plot the voltage waveform v(t) as a function of time. The capacitor is imu uncharged. FIGURE P3-10 ilt) 4 A 6. -4 A
Determine the capacitance of each other and tolerance of each capacitors shown below
QUESTION 11 An inductor is connected in parallel with a 6540 resistor and a function generator. The applied voltage is 42V RMS and the total current is 67mA RMS. Find the magnitude of the current through the inductor. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in mA but do not enter the unit.