Problem 3:A cylinder contains an ideal gas and is closed by a movable piston. The cylinder is kept submerged in anice-water mixture. The piston is quickly pushed down from position 1 to position 2 and then held at position2 until the gas is again at the temperature of the ice-water mixture; it then is slowly raised back to position1. Below is a p-V diagram for the process.PressureV₂VolumeIce andwaterStartV₁If 100 g of ice is melted during the cycle, how much work has been done on the gas?

Answered: Image /qna-images/answer/31c5677b-fc86-4132-97ae-d652666e4697.jpg

Answered: Problem 3: A cylinder contains an ideal…

Similar questions

A gas is taken through the cyclical process shown in the figure below. If each unit on the horizontal axis equals 1.50 m3 and each unit on the vertical axis equals 4.50 x 105 Pa determine the net work done by the gas.
A cylinder filled with ideal gas has a piston of mass M=5kg and area A=10 cm?. The cylinder has a valve located at the bottom. The valve was initially opened and some of the gas escapes slowly. The valve is then closed, after which the piston is observed to be at a lower position. Assume that the system is in thermal equilibrium with the surroundings and the piston is allowed to move freely during the whole process. 1. What was the initial absolute pressure of the ideal gas before the valve was opened? Is the final pressure of the gas in the cylinder greater than, less than, or equal to the initial pressure? Explain. Explain how your answer is consistent with the forces acting on the piston in the initial and final states.
A gas is enclosed in a container that has a piston with a cross-sectional area of 0.15 m2. The absolute pressure of the gas is maintained at 6,000 Pa when the piston is moved inward by 20 cm. Determine the magnitude of the work done by the gas. A) 180 J B) 450 J C) 90 J D) 200 J
week 5 #1 An ideal monatomic gas is taken through the cycle in the PV diagram. where V1 = 1.10, V2 = 2.20, P1 = 98.0 kPa and P2 = 230 kPa. How much work is done on this gas per cycle? ________J
Part A A cube 23 cm on each side contains 2.6 g of helium at 20 °C. 1200 J of heat energy are transferred to this gas. What is the final pressure if the process is at constant volume? Express your answer to two significant figures and include the appropriate units. Value Units P= Submit Request Answer Part B What is the final volume if the process is at constant pressure? Express your answer two significant figures and include the appropriate units. Value Units V = Submit Request Answer
A gas is confined in a thermally insulated cylinder as shown in the figure below. The gas is compresses as shown in figure (b). Which one of the following statement is true? a. The work done on the gas will be negative b. The work done on the gas will be Positive c The final pressure on the gas will be zero d. The work done on the gas will be Zero yot
A gas is taken through the cyclical process shown in the figure below. If each unit on the horizontal axis equals 2.75 m³ and each unit on the vertical axis equals 1.25 × 105 Pa determine the net work done by the gas. J J V
A pressure versus volume (pV) diagram for a system is shown in the figure. The arrows of the curve indicate the direction of the process, and the points of interest are labeled. The values for the points in the diagram are shown in the table. Volume (m³) Pressure (Pa) 2 Vo = 27.8 po = 1.37 × 10ª Vi = 20.8 Pi = 1.37 × 104 V2 = 17.4 P2 = 6.18 × 10³ V3 = 13.9 P3 = 6.18 × 10³ V4 = 13.9 P4 = 2.64 x 103 Vs = 8.87 p5 = 1.00 x 10³ Volume (m) Calculate the amount of work done on the system from 0–2 (Wm) and then for the entire curve from 0-5 (Wos). Pressure (Pa)
A frictionless gas-filled cylinder is fitted with a movable piston, as the drawing below shows. The block resting on the top of the piston determines the constant pressure that the gas has. The height h is 0.129 m when the temperature is 273 K and increases as the temperature increases. What is the value of h when the temperature reaches 339 K?
QUESTION 16 The temperature at state A is 20.0°C, that is 293 K. During the last test, you have found the temperature at state D is 73.0 K and n = 164 moles for this monatomic ideal gas. What is the change in thermal energy for process A to D, in MJ (MegaJoules)? Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement. p (atm) 5 4 3 2 1 0 A D 1 2 3 4 B 5 → V (m³)
An ideal gas at 1.53 atm. is heated from 334.01K to 553.51K and its volume expands to 4 times its original volume. What is the final pressure of the gas? Assume no moles of gas enter or leave the system
A 2100 cm³ container holds 0.10 mol of helium gas at 350°C. Part A How much work must be done to compress the gas to 1200 Cm² at constant pressure? Express your answer with the appropriate units. ▸ View Available Hint(s) W = 220 J ✓ Correct Part B Previous Answers How much work must be done to compress the gas to 1200 Cm³ at constant temperature? Express your answer with the appropriate units. ► View Available Hint(s) W = Submit μA Value Previous Answers Units ? X Incorrect; Try Again; 4 attempts remaining

SEE MORE QUESTIONS