Problem 2: Draw the influence line for the vertical reactions at supports B, E, and G and the shear and bending moment at point C of the beam shown below. E F 12 ft- 12 ft- с D Hinge -12 ft- 120- -12 ft- -12 ft

Q: Describe Fellenius Method.

A: In situations where the effective angle of shearing resistance over the failure surface is not…

Q: B1 (12 Wx20 D) 81 (12°Wx200) 2 (12Wx200) 3'-0" 25'-0" 82 (12°Wx20"D) $2 B FLOOR FRAMING PLAN NO…

A: a. floor cross sections will look like this layout:Explanation:  you can input details and materials…

Q: Find the slab thickness for the pand shown Column size - 300*300 -5.00- Jy 350 Mpa -009- 2-5

A: The column size = 300300The yield stress (fy) = 350 MPaTo determine:-The slab thickness

Q: Draw the sectional view of AA' and BB' Show Layers and Dimensions

A: Given FigureTo Draw the sectional view of AA' and BB'

Q: one help please can you help me to draw an isometric view of the bridge (truss)

A:

Q: What is the length of the vertical piece halfway between C and D in feet? B 12'-0" A 16'-0" D 16'-0"…

A:

Q: 6. Using the equation of the magnetic field due to a single ring of charge, derive the formula for…

A: Step 1: Step 2: Step 3:don't forget to upvote :) thank you and comment if doubt exists Step 4:

Q: Where

A: Required : To explain the number of cycle in 1 hour

Q: draw a structural base in a picture

A: Structural layout shows the structural components of a building like beams & colums. This layout…

Q: If a standard view in a drawing has hidden lines, then creating a sectional view is always…

A: Sectional view represents the internal configuration of any object. It shows the details of all…

Q: 4#8 12" 15" I 3: fó= tooopsu Grade Go Steel NWC. &Mn = ?

A:

Q: structural drawing   please indicate a details in this image

A: The structural diagram is shown in the above figure. We have to indicate a details in this image.

Q: A & C are incorrect, please re-work

A: As per question , I solve here only a and c. Find out - (a) Radius of curve  (c) Tangent length

Q: Draw the multiview projection of the given isometric figure. L HRP FRP L 1. Discuss how did you draw…

A:

Q: All are incorrect, can you re-work?

A: The degree of the curve = Da = 5°0' The intersection angle = 20°30' The station of the PI = 63+25.53…

Q: V5-4. For the 50-foot grid shown in Fig. 5-12, redraw, and sketch all one-foot contour lines. the…

A: Calculations of the distances of the points from the lower levels

Influence Lines

The graphs that show the variation of a function at a specific point on a beam or truss due to a unit load placed at any point along the structure are known as influence lines in engineering. Some common functions that are studied with influence lines are shear, moment, and deflection. In designing beams and trusses, it is important to use influence lines in structures where loads would move along their span such as bridges, crane rails, conveyor belts, floor girders, etc. The influence lines help to study where a load will create the maximum effect for any of the functions.