Problem 11 Your stove can supply a constant amount of heat to your pot of water at 100 J/ s. If you want to heat your 1 kg water from 20° C to boiling (100°), how long would it take you? (Find the energy required to boil the water, and then find how long it would take the stove to give the water that amount of energy.) Cwater = 4190 J/kg K.

Problem 11 Your stove can supply a constant amount of heat to your pot of water at 100 J/ s. If you want to heat your 1 kg water from 20° C to boiling (100°), how long would it take you? (Find the energy required to boil the water, and then find how long it would take the stove to give the water that amount of energy.) Cwater = 4190 J/kg K.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Q3/ a/ ITRNACE On= 80MW Wnet.out НЕ OL = 50 MW RIVER Determine thermal efficiency
3 of 4 A stainless-steel-bottomed kettle, its bottom 25 cm in diameter and 1.6 mm thick, sits on a burner. The kettle holds boiling water, and energy flows into the water from the kettle bottom at 800 W. Review I Constants I Periodic Tabl Part A What is the temperature of the bottom surface of the kettle? Thermal conductivity of stainless steel is 14 W/(m K). Express your answer using four significant figures. VO AEO ? T = 102.65 °C Submit Previous Answers Request Answer X Incorrect; Try Again; 5 attempts remaining Review your calculations and make sure you round to 4 significant figures in the last step. Ne Provide Feedback
To what temperature will 9400 J of heat raise 2.5 kg of water that is initially at 11.0 °C? The specific heat of water is 4186 J/kg · C°. Express your answer using three significant figures. ? T = C° Submit Request Answer
2. We have derived the following equation for the rate of heating of the atmosphere. Only the first term on the right was explained. After reviewing the basics of thermodynamics, you are in a position to explain the second term. Show the steps for deriving the last term in the equation. Speculate why it of interest to change from dependence in z to dependence on p? dT 1 dF 8 dF not net dt C,p dz C, dp
A small electric immersion heater is used to heat 59 g of water for a cup of instant coffee. The heater is labeled "140 watts" (it converts electrical energy to thermal energy at this rate). Calculate the time required to bring all this water from 18°C to 100°C, ignoring any heat losses. (The specific heat of water is 4186 J/kg.K.) Number i Units
23.0 g of copper pellets are removed from a 300 degree C oven and immediately dropped into 100 ml of water at 25 degree C in an insulated cup . what will the new water temperature be? express answer in degree C
An insulated beaker with negligible mass contains liquid water with a mass of 0.245 kg and a temperature of 66.4 °C. Part A How much ice at a temperature of -17.8 °C must be dropped into the water so that the final temperature of the system will be 34.0°C? Take the specific heat of liquid water to be 4190 J/kg K, the specific heat of ice to be 2100 J/kg-K, and the heat of fusion for water to be 3.34x105 J/kg. View Available Hint(s) mice = [ΨΕΙ ΑΣΦ 5 kg
The next few questions challenge you to figure out the acceleration due to gravity ( g ) on various hypothetical alien planets. On Planet #1, you drop a stone from rest, 63.8 m above the ground, and the stone hits the ground 3.88 s later. What is the value of g on Planet #1? 16.44 m/s^2 32.89 m/s^2 8.48 m/s^2 4.24 m/s^2
1
The sun generates 2kW /m² when used as a source for solar collectors. A collector with an area of 1m2 heat water. The flow rate is 4.0 liters per minute. What is the 8. temperature rise in the water? The specific heat of water is 4200- kg-°C 9. The mechanical equivalent of heat is a. Btu b. calorie С. Joule d. Specific heat
An insulated beaker with negligible mass contains liquid water with a mass of 0.305 kg and a temperature of 63.0 °C. Part A How much ice at a temperature of -10.9°C must be dropped into the water so that the final temperature of the system will be 29.0 "C? Take the specific heat of liquid water to be 4190 J/kg-K, the specific heat of ice to be 2100 J/kg-K, and the heat of fusion for water to be 3.34x10 J/kg. VAX mie ? kg