Problem 1: Steel rod AC (E=200GPA) having a cross sectional area of 250 mm?, jointly support the 10 kN load with spring DE having a flexibility of 0.0005mm/N and an unstretched length of 9m. Bar BCE is rigid. Assuming that there was no slack or stress in rod AC or spring DE before the load was applied; a. Determine the ratio of the deformation of rod AC to spring DE. b. Determine the force on rod AC in kN. 12m 9m c. Determine the force on spring DE (kN). 12m 4m

Q: a. Determine the torque T and the radius of the elastic-plastic boundary. b. Determine the residual…

A: The diameter f the solid shaft is D=100 mm. The elastic shear strength is τY=150 Mpa. The shear…

Q: Observe the figure that shows the assembly of the ACD arm, suspended by a bearing in C coupled to a…

A:

Q: MECHANICS OF DEFORMABLE BODIES 1. In the figure shown, the rigid bar with negligible mass was…

A:

Q: Two metal bars are fastened together at the bolted flange connection shown. There are 2 total bolts…

A:

Q: The steel member shown below has a diameter of 69 mm, modulus of elasticity of E=200 GPa, and is…

A: Draw FBD

Q: A damper square mat is supporting a dead load weight of 8 kN. Helical springs will be used to…

A: Find the diameter of wire Deformation = 98.7 mm Stress = 120.6 Mpa Force = 8 kN

Q: 2. The following handle is loaded at points B and C, as shown below. If the force P = A 0.8 m 40 mm…

A:

Q: = 69.0 psi. In a test on an aerosol can it was loaded to a gage pressure p While pressurized, the…

A:

Q: The part shown is loaded at point C with 290 N in the positive x direction and at point E with 200 N…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.