PROBLEM 1: Compute the moment of inertia about the given x and y axes. ANS: Ix = 48.7 × 106 mm², ly = 18.42 × 106 mm² 40 mm 40 mm 68 mm x 66 mm 66 mm

Q: Symbol

A: From the given figure the given welding symbol is arrow side fillet welding.

Q: Which symbol indicates that a change has been made to a CPT guideline, and/or note when compared…

A: When a change is made to a drawing or a manual in engineering, codes, and symbols are used to…

Q: safety in general shown in picture

A: Let us discuss Safety in general,  which are generally used at industries and big industries.

Q: What prevention measures would the student take to prevent fluid overload?

A: given; What prevention measures would the student take to prevent fluid overload?

Q: DRAW AN AUXILIARY VIEW THAT SHOWS THE TRUE SHAPE OF THE ANGLED CUT KEYWAY, ALONG WITH A TOP VIEW.

A: Given DataThe front and the top view of the object are provided in the question in third angle…

Q: 6. What material is used 7. What is the unspecified tolerance for angular dimensions? 8. What is the…

A: Given figure  CHART DOWEL SPLIT TYPE  TO FIND :  7 .What is the unspecified tolerance for angular…

Q: A low Reynolds number will result in a precipitate a. Bad sort b. Good sorting c. round c. Uncertain

A: A low Reynolds number will result in a precipitate  Good sorting.

Q: Technician A says that the engine oil drain plug typically needs to be replaced with a new one at…

A: At every maintenance trip of the automobile engine oil is changed by removing the oil drain plug.

Q: Write down the name of Primary Control Surface

A: The rudder is a fundamental control surface which is typically controlled by pedals rather than…

Q: What is the function of safety valve?

A:

Q: Given: BEW-5,600 lbs BEW C.G.-15.5 feet Pilot - 180lbs Tank 1 Fuel - 400 lbs Tank 2 Fuel 1,800 lbs…

A:

Q: I need these three parts answered pertaining to the print provided. If you can not answer all three…

A: The term, Orthogonal, describes the relationship of the axis of the ½” NPT pipe plug with the main…

Q: Which functions of the engine management system ensures compliance with Australian Design Rules

A: vehicle safety, anti-theft and emissions are the functions of the engine management system ensures…

Q: Need help drawing a 1/2-13 UNC 2A Hex head bolt

A: THIS HOW IT'S GONNA BE

Q: 7- Differentiate SFC and TFC?

A:

Q: One of the type of Tunnel washers is 777 b 17 Od Top transfer Forward tilt Side load Auto carte…

A: Tunnel washer: A tunnel washer, also known as a continuous batch washer, is a large industrial…

Q: Differentiate between Local and Universal Interchangeability?

A: The local and universal interchangeability is given.

Q: Technician A says that coolant hoses should be squeezed to check for hardening or softening.…

A: Solidly squeeze both the upper radiator and radiator hoses. They ought to feel firm, solid, and…