Prob. 4: Liquid ammonia at -20°C is flowing through a 20 m-long section of a 5-mm-diameter copper tube at a rate of 0.09 kg/s. Determine the pressure drop,. the head loss, and the pumping power required to overcome the frictional losses in the tube.

Q: Q.3. Air flows steadily adiabatically through a pipe with a constant cross-sectional area. Air is…

A:

Q: mmonia is absorbed at 1 bar from an ammonia-air stream by passing it up a vertical tube, down which…

A: Given data: Length of reactor tube = 1920 mm Diameter of reactor tube = 135 mm Partial pressure of…

Q: air h, h, water

A: Given Density of water ρw =1000 kg/m3 h1 = 60 cm h = 45 cm h2 = 180 cm Find-Difference of…

Q: Air enters a nozzle steadily at 2.21 kg/m and 30 m/s and leaves at 0.762 kg/m' and 180 m/s. If the…

A: Given   Density at inlet  of air(ρ 1) = 2.21 kg/m3 Velocity at inlet of nozzle (V1) = 30 m/s Inlet…

Q: 17. Calculate the pressure at point A in Fig. 2.50. The slope of the tube is 4 horizontal to 1…

A: Reservoir review is given.Calculate pressure at point A.

Q: A centrifugal exhauster is takin in dry air from a room where the temperature is 60 °F and the…

A: Simple figure for above question Z=1ft pressure change=1.2 in of water Find Temperature of air in…

Q: Air of density 1.25 kg/m3 enters a duct at a uniform velocity of 10 m/s across a 0.25 m? inlet at a…

A: Density of air, ρ = 1.25 kg/m3 Velocity of air is uniform at inlet, v1 = 10 m/s Inlet area, A1 =…

Q: a- the volume flow rate of air at the inlet b- the mass flow rate of air at inlet and at exit c- the…

A: HGGHH

Q: Steam flows in a Schedule 40, 6 (in) (Internal Diameter-6.065 in) pipe 1000 ft long, with roughness…

A: Given that  For schedule 40d1  =6 in =6 x 0.0254 = 0.1524 m L = 1000 ft =  10003.28084 =304.8 m m  =…

Q: A converging-diverging nozzle is used to accelerate water at the state of superheated steam. The…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: #2: Your boss tells you that water at 68 F is flowing in a cooling tower loop at a rate of 35 gpm,…

A: Disclaimer: Since you have asked multiple question, we will solve the first question for you. If you…

Q: A liquid is flowing from one large tank to another through a 1 in. diameter pipe. The level in tank…

A:

Q: Use Bernoulli’s equation .

A: (a) v = 20.88 m/s(b) v = 1.886 m/s(c) v = 2.5668 m/s(d) v = 1.197 m/sExplanation:

Q: 4.36. A steady-flow water power plant has the following inlet and outlet conditions: Pressure, psig…

A: Given data for steady flow water plant are as follows:   Inlet Outlet Pressure, psig 0 0…

Q: Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100 °C,…

A:

Q: Water is flowing through a horizontal 6 in. Schedule 40 mild steel pipe at 1 atm and 25°C. The…

A: Given:The roughness factor, The inside diameter, The length of the pipe, The inlet pressure, The…

Q: 4. (20 points) Water (25°C) flows at 4.5 gpm (gpm is gallons per minute) in the system shown below.…

A: a) flow rates will be same along the pipe assuming no change in density.   1 gpm =0.00006309 m3/s…

Q: Air at static temperature of 300 K and static pressure of 140 kPa flow with velocity 60 m/s. a.…

A: Static temperature of air, T1 = 300 K Static pressure of air, P1 = 140 kPa Velocity, v = 60 m/s

Q: Q.2. Air flows steadily adiabatically through a pipe with a cross-sectional area of 0.002 m?. At the…

A:

Q: parallel piping hor. plane. pipe consists of two pipelines, i.e. Pipe 1 and Pipe 2. Pipe 1 is 60 m…

A: As per Bernoulli's equation applied between points A and B,PAγ+VA22g+ZA=PBγ+VB22g+ZB+hL1Neglecting…

Q: Air at 85 °F flows isothermally through a 6 in diameter smooth pipe at a flow rate of 10 lbm/s.  If…

A: This question involves application of the Bernoulli's equation. Let us see the data given: End…

Q: A pitot-static tube measures the total pressure pr and the local pressure p in a uniform flow in a…

A: Given : a) Total pressure Local pressure Diameter of the pipe

Q: A steady-flow 100% efficient water power plant has the following inlet and outlet conditions:…

A:

Q: Example (4-2): A pump is 2.2 m above the water level in the sump and has a pressure of (-20) cm of…

A: Vacuum pressure at the suction side of the pump = -20 cm of the mercuryDiameter of the suction pipe…

Q: (4) Air at 1 MPa and 500°C enters a converging.nozzle, with a velocity of 140 m/s. Determine(a) The…

A:

Q: A jet of water flows from a 4-in diameter nozzle such that the velocity at point 1, the top of the…

A: Given Data; Steady Flow Diameter of Nozzle; D1 = 4 inches=0.1016 m Diameter of Pipe; D2= 6 inches=…

Q: A horizontal steam pipe (60 mm. OD) carries high pressure steam at 230℃ . Wind flows past this pipe…

A:

Q: velocity of the water flowing out through the nozzle?

A:

Q: Water leaves the 25 mm diameter nozzle of a fire hose at a velocity of 25 m/s. What will be the…

A: Givendiameter of nozzle when water leaves D = 25 mm…

Q: 2) Both ends of the nozzle with an inlet cross-sectional area of lx10-S ft² and an outlet cross-…

A: In fluid mechanics, Bernoulli's theorem is described as the total mechanical energy of the flowing…

Q: 0.4 m 0.4 m 0.5 m 1.0 m water s 0.90 oil, s=

A: Solution Given that different fluids with specific gravity One atmosphere (101.325 kPa) is also the…

Q: 1)Water is pumped from a storage tank through a tube of 3.0 cm inside diameter at the rate of 0.001…

A: