= points A, B, C, D, E, and G. D is for the roller only as the ment

Q: 80mm 60mm Vax's Gomm 40mm Find the location of the Controid. Show All work. 1

A:

Q: What are forces on pin C and D

A:

Q: 2 Constraint indicated the name and where it should be

A: Given: To find: Where the constraint should be

Q: A bolt needs to be tightened to a degree that is equal to a moment amounting to 60 N-mm. If a…

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: What is the maximum magnitude of the bending moment caused by force G? If none, enter zero. Do not…

A: It is required to determine the magnitude of the maximum bending moment by the force G.

Q: 3. if you had to lift a truck and had a pole, a rope and a fulcrum, you could do it! A kid could do…

A: for third kind of lever fulcrum lies at one end and object other...

Q: a,b,c please and thank you!

A: The objective of the question is to determine the maximum and minimum principal stresses and the…

Q: The diameter of the bolt is .500 inches. Force

A: given:diameter of the bolt d=0.500inforce F= 750pound

Q: Select the correct statement about the notation circled in green and marked as letter C. Assume all…

A:

Q: Determine the tensions in cables AB, AC, and AD.

A:

Q: Is 2.0cm3 of aluminum same as 2.0cm3 of lead

A: According to the given data, the volume of the aluminum object is 2.0 cm³  and the volume of the…

Q: If a force doubled, impulse will triple. True or false

A:

Q: What is the magnitude of the Right Reaction force in pounds?

A: GIVEN: F=1.5 kpis =1500 lbf TO FIND: The reaction on the right side. Rb

Q: 0.75 in. 1'in. -20° 1.5 in.1 in. 3 in. 5 lb D 5 lb

A: Given,

Q: 15 What is the weight of the weldment shown? (MS) Plate= .2835 lbs. per cubic inch. V 58" x 21 x 21"…

A:

Q: The handle of the hammer is subjected to the force of 35 Ib. The moment of this force about the…

A:

Q: Which is greater in measurement A. Radius B. Diameter C. Chord D. Both b and C

A: Given that,  For a circle , there is a diameter , chord and radius.

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.