point B. (b) between the two pipes, which has a greater pressure? HO B 125 mm 350 mm Hg 175 mm -i-

Step 1 given; What the dismantling and Assemble of diaphragm valveAlso what is function of part than constant it Step 2 solution; Dismantling joint-It is very useful for joining and removing of pipe section with designing of dismantling joint. because its is used for joint longitudinal adjustment in pipe section for joining of pipe. without longitudinal adjustment ,It is not possible to insert valve for joining of longitudinal pipe.  Diaphragm valve-diaphragm valve is flexible valve. which is used for controlling pressure when force is applied in valve then it will be automatically open or close on the basis of pressure adjustment. and it will control the flow rate of fluid. when less flow rate required then valve slightly closed on the basis of flow requirement. when more flow rate required then it will be open. function- it will change the speed and velocity of fluid.

A rigid DC switch is attached to the 20 mm radius solid aluminum AB shaft. The forces of P = 3kN in the + y axis direction and F = 4kN in the -z direction were applied to the DC element from the C end. Check the safety of the pipe according to the tresca and Von-mises criteria. Tallow = 80MPA, oalow = 160MPA 20mm A Im D C 100 mm B

In the Cylindrical Cam system, the part attached to the Cam profile is called Select one: O a. Follower O b. Shaft O C Guide O d. Pin

Q1. it's required to determine the diameter of pipe BC

0.7 mm F BL C 240 mm 300 mm D SITUATION 04 The cylinder CD of the assembly shown in Fig. ESS4-TE-004 is heated from 35°C to 160°C using electrical resistance. Also, the two end rods AB and EF are heated from 30°C to 65°C. At the lower temperature, the gap between C and the rigid bar is 0.7 mm. Rods AB and EF are made of steel, and each has a cross-sectional area of 160 mm^2. CD is made of aluminum and has a cross-sectional area of 350 mm^2. The elastic modulus for both the steel and aluminum are 200 GPa, and 70 GPa, respectively. The coefficient of thermal expansion for the steel and aluminum are 12.0E-06 / °C and 23.0E-06 / °C, respectively. * Determine the force (kN) in rod AB caused by the increase in temperature of the system. 9.

A0.375-in.-diameter steel [E = 30,000 ksi] bolt (1) is placed in a copper tube (2), as shown. The copper [E = 16,000 ksi] tube has an outside diameter of 1.000 in., a wall thickness of 0.12 in., and a length of L= 7.0 in. Rigid washers, each with a thickness of t= 0.125 in., cap the ends of the copper tube. The bolt has 24 threads per inch. This means that each time the nut is turned one complete revolution, the nut advances 1/24 in. The nut is hand-tightened on the bolt until the bolt, nut, washers, and tube are just snug, meaning that all slack has been removed from the assembly, but no stress has yet been induced. What stresses are produced in the bolt and in the tube if the nut is tightened an additional quarter turn past the snug-tight condition? Rigid washer Rigid washer Bolt () Tube (2) If the force induced in the bolt by advancing the nut is F1, and force induced in the tube by advancing the nut is F2, what is the relationship between F1 and F2?