'layerQuestion 13Aplate withwith aan area of 500 cm²is to be coatedof gold 0.01cm thick. How long wouldgo ld 0.01 cm thick. Howthis take to accomplish using an AUCN solutionat a current of 5.20 Amps, given that gold has adensity of 19.3 glem?

Given: Area of surface to be electroplated = 500 cm2 Thickness of plating = 0.01 cm So, volume of…

plate with with a layer this take to accomplish usina an AUCN solution at a current of 5.20 Amps, given that gold has a an area of 500 cm2 is to be coated of gold 0.01 cm thick. How long would density of 19.3 glem³?

plate with with a layer this take to accomplish usina an AUCN solution at a current of 5.20 Amps, given that gold has a an area of 500 cm2 is to be coated of gold 0.01 cm thick. How long would density of 19.3 glem³?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: How long does it take to deposit a coating of gold 1.00 μm thick on a disk-shaped medallion 4.00 cm…

A: According to the Faraday first law of electrolysis, the amount of substance deposited at any…

Q: How long would a constant current of 5.0 amperes be required to flow in order to plate out 5.0 g of…

Q: Determine the time required to deposit 5.25 g of silver on a surfacefrom a silver nitrate solution…

Q: 3 Briefly explain why, for a small anode-to cathode area ratic the corrosion rate will be higher…

A: Explain why, for a small anode to cathode area ratio ,the corrosion rate will be higher than for a…

Q: Definition of terms - Battery - Galvanic Cell - Electrolectic Cell Note only need the…

A: Given -Battery- Galvanic Cell- Electrolectic CellWe need to write the definition of above terms and…

Q: A current of 4.90 A is passed through a Cu(NO,), solution. How long, in hours, would this current…

A: The chemical deposition due to the flow of current through an electrolyte is directly proportional…

Q: The Nernst equation can... (Select all answer choices that produce a true statement.) ...be used to…

A: The Nernst equation is a fundamental equation in electrochemistry that describes the relationship…

Q: In an electrolytic cell where electrolysis is carried, anode has:(a) Positive change(b) Negative…

A: Electrolysis takes place in electrolytic cell. Electrolytic cell consists of two electrodes…

Q: Salt bridge A concentration cell similar to the one shown is composed of two Ag electrodes and…

A: Concentration cell with Ag electrodes .

Q: Calculate the potential of an electrode at normal conditions in contact with a solution that is…

A: Using Nernst equation we can calculate unknown electrode’s potential.

Q: help please answer in text form with proper workings and explanation for each and every part and…

A: Step 1:

Q: - many grams of lead metal will be deposited from a solution that contains Pb2+ ions if grams ubmit…

A: The questions based on Faraday's first law of electrolysis. it states that mass of an element…

Q: How many hours of will it take to deposit 664 g Al at a current of 32.6 amperes? Assume a solution…

A: time = 60.71 hours

Q: 2+ How many grams of manganese metal will be deposited from a solution that contains Mn-" ions if a…

A: Mn(s) ---> Mn2+ (aq) Atomic mass of Mn = 54.938044 g n = 2 electron Current = 0.689 A Time…

Q: 15. How many minutes would a current of 10.0 amps need to run through a solution containing Cut2 to…

Q: A current of 4.88 A is passed through a Cu(NO,), solution. How long, in hours, would this current…

A: Given that Current = 4.88 A = 4.88C/s Mass of Copper diposited = 5.10g Cu2+ + 2e- = Cu 1mol of…

Q: When the Hg concentration is 8.20 x 10 M, the observed cell potential at 298 K for an…

Q: A voltaic cell consists of a standard hydrogen electrode and a second half-cell in which a magnesium…

A: Electrochemical cell : It is a kind of arrangement which produce electrical energy from chemical…

Q: How many seconds are required to deposit 0.209 grams of cobalt metal from a solution that contains…

A: To calculate the time required to deposit 0.209 grams of cobalt metal from a solution containing…

Q: itior

A: Ampere is the unit of current and it is defined as the rate of flow of electric charge. In question,…

Q: Draw galvanic cells based on the net L for the follow equoions irg reochas. to -> fea)

A: The given cell reaction = Fe (s) + Sn2+(aq.) →Fe2+(aq.) + Sn (s)

Q: 2) How long, in minutes, will it take to plate out 25.0g of Au from a AuCl3 solution if the current…

Q: Consider a cell whose Nernst potential is 0.50 V. If the cell resistance is 7.50 ohms and a current…

A: Overpotential is the measure of excess potential required to derive a reaction from its…

Q: Salt bridge Ag .02M Cu(NO,), 3M AgNOS .02M CuNOs Je(ag) .02M CulNNO, AgNOgcag) 3M

Q: What mass of Al

Q: b) A cell in the copper purification process has a current of 24 000A passing through it. (i)…

A: Suppose I A amount of current follow through a solution for t sec then amount of charge given as Q =…

Q: Check Your Understanding Suppose that a machine part requires 400 mg of copper to pro- vide a…

A: Solution: Electroplating is a method of coating one metal onto the other with the help of an…

Q: A concentration cell is used to measure the molar solubility of CdCO,. A saturated solution of CdCO,…

Q: How would changing the reference electrode affect a Standard Reduction Potential? there would be no…

A: A reference electrode is an electrode which has a stable and well-known electrode potential the…

Q: Solve the following: 1. Suppose that you have a cell that has an iron (II) concentration of 0.015 M…

Q: Please ketch ond label a galvanic cell with the ians and Salt bridge Indicate ian flow frcm the Salt…

Q: In a copper plating experiment in which copper metal is deposited from a copper(II) ion solution the…

A: Given: Time = 3.3 hours Current = 17.8 A Atomic mass of copper = 63.5 g/mol

Q: A current of 5.47 A is passed through a Fe(NO,), solution for 1.70 h. How much iron is plated out of…

A: The question is based on the concept of electrolysis. it involves Faraday's first law which states…

Q: An electrode Is prepared fromm liquid mercury in contct willh a salurated solution o mercury(1)…

A: The standard reduction potentials of half- cell reactions are, The most positive standard reduction…

Q: Two identical pieces of the same unknown metal are placed into 1.0 M solutions of aquesus LINO: and…

Q: Use the References to access important values if needed for this question. What is the calculated…

Q: 1. Definition of terms - Battery - Galvanic Cell - Electrolectic Cell Description Prosectional…

A: Definition :- A device converts the chemical energy to the electrical energy through electrochemical…

Q: How many seconds are required to deposit 0.164 grams of magnesium metal from a solution that…

Q: An electrochemical cell with the given line notation was constructed. S.C.E. || cell solution |…

Q: When the PbT concentration is 1.05 M, the observed cell potential at 298 K for an electr following…

Q: Calculate the enuilibrium constant for the following reaction using the standard half-cell…

A: In order to calculate the equilibrium constant we first write down the given data: T=298K. E0 for…

Q: How many ground, at chas Chromium metal are plated out then constant Curvent at 8.00 A Passed though…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

ellus_engine.html?ClassID=1907336612# dent Orie... One type of iron nail is coated with another metal in order to reduce corrosion. A solution of the metal, M(NO3)2 has a current of 20.00 A applied for 15.0 minutes. How many moles of M are formed during the electrolysis? [?] mol M Round only at the end. Use appropriate significant figures. Enter
[Review Tupies] [References Use the References to access important values if needed for this question. A standard galvanic cell is constructed in which a Cu | Cu" half cell acts as the cathode. Which of the following statements are correct? Hint: Refer to a table of standard reduction potentials. (Choose all that apply.) As the cell runs, anions will migrate from the CuCu" compartment to the other compartment. 2+ Hg"Hg could be the other standard half cell. U Cu* is oxidized at the cathode. U cr*Cr* could be the other standard half cell. The anode reaction could be Cr* -> Cr* + e Submit Answer Retry Entire Group 9 more group attempts remaining
G Refer to a table of standard redi x now.com/ilrn/takeAssignment/takeCovalentActivity.do?locator=assignment take CHEMIS TRY [References] Use the References to access important values if needed for this question. When the Hg2+ concentration is 1.35 M, the observed cell potential at 298K for an electrochemical cell with the following reaction is 1.717V. What is the Zn2+ concentration? Hg²*(aq) + Zn(s)→ Hg(1) + Zn²*(aq) Answer: M Submit Answer Try Another Version 2 item attempts remaining
5) For this problem refer to the electrochemical cell below a) Which electrode is the cathode and which is the anode? b) Is this cell electrolytic or galvanic? Explain. c) If the concentration of dissolved zinc ions were increased, how would this change the measured voltage? Volumeter so so; Znisi - Zntag) - 2e Cagl + 2e -Cuis)
Answer my question please
How should the voltage change in the Daniell cell if both the zonc solution ad the copper solution are reduced to 0.10M? Explain your choice
If the Standard Potential cell for the following AgI /Ag and I/I Was -0.152vand o, suv respectively. write the total chemical reaction for the Cell ? 2) what is the Potential cell if the meterial is Standard ? 13) If the Potential cell increase with increasing Temperture of 1*104 V/KⓇ Percent Calculate AG, AS, AH at 25c
The maximum corrosion current density in a steel sheet coated with zinc and exposed to seawater is found to be 5 mA/m?. What thickness of the layer is necessary so that the coating may last for one year?
Given that standard reduction potentials at 298.15 K are E° Mg*2 /Mg = -2.37 V and E° Sn2*/Sn = -0.140; then if a Mg(s) foil is soak in 1.0 M SnCl2(ag), the Mg foil be will be oxidized and eventually dissolve.
For the answer choose between A. 0.464 V B. 0.523 V C. 0.818 V D. 0.111 V
A baby'sspoon with an area of 6.25 cm2 is plated with silver from AgN03 using a current of 2.00 A for two hours and 25 minutes. a)If the current efficiency is 82.0%,how many grams of silver are plated? b)What is the thickness of the silver plate formed (d = 10.5g/cm3) ?
How many grams of magnesium metal will be deposited from a solution that contains Mg" ions if a current of 0.900 A is applied for 42.0 minutes. grams