(a) A 2.25 kg salami is supported by a cord that runs to a spring scale, which is supported by another cord from the ceiling (see Figure(a)). What is the reading on the scale, which is marked in weight units? (b) In Figure (b) the salami is supported by a cord that runsaround a pulley and to a scale. The opposite end of the scale is attached by a cord to a wall. What is the reading on the scale? (c) InFigure (c) the wall has been replaced with a second 2.25 kg salami on the left, and the assembly is stationary. What is the reading on thescale now?Spring scaleSpringscale(b)Spring scale(a)(c)(a) Number22.05UnitsN(b) Number22.05Units(c) Number44.10Units

Consider the given data as below. Mass of salami, m=2.25 kg Acceleration due to gravity, g=9.8 ms2

Answered: (a) A 2.25 kg salami is supported by a…

Similar questions

A crate that has a mass of 65.1 kg is held in equilibrium by two ropes as shown in the figure. Find the tension (in Newtons) in rope 1 if a = 33.2 0.
In the figure, point A is pin support and point B has a sliding support. Find the reaction forces at points A and B. 20 N 4 N/m 53° 2 N/m В 6 m 2 m 3 m
Two identical springs, A and B, each with spring constant k = 30.7 N/m, support an object with a weight W = 15 N. Each spring makes an angle of θ = 34.8 degrees to vertical, as shown in the diagram. (a) Write an expression for the tension in spring A (which is equal to the tension in spring B) in terms of W and θ. (b) By how much is spring A stretched, in meters?
A typical jar that has been tightened to a reasonable degree requires 2.0 N ⋅ m to open. If you grab a 7.0-cm-diameter jar lid with one hand so that your thumb and fingers exert equal magnitude forces on opposite sides of the lid, as shown, what is the magnitude of each of the forces?
A setup similar to the one shown in the figure below is often used in hospitals to support and apply a horizontal traction force to an injured leg. (Let m = 5.25 kg and 8 = 75.0°.) (a) Determine the force of tension in the rope supporting the leg. N (b) What is the traction force exerted to the right on the leg? Additional Materials еВook
A skydiver weighing 65 kg jumps out of a helicopter hovering at a height of 3 kilometers. Assume a cross-sectional area of 0.5 square meters. After thirty seconds of free fall, the skydiver deploys the parachute and the cross-sectional area becomes 40 square meters. Reproduce the model for the skydiver in Excel or VenSim. In VenSim you may have to make At quite small in order not to throw an error. Because you reach terminal velocity relatively quickly your answer should not be particularly sensitive to the value of At you choose. What is the skydiver's terminal velocity without the parachute? meters/second What is the skydiver's terminal velocity with the parachute? meters/second
How much tension must a 28.0 m long wire be able to exert without breaking when it is used to hang an iron sculpture that weighs 2784 N? The wire must be attached to two anchors in the ceiling 16.1 m apart.
A horizontal force of 430 N is applied to a stationary wooden box in one direction, and a 700 N horizontal force is applied in the opposite direction. What additional force is needed for the box to remain stationary?
Two children push on opposite sides of a door during play. Both push horizontally and perpendicular to the surface of the door. One child pushes with a force of 17 N at a distance of 0.585 m from the hinges, and the second child pushes at a distance of 0.465 m. What is the magnitude of the force, in newtons, the second child must exert to keep the door from moving? Assume friction is negligible. F2=
A person whose mass is m = 58.0 kg steps on a mechanical bathroom scale placed on an inclined plane that makes the angle a = 33.3° with the horizontal. What is the reading on the scale? kg reading:
The figure below shows a bird feeder that weighs 100.1 N. The feeder is supported by a vertical wire, which is in turn tied to two wires, each of which is attached to a horizontal support. The left wire makes a 60° angle with the support, while the right wire makes a 30° angle. What is the tension in each wire (in N)