Part of a roller-coaster ride involves coasting down an incline and entering a loop 6.80 m in diameter. For safetyconsiderations, the roller coaster's speed at the top of the loop must be such that the force of the seat on a rider is equal inmagnitude to the rider's weight. From what height above the bottom of the loop must the roller coaster descend to satisfythis requirement?Need Help?Read It

mg(h - 2R) = (1/2)mv2andmv2/R - mg = mgsolve for h

Part of a roller-coaster ride involves coasting down an incline and entering a loop 6.8 considerations, the roller coaster's speed at the top of the loop must be such that th magnitude to the rider's weight. From what height above the bottom of the loop mus this requirement? m

Part of a roller-coaster ride involves coasting down an incline and entering a loop 6.8 considerations, the roller coaster's speed at the top of the loop must be such that th magnitude to the rider's weight. From what height above the bottom of the loop mus this requirement? m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Jeremiah the Bullfrog rode a roller coaster around a loop. Being a good friend, he tooksome measurements for you during his journey. The 1.5 kg amphibian noted that at thebottom of the loop, the speed of the roller coaster was 33 '/s. You know from the informa-tional poster next to the entrance that the loop has a radius of 22 m. How much force didthe seat exert on Jeremiah at the bottom of the loop? Show your Work
A 0.8-kg ball is attached to a 1.0-m rope and whirled in a vertical circle. 3. ( The rope will break when the tension exceeds 400 N. What is the maximum speed the ball can have at the bottom of the circle without breaking the rope?
Answer only number 2
question 22 please
Pulley 1 51° 72.5 35 kg kg Bench Hs = 0.66 = 0.325 -Three objects are connected by weightless flexible strings as shown in the figure. The pulley has no appreciable mass or friction, and the string connected to the block on the horizontal bench pulls on the block parallel to the bench surface. The coefficients of friction between the bench and the block on it are u = 0.66 and Hx =0.325. You observe that this system remains at rest. Answer the following questions. Show all work. Clearly indicate any fundamental principles used. a. Draw a force diagram for the 35 kg block. b. Draw a force diagram for the point connecting the three ropes. c. Calculate the mass of block A. d. Draw a force diagram for tlhe 72.5 kg block. e. Calculate the friction force between the 72.5 kg block and the bench.
A box starts sliding from rest at the top of an inclined plane. The initial height of the box is 5.0 m above ground. When it reaches the bottom, it slides over a rough horizontal surface. The kinetic coefficient of friction is 0.5. What is the distance through which the box slides on the horizontal surface? а. 5.0 m b. 10.0 m С. 15.0 m d. 20.0 m
A box is released from rest at the position shown. Determine its speed (m/s) after traveling 3.1s along the 29ᴼ inclined surface if the coefficient of kinetic friction between the box and the surface is 0.34. Round off only on the final answer expressed in 3 decimal places.
1.What is the magnitude of her vertical acceleration? 2.What is the magnitude of her horizontal acceleration?
Two cars are traveling around a vertical loop of radius 9.8 m. A.) Determine the minimum speed the green car must be going to not fall. Vgreen, min. = B.) Determine how fast the red car is going if the normal force on it is 3.5 times its weight. Vred=
2.The 10kg crate is being pushed 5m along a floor by an 80.0-N force, applied at a 20.0 degree angle up from the horizontal. The u k between the floor and the crate is 0.100. The crate is initially moving at a speed of 5 m/s. - F=80N 20° 10 kg HA-0.1 a.) Draw a free body diagram for all the forces acting on the crate. CLEARLY label which of the forces do zero work on the crate b) Determine the change in Kinetic energy c) Determine the new speed obtained by the crate
Answer The larger radius means that the change Im interval. Therefore, the acceleration is smaller and the required to less likely to break when the puck travels in a circle of larger radiu Example 6.3 What Is the Maximum Sp A 1 5004kg cat moving ona flat horizontal road negotiates a cu ve as shown in Figure 6.4a. If the radius of the curye IS 350 m aind ithe coefficient of static friction between the bres and da pavement is 0.523 find the maxîmum speed the car can have and still make the turn successfully. SOLUTION Conceptualize Imagine that the curved roadway is part of a the car is moving in a circular path.
In the figure below, a stuntman drives a car (without negative lift) over the top of a hill, the cross section of which can be approximated by a circle of radius R = 130 m. What is the greatest speed at which he can drive without the car leaving the road at the top of the hill? km/h Submit Answer