Part A The beam is supported by a pin at A and a short link BC. If P = 12 kN , determine the average shear stress developed in the pins at A, B, and C . All pins are in double shear as shown, and each has a diameter of 20 mm. (Figure 1)

Q: For the diagram shown, if the load P = 14 kips, determine: a. the normal force in the member Bar BD…

A: Given data: the applied loadP=14 kipsthe diameter of the pin Bd=0.5 intotal length of the beamL=10…

Q: 2. A linkage to an aircraft landing gear is shown. • The 40-kN force acting on the wheel has a line…

A:

Q: TOP The assembly shown has pin support at E and roller support at V. A steel rod is connected at M…

A:

Q: Rigid bar ABC is supported by a pin at bracket A and by tie rod (1). Tie rod (1) has a diameter of…

A:

Q: Solve Problem for the maximum shear stress within regions AC and BC, and the angle of twist f of end…

A: Considering Section AC, Maximum Shear Stress: Considering Section BC, Maximum Shear Stress:

Q: The double-web girder is construction from two plywood sheets that are secured to wood members at…

A:

Q: Strength of materials Qz The steel shaft has a diameter of 50 mm and is fixed at end A and turn free…

A:

Q: a) The normal stress in bar BD is most nearly b) The shear stress in the pin at D is most nearly…

A:

Q: A simply supported beam supports the loads shown in the figure. The cross-sectional dimensions of…

A:

Q: 250 mm D 750 mm 120 N•m The two shafts are made of A-36 steel. Each has a diameter of 25 mm, and…

A:

Q: The beam is supported by double-shear pins at A, B, and C. The radius of all the pins are r = 8 mm.…

A: Find outDetermine the magnitude of the normal force in rod BC, .Determine the magnitude of the…

Q: Compute the outer and inner diameter of the hollow circular rod when it is subjected to an axial…

A: Given data as per question Axial pull = 350 KN Allowable stress = 125 N/mm2 Thickness of rod = 10 mm…

Q: 1. (50 pts) A beam is fixed on one end and free on the other. It has an open circular cross-section…

A: The objective of the question is to determine the stress state at points A, B, C, D and the maximum…

Q: 30 -1.5m A D 80KN 5m 80KN 1.5m 40μN

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.