palance sheet and estimate the thermal and mechanical

Q: How is the nominal or engineering strain found directly from the strain gage?

A: Engineering strain is defined as ratio of total amount of stretch that a part undergoes or the…

Q: What is notch sensitivity?

A: Notch sensitivity:- When a material undergoes cyclic or fluctuating lading then in that case notches…

Q: A) An engineer works for a company that has many gray cast iron rods of different diameters and…

A: Given :Load P = 10 kip Material : grey cast iron

Q: a) Briefly explain the advantages of hammer test over shaker test in modal testing.

A:

Q: In what situations would you use a hardess test instead of a Tensile test?

A: The objective of the question is to understand the scenarios where a hardness test would be more…

Q: Name the mechanical or optical device or the measurement and calculating the strain?

A: Strain refers to the deformation produced in the body per unit length or dimension in response to…

Q: Explain the purpose of the v-notch on the specimen for Charpy Test.

A: Charpy test: The Charpy test is also known as Charpy V-notch test for toughness of material. Charpy…

Q: why do we physically mark gauge length on the samples before the test even though the machine is…

A: Solution: Given Data: Tensile Testing Machine   To Find: (a) Why do we physically mark gauge length…

Q: What does a tensile test show?

A: Tensile test is destructive test in which multiple mechanical properties are measured. It is called…

Q: What term describes a numerical value that can be applied to a dimensional constraint in a technical…

A: Variation process arranging approach is some of the time called an information recovery strategy.…

Q: What is the relation between product tolerance and product variation?

A: Process variation is the watched difference from part-to-part which is caused by the restrictions…

Q: What are the different types of hardness test? Write a detailed note on each type.

A: Hardness is the ability of the material to resist scratch or indentation. Hardness is also defined…

Q: Explain the following with appropriate examples (at least 2 examples) 1. Grubler's criterion. 2.…

A: The Grubler's criterion gives the number of degrees of freedom of a mechanism involving links and…

Numerical Calculations

In the mid-20th century, the availability and the growth in power of digital computers led to the increase in the mathematical model in the field of engineering and science. The analysis of these detailed models needs to be increased.