P2.33Find the transfer function for Y(s)/ R(s) for the idle-speed control system for a fuel-injected engine as shown in Figure P2.33 O.

Q: 2. A 50-kW, 440-V, 50-Hz, six-pole induction motor has a slip of 6 percent when operating at…

A: Dear,as per company guidelines we can answer only 3 sub-parts at a time, kindly post other sub-parts…

Q: A servo motor has the following parameters: the rated power is 1.29KW at the nominal speed 3000 rpm.…

A: For a servomotor driving a linear load with gears, the following information is given:Rated motor…

Q: separately-excited d.c. motor is supplied via a half-control full-wave single-phase rectifier…

A: Given data:   Ra=6Ω     T=1.8 NmVrms=240 V Since the thyristors are fired at 110°, obtain the…

Q: Discuss the advantages of flux weakening operating regime in a DC motor.

A:

Q: A de machine is controlled by the step-down de-de converter shown below. The armature inductance La…

A: The question is about buck converter circuit.

Q: b) The speed of a separately excited motor is controlled by a single-phase semiconverter in Figure…

A: Given: The speed of a separately excited motor is controlled by a single-phase semi converter in the…

Q: A three-phase induction motor operating from a power supply of constant frequency can be used to…

A: Three phase induction motor is convert electromechanical energy and rotor current induced a magnetic…

Q: Two dc shunt generator in parallel supply together 2000A. The machines have armature resistances of…

A: According to the question we have to find the value of output of each machine.

Q: A four-pole, three-phase 415 V, 50 Hz induction motor has a rated rotor speed at 1445 rpm. The motor…

A:

Q: A PWM signal is sent to a permanent magnet DC motor through an H-bridge circuit. The PWM frequency…

A: Given f=100 kHz V=16 V No load speed = 1500 rpm T= 2Nm   duty cycle = 20 % =0.2                    =…

Q: A separately, excited Dc motor fed from 3-phase semi-controlled rectifier develops a full load…

A: Torque, T=kaϕIa T=0.25×50=12.5 N-m…

Q: A 200V, 875rpm, 160 A separately excited dc motor has an armature resistance of 0.07Ω. It is fed…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A three phase induction motor designed for a rated voltage of V1 at 50 Hz is accidentally switched…

A:

Q: A 5HP 230V 1500 rpm shunt motor has an armature resistance including brushes of 0.175 ohm, the shunt…

A:

Q: I want to represent each point on the graph paper with its corresponding scale written alongside it.

A: Since you have posted the multiple questions. So we are supposed to answer 3 parts only. In the…

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.