P14C.2 The surface tensions of a series of aqueous solutions of a surfactant A were measured at 20°C, with the following results: [A]/(mol dm³) 0.10 0.20 0.30 0.40 0.50 W(mN m') 72.8 70.2 67.7 65.1 62.8 59.8 Calculate the surface excess concentration.

P14C.2 The surface tensions of a series of aqueous solutions of a surfactant A were measured at 20°C, with the following results: [A]/(mol dm³) 0.10 0.20 0.30 0.40 0.50 W(mN m') 72.8 70.2 67.7 65.1 62.8 59.8 Calculate the surface excess concentration.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: 1. Bulk Ti-Al alloy was subjected to 1100 K oxidation for 5 hr, which led to the growth of 3.5…

A: XRD (X-ray Diffraction):X-ray Diffraction is a technique used to analyze the crystal structure of…

Q: Calculate the molar conductivity at infinite dilution (Ao) of HAc, knowing that Ao for NaCl, HCl and…

A: Thank you.

Q: Consider the following data on the molar conductivity (Am) of NaOH as a function of concentration at…

Q: The Conductivity of 0.20 M solution of KCI at 298 K is 0.0248 Scm³. Calculate its molar conductivity

Q: Three large proteins are ionized at the pH at which an electrical FFF separation is carried out.…

A: Field-flow fractionation, (FFF) is a type of separation technique in which field is applied to a…

Q: The temperature-dependent form of the extended Debye-Hückel equation is (-1.825 x 10°) (€T) z² va…

A: Activity coefficient = 0.59

Q: Calculate the thermal expansion coefficient, α = (∂V/∂T)p/V, of diamond given that the (111)…

Q: y =

A: The objective of the question is to determine the activity coefficient of given ions using the…

Q: P5B2 In a study of the properties of an aqueous solution of Th(NO3) by A. Apelblat, D. Azoulay, and…

Q: limiting conductance

Q: Consider a dilute solution of No molecules of solute B dissolved into Na molecules of solvent A (NB…

A: The objective of this question is to analyse the equilibrium conditions, deriving a pressure…

Q: Calculate the mean square displacement, (x²), of the H-Cl bond distance from its equilibrium…

A: where:v is the vibrational frequency (cm⁻¹)K is the force constant (N/m)μ is the reduced mass of the…

Q: (c) The data set below represents the surface tension data for aqueous solutions of 3-…

A: The main aim of this question is to explain the surface excess of 3-methylbutanoic acid and…

Q: The limiting molar conductivities of KCl, KNO3 and AgNO3 are 14.99, 14.50 and 13.34 mS- m2/mol,…

Q: The hole concentration?

A: Calculate the donor and acceptor concentrations in the semiconductor. The concentration of the…

Question

P14C.2 The surface tensions of a series of aqueous solutions of a surfactant A
were measured at 20°C, with the following results:
[A]/(mol dm³)
0.10
0.20
0.30
0.40
0.50
W(mN m')
72.8
70.2
67.7
65.1
62.8
59.8
Calculate the surface excess concentration.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 10 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

The velocity v with which a protein moves through water under the influence of an electric field varied with values of pH in the range 3.0<pH<7.0 according to the expression v/( ųms-1)=a+b(pH)+c(pH)^2+ d(pH)^3 with a=0.50, b=-0.10, c=-3.0*10^-3, and d=5.0*10^-4. Identify the isoelectric point of the protein.
Penicillin F is recovered from a dilute aqueous fermentation broth by extraction with amyl acetate, using 6.5 volumes of solvent per 100. volumes of the aqueous phase. At pH = 3.8 the distribution coefficient KD is 74. (a) What fraction of the penicillin would be recovered in a single ideal stage? (b) What would be the recovery with three-stage extraction using fresh solvent in both stages? (c) How many ideal stages would be needed to give the same recovery as in part (b) if a counterflow cascade were used with V/L = 0.065?
The Gibbs free energy of a mixture of solid A and B (a phase) is given as 10,000X4XB + RT (XĄ In XA + Xg ln XB)- AGmix A· А А (a) When AH is positive, phase separation can occur. The composition range where phase separation occurs is defined by the common tangent rule. Derive an expression for the relationship between Tand X8 that defines the composition and temperature range where phase separation occurs. Hint: assume the AHmix versus composition curve is symmetrical in this case. (b) Plot the phase diagram T (y-axis) versus XB (x-axis) over the temperature range from 300 K
How to c alculate the Debye length of the double electric layer near the charged surface in KCl solutions of two concentrations c1 =0.01 M and c2= 0.1 M.Assume T= 300K,  = 80, k = 1.38 ·10-23 J/K, o = 8.85 · 10-12 CV-1m-1
The molar conductivity of NH4Cl at infinite dilution is 149. 7 02-1 cm² mol-¹ and the ionic conductivities of OH and Clare 198.0 and 76.3 -1 cm² mol-1, respectively. What is the molar conductivity of NH4OH (in 2-1 cm² mol-¹) at infinite dilution? Express your answer in four significant figures
Obtain the linear attenuation coefficient of PVC (C2H3Cl)3 with a density of 1.4 g/cm^3.
With the aid of sketches, explain the solidification of Fe-Al alloy from liquid to final microstructure present at room temperature. Determine the phase present, their individual composition, and the phase fraction at 250°C.
(2) The solubility of methane in water at 20 °C and 1.00 x 105 Pa pressure is 0.025 g dm-³. What is its solubility in water at 1.25 x 105 Pa and 20 °C?
Consider the arrangement: fly F (b) 0=45° r (nm) 0.5 1.0 1.5 4.0 +0₂ (a) = 2.0 nm 0 (degree) 0 45 90 180 +Q₁ Calculate the molecular potential energy of interaction between two HCI molecules (μ = 1.08 D) at the given separations (r) and angles (0). Comment on your results. V (J/mol) 8 -Q₂ V (J/mol)
Tooth enamel consists mainly of the mineral calcium hydroxyapatite, Can(PO)(OH). Trace elements in teeth of archeological specimens provide anthropologists with clues about diet and disease of ancient people. Students at Hamline University measured the trace element strontium in cnamel from extract wisdom teeth by atomic absorption spectroscopy. Solutions were prepared with a constant total volume of 10.0mL. containing 0.750mg dissolved tooth enamel plus variable concentration of added Sr. \table[[Added Sr (ng/mL- ppb), Signal (arbitrary units)], [0, 28.0], [2.50, 34.3], [5.00, 42.8], [7.50, 51.5], [10.00, 58.6]] a) Prepare a graph to find the concentration of Sr in the 10mL sample solution in part per billion = n m L. (2%) b) Find the concentration of Sr in tooth enamel in part per million = μ (3%) 5. Tooth enamel consists mainly of the mineral calcium hydroxyapatite, Ca(PO)(OH). Trace elements in teeth of archeological specimens provide anthropologists with clues about diet and…