P.5 For the two given AM demodulator circuits, a) Specify the type of demodulator. b) Sketch the signals: (i) At the output of the low-pass filter and (ii) At the terminal output of left circuit, and (iii) At the output of the right circuit. (a + m(i)] cos w! Low-pass filter m(1) AM ignal Rectifier Detector

Q: Given the differential amplifier circuit below. Determine the following: emitter current,…

A:

Q: In the capacitor input full-wave rectifier filter, as the time constant of the input filter is…

A: here the time constant of the full-wave rectifier is RC

Q: State the advantages and disadvantages of the block diagram reductio technique.

A: Block diagram reduction techniques are used to find transfer function in control system. Transfer…

Q: A chopper has input voltage of 290 and the load resistance as 50, the average load current as 50A.…

A: Chopper: The circuit which transfer the dc power from one circuit to another circuit at the required…

Q: Q-3) A SCR circuit with half-wave controlled rectifier triggered at 48° in a 240 V AC circuit. Find…

A: In this question, we need to determine the average load voltage across the load. If trigger angle =…

Q: P3 Design a relaxation oscillator circuit giving a triangular signal. The oscillation frequency is…

A: Relaxation oscillator in electronics is a type of non linear oscillator circuit which develops the…

Q: What is the differential gain of the differnce stage of the instrumentation apmplifier?   What is…

A:

Q: Clipper circuit: Vi (p-p)= 10 volt (Sinewave) F=1 kHz R= 10 Kohm V= 4 volt Find and Sketch the…

A:

Q: The input of a certain regulator increases by 2.5 V. As a result, the output voltage increases by…

A:

Q: 11) the supply frequency; 12) the rectifier pulse number;

A:

Q: a) A 1V 5 kHz signal is put into a low pass filter with a cut-off frequency of 2 kHz. What will the…

A: In this question We need to determine the output signal of the filter.  We know,  LPF passes only…

Q: (2) Consider a frequency modulated signal. The modulating signal frequency is increased from 10 kHz…

A: In this question we have to find the correct optionsrgarding modulated signal bandwidth

Q: b) The waveforms shown in figure (1) are the trigger and the output waveforms of a monostable…

A:

Q: Describe its frequency spectrum. What will be the output if the sampled signals are analog signal…

A:

Q: c. The filter is a device that allows passing the dc component of the load and blocks the ac…

A: A filter circuit is an electronic device which blocks the ac component present in the rectified…

Q: sinusoidal signal of frequency 2 KHz is sampled at rate of 5 KHz. What is the digital frequency of…

A: The output frequency of a sampled signal is  fo = f + fs

Q: A signal generator having a source resistance of 50 2 is set to generate a 1 kHz sinewave. Open…

A: Given, R= 50 Ωf=1000 HzV=10 V (peak-to-peak)VC= 8 V (peak-to-peak) It is asked to find the value of…

Q: Find the resonance point and the half-width of the speed versus frequency curve for the damped…

A: When b / m << 2ω0 (half width of speed), we say that the oscillator is lightly damped. For a…

Q: the given comparator and input signal V, draw the output waveform w.r.t the sinewave input signal…

A:

Q: Nyquist criterion margins

A: To explain: Nyquist criterion margins.

Q: Q/The buck-boost regulator gust has an input Voltage of Vs = 12V. The duty cycle = 0.25 and the…

A:

Q: (B) For the mechanical system in figure (4). Drive the transfer function Y(s)/F(s) KI M K2 Figure…

A: we need to find out transfer function for the given mechanical system.

Q: Identify the given statement. FM and PM demodulators can actually reduce noise and increase the…

A: FM and  is the frequency modulation and PM is the phase modulation  In FM amplitude and phase remain…

Q: Discussion and elaboration on the importance of active filter in electronic system and relate it to…

A: We need to write the importance of active filter in electronic systems and also need to write how it…

Q: The filter is a device that allows passing the dc component of the load and blocks the ac component…

A: Rectifiers- Rectifiers are the one which are used to convert AC voltage into DC voltage. But the…

Q: A. Design a square wave Oscillator for frequency 2 kHz and sketch the corresponding Circuits and the…

A: Answer: (i) Design of square wave oscillator using op amp : Given that  f= 2 kHz In this case the…

Q: Q4) If fr is the frequency of the fundamental component of the output ripple, then for full bridge…

A: In full wave bridge rectifier the time period of output signal is half of the time period of input…

Q: Discussion add elaboration on the importance of active filter in electronic system

A: Introduction: Active filters are utilized in communication systems for suppressing noise, to isolate…

Q: Explain how the Active Low Pass Filter works in detail, as shown in a drawing

A:

Q: - Signal conditioning element - This takes the output of the sensing element and converts it into a…

A: A signal conditioning circuit is that circuit which is used to convert one form of signal to other…

Q: 6. Refer to the RC Phase-shift Oscillator below. A Vin R₁ Rf 6.a. Derive the feedback factor formula…

A: RC phase shift oscillator is shown below. Find Derive the feedback formula of the circuit. Draw…

Q: Draw a one-phase bridge type Full Wave Uncontrolled AC/DC converter circuit, explain the working…

A:

Q: 1. What is the condition for over modulation and what are its effects?

A:

Q: A chopper has input voltage of 290 and the load resistance as 52, the average load current as 50A.…

A: The circuit transfers the dc power from one circuit to another the circuit at the required output…

Q: 3. Discuss the main reason for the probable error occurred during experiment

A: Bartleby has policy to solve only first question.  Reupload Rest questions.

Q: if you design differentiator to differentiate input signal varies in frequency between 1 KHz and 20…

A: A cut off frequency magnitude response is 3 dB lower 0 Hz. Formula cutoff frequency :  fc = 1(2π RC…

Q: Draw block diagram of envelop demodulator. Explain the use of diode in demodulator

A: Transmitter transmit the signal. It convert the communicated signal into compatible with…

Q: Question-4: Design a positive biased limiter circuit (use silicon or germanium diode) that limit the…

A:

Q: Why do we need three RC network for phase shift oscillator? Can it be two or four ? and why

A: In this question we will write phase shift oscillator...

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.