Problem # 1The infiltration capacities of an area for different intervals of time aregiven below:time (hr)00.250.51.0 1.25 1.500.751.752.0I (cm/hr) 10.05.53.12.21.551.251.21.01.0Find the equation for infiltration capacity (Horton's equation).,..

Answered: Image /qna-images/answer/d096695d-d9f9-4f34-afd7-f2c3e9cf5ee5.jpg

P TOblem # The infiltration capacities of an area for different intervals of time are given below : time (hr)0 0.25 0.5 0.75 1.25 1.50 1.0 1.75 2.0 I (cm/hr) 10.0 5.5 3.1 2.2 1.55 1.25 1.2 1.0 1.0 Find the equation for infiltration capacity (Horton's equation),

P TOblem # The infiltration capacities of an area for different intervals of time are given below : time (hr)0 0.25 0.5 0.75 1.25 1.50 1.0 1.75 2.0 I (cm/hr) 10.0 5.5 3.1 2.2 1.55 1.25 1.2 1.0 1.0 Find the equation for infiltration capacity (Horton's equation),

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The hydraulic residence time of the conservative PFR shown below is 72 minutes. At time te0, the…

Q: Problem 1 Calculate the specific discharge velocity, v, in the permeable layer given H = 3 m, H₁ =…

Q: (b) Given data : K =0.3 hr¹, K₂ =0.3 hr¹; fo =0.75 in/hr, fc = 0.25 in/hr. 0.1 0.2 2 1.0 3 0.8 t(hr)…

A: Given: fc=infiltration capacity at any time t,=0.25 in/hr fo=initial infiltration capacity=0.75…

Q: Monthly average surface area of Akkaya reservoir and average evaporation values read in a nearby…

A: evaporation in one monthEm=Area×E×daysfor one month =30days lets make a table month E(mm/day)…

Q: In a furrow irrigation system, the following information is giv . • Length of a furrow = 200 m

A: Given:- length of furrow=200m Inflow=1.5l/s To find:- Irrigation time

Q: Using Dupuit formula find the drain spacing for the following data 1- Coefficient of permeability =…

A: The given data is shown below: Coefficient of permeability=0.3 m/dayRecharge required =0.84…

Q: In a furrow irrigation system, the following information is given • Length of a furrow = 200 m . •…

A: l = 200m Q = 1.5l/s w = 80cm d = 100mm It has been asked in the question to determine the irrigation…

Q: Q: In fig. below, calculate: 1- The total head at point b and point c, 2- Rate of flow per unit…

Q: Q #2 Design A rapid sand filter to serve a little city with an annual water consumption rate of…

Q: Q2/ Sprinkler irrigation system irrigate 8 ha farm in 2 hours with average sprinkler irrigation rate…

A: To solve the given problem, we need to follow these steps:Determine the time when water starts to…

Q: The infiltration capacity in basin is represented by Horton's equation as fp=5.0 + e-St where fp is…

Q: Home work2: from test data of infiltration experiment, D-2.5 cm@t-15 minute and D=8 cm @t= 100…

A: Given D=2.5cm at t=15min D=8cm at t=100min

Q: 2.31. Determine a Horton equation to fit the following times and infiltration capacities. Time f…

A: Find infiltration rate at 10 mins, 180 mins and 360 mins

Q: The initial infiltration capacity (fo) of a watershed is estimated as 1.3 in./hr, and the time…

A: Initial infiltration curve, fo = 1.3 in/hr Final infiltration curve, ff = 0.2 in/hr Time constant, k…

Q: A recharge basin was evaluated for groundwater recharge and following parameters were determined…

A: Question is based on the rectangular basin for ground water recharge . Volume of inflow and…

Q: 2. During a 10 hour rainfall, precipitations in Table are observed. Table: Precipitations (mm) hour…

Q: Solve the infiltration loss bounded at t1 = 15 min to t2 = 25 min for exponential function and t1 =…

Q: A circular sewer flowing full to carry a sewage discharge of 0.864 m3/s at a slope of 10 in 20000.…

Q: 2- The daily mean evaporation from a pan located near a lake is measured as 10 mm/day during August.…

A: E = 10 mm/day A = 5.5 km2 or 5.5 x 106 m2 Qin = 1 m3/s Qout = 500 lit/s or 0.5 m3/s

Q: in an irrigation run, the infiltration rate (I) is constant and is equal to 20 mm/hr. The…

A: The given data is shown below: I=20 mm/hrOpportunity time=60 minutes

Q: The DO of a river is 5.9 mg/L just downstream from a wastewater outfall. The mix of river and…

Q: Find daily evaporation by using Meyer's formula if following details are given : Reservoir area = 3…

A: Reservoir area = 3 km2Wind temp. = 25°es at 25°C = 23.75 mm of mercuryRelative Humidity = 45% K =…

Q: A catchment area near Kirkuk has the following mean monthly temperatures are given in the table…

A: The monthly Thorthwaite Heat Index (i) is given by: i=(t5)1.514 Where, t = Mean monthly temperature…

Q: A 20 cm diameter sewer with invert slope of 1 in 500 is running full. Calculate the rate of flow in…

A: The rate of flow or discharge through a sewer is equal to the volume of sewage discharged per unit…

Q: Given: Rate of infiltration, in/hr 3.1 Final capacity, in/hr 0.3 Horton k, hr 0.4 Solve for the…

Q: - For the storm hyetograph shown below, determine the infiltration capacity al model and assuming…

A: Initial infilteration capacity, fo = 0.8 cm/hrEquilibrium capacity, fc = 0.3 cm/hrHorton's Decay…

Q: The infiltration capacity in basin is represented by Horton's equation as fp=5.0 + e-St where fp is…

Q: 2. The following data are the daily amounts of rainfall and water added to a pan (both in inches).…

A: Given values- To Find- Daily Evaporation rates.

Q: A ring infiltrometer test were made on sandy loam soil the results of the test are given in the data…

Q: Calculate the evaporation (mm) from a pond, if the pan evaporation is 45 mm, the pan coefficient is…

A: Pan evaporation = 45 mmPan coefficient = 0.70 To Find :The Evaporation from a pond ?

Q: In the branched pipe system shown, 850 L/min of water at 10°C is flowing in a DN 100 Schedule 40…

A: Data given Q = 850 L/min = 0.0141 m3/s Total length of pipe in the lower branch, L2 = 60 m L1 = 30…

Q: The inital rate of infiltration of a watershed is estimated as 2.1 in/hr, the final capacity is 0.2…

A: Initial infiltration rate (fo) = 2.1 in./hr Final infiltration rate (fc) = 0.2 in./hr Time constant…

Q: The average weather conditions are; Net radiation Air Temperature Relative Humidity Wind speed…

A: Given data: The average weather conditions are given:

Q: |Q4]// |A]: For a small drainage area, the infiltration rate at the start of rainfall storm was…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Measured infiltration rates, f in cm/hr, for every hour from t=0, when the rainfall just commenced…

A: Given: Rainfall commenced to t = 8 hours are given in table. Initial constant rate, fo=2.2…

Q: Find the infiltration rate if the initial rate = 1.3 in/hr. and the final rate = 0.2 in/hr, k= 0.35…

A: Given: The initial rate is 1.3 in/hr. The final rate is 0.2 in/hr. The constant k is 0.35 per hour.

Q: In a furrow irrigation system, the following information is given • Length of a furrow = 200 m .…

A: Given,Length of furrow, l=200mInflow, Q=1.5 l/sFurrow spacing, w=80cmAverage infiltration depth,…

Q: Measured infiltration rates, f in cm/hr, for every hour from t=0, when the rainfall just commenced…

A: Table for infiltration rate: Rainfall commenced to t = 8 hours are given in table. Initial constant…

Q: What is the infiltration capacity at 3 hours of a soil

Q: The moisture condition of a catchment soil previous a storm is known. Its infiltration capacity fp…

A: HORTON EQUATION:fP=0.5+1.2e-0.5tAT TIME =0 hrfP=0.5+1.2e-0.5×0=1.7 cm/hrAT TIME INFINITYfp=0.5 cm/hr

Question

Problem # 1
The infiltration capacities of an area for different intervals of time are
given below:
time (hr)0
0.25
0.5
1.0 1.25 1.50
0.75
1.75
2.0
I (cm/hr) 10.0
5.5
3.1
2.2
1.55
1.25
1.2
1.0
1.0
Find the equation for infiltration capacity (Horton's equation).,..

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The initial infiltration capacity fo of a watershed is estimated as 1.5 in./hr,and the time constant is taken to be 0.35 hr -1. The equilibrium capacity fe is 0.2 in./hr. Use Horton's equation to find (a) the values of fat t= 10 min, 30 min, 1 hr, 2 hr, and 6 hr, and (b) the total volume of infiltration over the 6-hr period
compute evaporation rate in milliliters per day using "energy method"
35
IQ4// [A]: For a small drainage area, the infiltration rate at the start of rainfall storm was record to be 90 mm/hr and declined exponentially to a constant rate of 8 mm/hr after 2.5 hr. The total infiltration during 2.5 hr was 50 mm. Develop the Horton's equation for the infiltration rate at any time t<2.5 hr. [B]: Find the required discharge of irrigation water at the headwork of the distiriburatry, if the gross area is 20000 mishara, the irrigation intensity is 65%, and the water duty is 1600 hectare/m/sec.
A pump can lift water at a discharge of 0.15 m³/s to a head of 25 m. The critical cavitation number (o) for the pump is found to be 0.144. The pump is to be installed at a location where the barometric pressure is 9.8 m of water and the vapour pressure of water is 0.30 m of water. The intake pipe friction loss is 0.40 m. Using the minimum value of NPSH (Net Positive Suction Head), the maximum allowable elevation above the sump water surface at which the pump can be located is
The water need of a district with a future population of 38800 and average daily water consumption qort = 189 lt / N / day will be met by leakage pipes fed double-sided (at the end of the collection box). Water layer thickness H = 5 m, k = 0.0018 m / s and n = 0.02 are given. Standard pipe diameters and costs are given as follows: 0.4 m (60 TL / m), 0.7 m (70 TL / m), 1.0 m (80 TL / m) and 1.3 m (85 TL / m). Size the leaking tube so that it is most economical (diameter, length and slope). Average flow velocity is between 0.2-0.4 m / s.
The infiltration rate f in a basin under ponding condition is given by f= 30 + 10e 2t where, f is in mm/h and t is time in hour. Total depth of infiltration (in mm, up to one decimal place) during the last 20 minutes of a storm of 30 minutes duration is