A recharge basin was evaluated for groundwater recharge and following parameters were determined (K-1.3 m/d, H, 0.6 m, f = 0.3, He 0.5m, L= 12 m and  Vinf= (432 m³). a. Estimate the average infiltration rate and infiltration time if (L = 2, 6 and 12 m). b. Estimate the surface area of recharge basin

Q: For the Horten model, the initial infiltration rate is equal to 27 cm/hr, the final infiltration…

A:

Q: 1:) A circular coagulation basin has a diameter of 2.5 m and it's depth equal to 1.60 m. If me…

A: diameter = 2.5 mdepth = 1.6 mGt = 27000t = 30 s = 1.00310-3 kg /m.salum = 50 mg/LFind: (a) The…

Q: drainage basin has an area of 9350 km2. The average annual precipitation for this area is 827 mm.…

A:

Q: Determine the time of concentration for use in the NRCS method for a drainage basin located in…

A: The given data is shown below:  Average Grass L = 100’ S = 1.6% n = 0.24Shallow Concentrated L…

Q: b. Determine the spacing of pipe drain from following data.    Annual rainfall = 1000mm  Drainage…

A: Pipe Drain: A pipe drain or a drainage pipe is used to transfer the wastewater collected from the…

Q: For the Horten model, the infiltration rate is equal to 0 cm/hr, the final infiltration rate is…

A:

Q: 2.31. Determine a Horton equation to fit the following times and infiltration capacities. Time f…

A: Find infiltration rate at 10 mins, 180 mins and 360 mins

Q: The initial infiltration capacity (fo) of a watershed is estimated as 1.3 in./hr, and the time…

A: Initial infiltration curve, fo = 1.3 in/hr Final infiltration curve, ff = 0.2 in/hr Time constant, k…

Q: ermeability that behaves as a one-dimensional aquifer with a hydraulic conduc /day, effective…

A: Given:- effective porosity=0.3 hydraulic gradient=0.03m/m initial concentration of cyanide=42mg/l To…

Q: The radius from the observation well A and B are 150 ft and 300 ft, respectively. The thickness of…

A: The radius of well A (Ra ) = 150ft The radius of well B (Rb) = 300ft Depth of aquifer (D) = 100ft…

Q: An artifical recharge pond is located in a sandy area (Kv = 10 m/day; porosity = 30%). The pond…

A: We can use the one-dimensional equation for vertical water flow in unsaturated porous media, known…

Q: If i (mm\hr) at +12, where (t) is the accumulated infiltration time in (min). Use the below data to…

A:

Q: For the following soil properties determine the volume of infiltration at surface saturation (Fs)…

A: Given that ks=1.75 in/hrθs=0.315θi=0.212ψ=-9.15 ini=7.75 in/hr We know that…

Q: Month Temperature( C) Relative Wind Humidity (%) velocity at 2m above GL (km/hour) Jan 12.5 85 4.0…

A:

Q: The DO of a river is 5.9 mg/L just downstream from a wastewater outfall. The mix of river and…

A:

Q: 12. (Horton's equation for infiltration rate, ). One can use Horton's equation to estimate the…

A: Given:To find:

Q: Calculate the infiltration rate using green ampt method at 0.2 hr for a silty clay soil at 0.1 hr…

A: Given: The effective saturation is 20%. The hydraulic conductivity is 0.05 cm/hr. The cumulative…

Q: The following data are available for a certain water treatment plant: t=30 min, t=1min, t-120 min,…

A:

Q: Hydraulic conductivity K= 100 ft/day, Aquifer thickness B = 50ft, Hydraulic gradient J = 0.001 Plume…

A: Co-efficient of Permeability , K=100ft/d Aquifer Thickness , B=50 ft Hydraulic Gradient , j=0.001

Q: The initial infiltration capacity fo of a watershed is estimated as 1. 5 in./hr and the time…

A: Given data :

Q: A groundwater borehole at USM engineering campus contains 3000 mg/L of TDS. The flow is 0.32 m3 /s.…

A: Discharge, Net pressure, Water flux rate coefficient,

Q: Use the Green-Ampt method to evaluate the infiltration rate and cumulative infiltration depth for…

A: Green-Ampt proposed a physics-based approach to arrive at results that were in agreement with…

Q: Secondary Clarifier  An activated sludge plant has a design flow (average daily flow) of 11 MGD.…

A: The volume of the tanks is given by,

Q: The infiltration capacity in basin is represented by Horton's equation as fp=5.0 + e-St where fp is…

A:

Q: A soil has the following soil properties for use in the Green-Ampt equation: n = 0.464 K = 1.5 in/hr…

A:

Q: (ii) For the rectangular septic tank in (i) above, prove or show that the efficiency of particle…

A:

Q: Q₂: A) At the beginning of a given day a reservoir has a surface area 30 Km². The inflow to the…

A: Reservoir surface area (A) = 30 km2 Inflow rate (Qi) = 80 m3/s Outflow rate (Qo) = 15 m3/s Seepage…

Q: 3.2 Calculate the time of concentration (I), with the following design inputs: • Hydraulic length =…

A:

Q: A manufacturing facility that manufactures printed circuit boards puts wash water that was used to…

A:

Q: The infiltration capacity in a basin is represented by Horton's equation as fp-3+eWhere fp is in…

A:

Q: The inital rate of infiltration of a watershed is estimated as 2.1 in/hr, the final capacity is 0.2…

A: Initial infiltration rate (fo) = 2.1 in./hr Final infiltration rate (fc) = 0.2 in./hr Time constant…

Q: t a given location parameters of Philip's equation were found as S = 45 cm/hr 0.5, and K = 10 cm/hr.…

A:

Q: In a drainage system, drainage spacing is 50 m and depth of the impermeable layer below drain level…

A: discharge Q = kiA where  k is hydraulic conductivity i is hydraulic gradient = (h2 - h1)/L here h2…

Q: 10. A 15,000 ft" conventional activated sludge system has a recycle ratio of 0.38, an influent flow…

A:

Q: The area shown in figure below is provided with a tile drainage system. knowing that: 1-Depth of the…

A: Given: Depth of the drains below land surface =1.5 m Depth of the impermeable layer below land…

Q: Considering the water balance equation, which processes are an input of water into the aquifer? A.…

A:

Q: Find the infiltration rate if the initial rate = 1.3 in/hr. and the final rate = 0.2 in/hr, k= 0.35…

A: Given: The initial rate is 1.3 in/hr. The final rate is 0.2 in/hr. The constant k is 0.35 per hour.

Q: Water table in a canal command receives a recharge at the rate 2.5 mm/day. Sub-surface ditch drains…

A:

Q: The hydraulic conductivity (K) of a homogeneous sandy clay mix aquifer is   2x10-3  cm/sec.   The…

A:

Q: AA רואד רחר בורו Determine the size (diameter and depth) of the secondary clarifier (s) at a…

A: Step 1

Q: A rectangular sedimentation basin with a length twice the width and 3 m deep, receives a flow of…

A: According to given data  A rectangular sedimentation basin with a length twice the width and 3 m…