Oxygen flows isentropically through a 100 mm −diameter pipe. At one point, the velocity of flow, pressure , and unit weight are 125 m/s,  450 kPa, and 0.058 kN m3 ⁄ , respectively. At another point a short distance away from the first, the pressure is 360 kPa. Determine the velocity at the second point.

Q: Q=2000J ПЛЛЛЛЛ air V(m/s) D=0.1m Tout=? Air at (3.15x10^2) K is entering in a circular pipe at…

A:

Q: Q5) The average velocity of the air flowing in a pipe with a roughness of ks=D0.0015 mm with a…

A:

Q: Helium flows through a 0.30-m-diameter horizontal pipe with a temperature of 20 °C and a pressure of…

A: Given : The diameter of pipe is The final diameterof pipe is is The flow rate is

Q: Oil is pumped from a very large tank (z1 = 150 m) to another tank (z2 = 200 m), located higher and…

A:

Q: Benzene flows in a pipe as shown in figure. Determine the pressure at point 2 if the pressure at…

A: Given that , P1=5.2 barQ1=0.5m3specific gravity of benzene =0.876D1=15 cm =0.15mD2=22.5cm…

Q: Two gaseous stream containing the same fluid enter a mixing chamber and leave as a single stream.…

A:

Q: An incompressible fluid of density 800 kg/m3 flows steadily at 8 m3/sec through a horizontal piping…

A: ρ=800 kg/m3Q=8 m3/sd1=1md2=0.5mP1=1000 kPa absP2=atmospheric pressure =101.325kPa

Q: Consider the following compressor that receives air at a constant rate of three cubic feet per…

A:

Q: Air at standard atmospheric condition flows through a pipe at a velocity of 20 m/s, which then…

A: Ans: 995 Pa

Q: . Solve for the inlet volume flow

A: To Find Inlet volume flow

Q: Water at 10°C flows through the system shown in the figure below at 0.28 m³/s. Energy loss in the…

A: Temperature of the water vessel. T1=10°C Diameter of the pipe. d =30cm=0.3m Diameter of the pipe…

Q: Air flows through pipe. A Venturi meter is used to measure the mass flow. The temperature and static…

A:

Q: Determine the time taken by the oil to get collected in a measuring jar of 26 x 10^-3 m3. The oil…

A: Given     Specific gravity, y =  0.74       Mean velocity, v = 5 m/s                        Area, a…

Q: Q=2000J ПЛЛЛЛЛ air V (m/s) D=0.1m Tout=? Air at (3.15x10^2) K is entering in a circular pipe at…

A: Given data: Temperature of air at entry = T1 = 3.15 x 102 K = 315 K Pressure of air = P = 101325 Pa…

Q: In fluid mechanics, The minor losses occur due to any disturbance that might occur to the flow,…

A:

Q: Air flows through pipe. A orifice meter is used to measure the mass flow. The temperature and static…

A:

Q: A liquid flows through a 2.067-in ID standard steel pipe at a velocity of 3 m/s. If the density and…

A: Given data as per question Diameter of steel pipe =2.067 in=0.0525018mvelocity =3 m/sdensity of…

Q: Water flows into the tank (Figure 1) at V = 8.5 m/s- Figure 15 m 1.5 m 40 mm 40 mm 80 mm 1 of 1…

A: The given data is shown below.

Q: A circular pipe 2 m long carries water and tapers uniformly from diameter 0.1 m at point A to 0.2 m…

A:

Q: Water flowing through a 2.1-cm-diameter pipe can fill a 400 L bathtub in 3.0 min . Part A What is…

A: We know that, Volume flow rate = Area × Velocity. Putting all the given value after converting them…

Q: Hot water at a constant volumetric flow rate of Fh and temperature Th(t) is mixed with cold water…

A: Given: Hot water at a constant volumetric flow rate of Fh and temperature Th(t) cold water at a…

Q: Calculate the mass flow rates for your main pipe and intersecting pipe using the instructions posted…

A: For the main pipe RE=500Dm=20 mmLm=400 mmβ=121° For intersecting ppe RE=5000Li=200 mmDi=18.5…

Q: Water is flowing through a U-section pipe as shown in Figure 1.2. At flange (1) the total absolute…

A:

Q: Show complete solution: Prove that for a fluid with a constant density ρ flowing at a steady-state…

A: For steady state condition, continuity equation for incompressible fluid (density =constant)…

Q: Problems 4: n-Butyl alcohol at 60°F flows between two parallel plates with the velocity given by…

A:

Q: Oil (Density = 860kg/m³) flows through a pipe. Pressure, velocity and height at a section are 1 bar,…

A: Given: Density of the oil =860kg/m3 Pressure (P)=1bar Velocity (V)=1m/s height (Z)=1m

Q: Question 7 A liquid, with a density of 850 kg/m3 , is flowing downwards through a vertical pipe…

A:

Q: Air is flowing steadily through a converging pipe at 40°C. If the pressure at point 1 is 50 kPa…

A:

Q: 1. A hydroelectric power-generating facility is to be built at a location that has a change of…

A: Given Data Q=227 m3/s H=45 m

Q: A fluid enters a pipe at speed v1=0.1 m/s. the diameter of the tube is d=200mm and the fluid flowing…

A:

Q: Water flows into the atmosphere from a nozzle and strikes a vertical plate as shown in Figure Q2. A…

A: Introduction In this problem, we will calculate the inlet and outlet velocities of the nozzle, the…

Q: A venturi meter has air flowing through it. The diameter at the entrance is 2.9 in and at the throat…

A:

Q: AB is a section in a 25 centimeter constant diameter pipe.  20 degree C mercury enters the section…

A:

Q: A pitot-static tube is used to measure the velocity of air flowing through a duct. The manometer…

A: Given: Pitot tube reading h=5cm of waterDensity of air ρa=1.13kg/m3Density of water…

Q: fluid at a certain temperature has a viscosity of 37.1 cP and a specific gravity of 0.8022. 49508.6…

A: Given:μ=37.1 cP =0.0371 Pa.ss=0.8022Q=49508.6 bbl1 day   =7,921.3763600*24 =0.09168 m3/sL=501.55…

Q: . A fluid with density ρ = 930 kg/m3 and viscosity η = 0.30 × 10−2 Pa · s flows in a pipe. The…

A:

Q: Air flows through a compressor under steady flow conditions. At suction V1=0.75m3/kg, v1=30m/s At…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.