Open feed water heater in the power plant operating according to the Rankine cycle with ideal intermediate steam is used. Turbine inlet state is 10MPa 650C. Condenser pressure is 10 kPa. Intermediate steam taking takes place at a pressure of 2 MPa. The intermediate steam mass flow rate depends on the total mass flow. Find the ratio. Find the thermal efficiency. TIP: Treat the mass flow entering the turbine by saying 1, and r for the intermediate steam. Result: r = 0.239, yield 45.2%

Q: the intake volume of an engine working on the carnot cycle is 43.5 m^3 while the voume after the…

A: The cycle efficiency. Given: The intake volume is V1=43.5 m3. The volume after the compression…

Q: Calculate the thermal efficiency and turbine-exit quality for an Ideal Rankine Cycle where the steam…

A: At state 1 P1=4MPa  T1=450C h1=3316.1 KJ/Kg S1=6.8185 KJ/Kg-K At state 2 Turbine exit Pcond=15KPa…

Q: 40˚C. Expansion now occurs to the condenser pressure of 0.0035 MPa. The steam flow is 147,000 kg/hr,…

A: In a reheat cycle steam at 15 MPa, 540˚C enters the engine and expands to 1.95 MPa. Reenters the…

Q: The steam supply to a two turbine unit is 6000kPa, 360°C. In the high pressure turbine the steam is…

A:

Q: a. Calculate the thermal efficiency and turbine-exit quality for an Ideal Rankine Cycle where the…

A:

Q: The pump in the Rankine cycle increases the pressure from 20 kPa to 6 MPa. The boiler exit…

A: P1 = 20 kPaP2 = 6 MPa or 6000 kPaBoiler exit temperature, T = 600°CRequired:Q ( heat supplied to…

Q: A reheat steam cycle has 13500 kPa throttle pressure at the turbine inlet and 2800 kPa reheat…

A:

Q: A power plant is to be operated on a Rankine Cycle with superheated steam exiting the boiler at 4…

A:

Q: In an ideal reheat-regenerative cycle, steam enters the turbine at 8.1356Mpa and 400.356oC. After…

A:

Q: Consider the steam enters the turbine with pressure of 40 bar, entropy of 7.0922 kJ/kg-K, and…

A: Data given- P = 40 bad  Entropy = 7.0922 kJ / kg - K  Condenser pressure = 0.0036 Mpa

Q: WATER IS USED AS THE WORKING FLUID IN AN IDEAL RANKINE CYCLE STEAM ENTERS THE TURBINE AT 20MPA AND…

A: given; →net workoutput(wnet)=?→heat transfer in steam generator (Q1)=?→thermal efficiency (η)=?→heat…

Q: A Rankine cycle given in the figure operates between 4 MPa and 10 kPa pressures. The adiabatic…

A: m = 10[kg/s]P[3] = 4000[kPa]T[3] = 600[C]P[4] = 400[kPa] P[6] = 10[kPa] The mass flow rate of the…

Q: A. A gas turbine expands gas from 1 MPa pressure and 600°C to 100 kPa pressure. The isentropic…

A: Calculated exit temperature and the power output.

Q: A power plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600°C in the boiler. It…

A:

Q: In a power plant working on Rankine cycle, the enthalpy at the end of conenser is 20 kl and the end…

A: Given data: Enthalpy at the inlet of the turbine (hiT) = 100 kJ Enthalpy at the outlet of the…

Q: Pump A small power plant produces steam at 3 MPa, 600°C, from the boiler. The first turbine section…

A: The inlet condition at turbine is The inlet pressure of second turbine is The condenser temperature…

Q: A reheat steam cycle has 13,580 kPa of throttle pressure at the turbine inlet and a 37.50308414 atm…

A:

Q: 4. A steam power plant that operates on a simple ideal Rankine cycle, the boiler pressure is 2 MPa…

A:

Q: Problem 3. A vapor power plant produces 25 kg/s steam at 6 MPa, 500°C, in the boiler. It cools the…

A:

Q: power plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600oC in the boiler. It…

A: Given:P1=3 MPaT1=600°CTc=45°C

Q: 9MPa pressure and 600C to steam high pressure turbine to ideal Rankine cycle with reheat it enters…

A:

Q: A power plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600oC in the boiler. It…

A: Given dataP=3MPaT=600°CQ=10MWPs=500kPaTs=45°C Here we using the steam table with respect to the…

Q: Q1: Consider a reheat regenerative vapour power cycle with a feed-water steam enter the first…

A: The inlet condition of high pressure turbine is The reheat pressure is .The inlet condition of low…

Q: A reheat steam cycle has 13500 kPa throttle pressure at the turbine inlet and 2800 kPa reheat…

A: given that: High pressure turbine inlet conditions are: P4 = 13.5 MPa, T4 = 540 oC Low pressure…

Q: Q.7 The condensing and evaporating temperatures of a vapor compression cycle using R134a are 40°C…

A:

Q: power plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600oC in the boiler. It…

A: To draw the T-s diagram for the given plant layout.

Q: The low pressure turbine in a regenerative cycle receives 10 kg/s steam at 600kPa, 500 C. The…

A: Given: The mass flow rate of steam, m = 10 kg/s The pressure at the entry of turbine, P1 = 600 kPa…

Q: Compute the thermal efficiency of an ideal Rankine cycle for which steam leaves the boiler as…

A:

Q: Example Consider a steam power plant operating on the ideal Rankine cycle the steam enters the…

A: Given that: For a Rankine cycle, temperature and pressure at the inlet of turbine are 350 oC and 3…

Q: A reheat steam cycle has 13500 kPa throttle pressure at the turbine inlet and 2800 kPa reheat…

A:

Q: plant operating in a Reheat Rankine Cycle produces steam at 3 MPa, 600oC in the boiler. It keeps the…

A: Given:P1=3 MPaT1=600°CTc=45°CP2=500 KPa

Q: Consider a simple ideal Rankine cycle with fixed boiler and condenser pressures.. Whathappens if the…

A: The Rankine cycle is an ideal cycle used to predict the performance of the turbine systems in the…

Q: Q2 Figure Q2 is a Reversed Carnot Cycle with a food department is kept at -12°C. The total heat gain…

A:

Q: 3. Steam is supplied to a two-stage turbine at 170 bar and 600°C. It expands isentropic ally until…

A: Given: T1 = 600 C P1 = 170 bar T3 = 500C P4 = 0.2 bar isentropic efficiency = 80%

Q: A reheat steam cycle has 13500 kPa throttle pressure at the turbine inlet and 2800 kPa reheat…

A: