OPEN CORPASS TRAVERSE. Given in the accompanying sketch pass traverse. alues accordingly. 23. the observed forward and' back bearings of an open com Adjust the observed directions and tabulate

Q: If you were to measure the cross section of a 2 x 4 you would find it to be 38 millimeters wideby 90…

A: Objective: To choose the correct option corresponding to size specifications of cross-section of a…

Q: A 6-in.-diameter concrete test cylinder is loaded with a com- pressive force of 113.1 kips, as…

A: Given data : The value of compressive force (F)=113.1 kips The value of diameter of concrete…

Q: Hello, can i also get help for this question too?

A: (1) the optimum speed = 28.68 mi/hr(2) the optimum density = 58 veh/mi(3) the maximum flow = 1663…

Q: A test car was used on a North-South road 0.75 km long, and the following data, for the moving car…

A: A test car was used on a North-South road 0.75 km long, and the following data, for the moving car…

Q: 3. A water jet that comes out of a pipe, exits into the air and strikes a plate. If the force is…

A:

Q: Hello, Can I get some help answering this question please?

A: TMS ≈ 28.5527 mph SMS ≈    1.1577 mph The Time Mean Speed (TMS) is generally higher than the Space…

Q: 6- --It is the smallest time taken to complete the activity if everything goes on well A- Most…

A:

Q: What materials are used for pipes in sanitary piping?

A: A sanitary drainage system consists of a system of piping for public or private premises that is…

Q: A steel rod 30 mm X 20 mm is subjected to an axial load of 35 kN. The original length of the rod is…

A: Given data : Original length (L)=650 mmDecrease in length (∆L)=-5 mmAxial load (P)=35 KNDimension=30…

Q: 2. Given the following depths of rainfall for an 8-hr storm event, graph the storm hyetograph with…

A:

Q: Example For the branching system shown in Fig. 11.14, calculate the discharge each pipe. Take f =…

A: Determine the discharge in each pipe.

Q: Hi, may i ask how to do these questions?Thank you for helping?

A: Solution for 12.93 Given;P=3kn

Q: Determine the centroid of the shaded area shown, which is bounded bythe X axis and the parabola y? =…

A:

Q: Determine the horizontal displacement of joint C of the truss. The cross-sectional area of each…

A: E = 200 GPa = 200 × 103 N/mm2  A = 200 mm2  Determine the horizontal displacement of the joint-C.…

Q: Draw the isometric figure of the given multiview projection. HRP FRP ==== ====== FRP PRP 1 11

A: The multi view projections are given.Multiview Projection:A Multiview Projection is a technique of…

Q: STANDARD PROCTOR TEST 1. Why does the soil need to be in the densest state when placed as an engine…

A: The soil need to be in the densest state when placed as an engineered fill because soil in densest…

Q: The floodgate of a dam is in the shape of a semicircle opening upwards. It is 10 ft tall. Calculate…

A:

Q: Question 2 J10p 180 grams of soil sample is in a cylindrical container, with a diameter of 40 mm and…

A: Given Data: mass of soil sample, w=180 g diameter of cylinder, D=40 mm height of cylinder, H=75 mm…

Q: The solid circular cross section of R = 8cm radius is subjected to torsional moment M2 = 60kNcm. The…

A:

Q: Problem-4 A series of direct shear tests was conducted on a soil, each test was carried out till the…

A: Given, Size of specimen = 50 mm x 50 mm Specimen height = 25 mm

Q: 3. (Tipler and Mosca, Physics for Scientists and Engineers, 5th Ed.) Consider three charges on a…

A:

Q: Question 4 The DO in an unseeded sample of diluted waste having an initial DO of 9.5 mg/L is…

A:

Q: 1. Calculate the extra width required for a horizontal road curve having 2 lanes of traffic and…

A: Given 2 lane roadRadius 250 mSpeed 60 km/hWheel base 6 mTo find out Extra widening

Q: Problem-10 A clay layer of 5m thick has the initial void ratio of 1.50 and pressure of 120 kN/m2.…

A:

Q: Q.02. The floor beam in below figure is used to support 6 meters width of a plain concrete slab…

A: GIVEN DATA: DENSITY OF PLAIN CONCRETE=22KN/m3 DENSITY OF ROCK=26KN/m3 DENSITY OF PLASTER =18KN/m3…

Q: 9. The table below shows the data collected on a highway during a speed study. Develop the frequency…

A:

Q: 5. The ground conditions at a particular site are as follows: Description of stratum Made…

A: I am solving the only question no 5 here, kindly resubmit the question for part 6.

Q: Find the net hydrostatic force and point of application y, on the 4 m tall, 5 m wide gate shown. -4…

A: Rectangular gate B= 5 m, H = 4mInclined at 30° from the horizontal.Gate at 2m below water surface…

Q: 6. The following traffic count data were taken from a permanent detector location on a major…

A: AADT is obtained by determining the average daily traffic volume recorded for all 365 days of the…

Q: The following data was collected during a 5-hour storm. If the base flow for the stream is 35 m³/s,…

A: Given: Base flow = 35 m3/s   Also, Let area of basin = 2 km2

Q: Line P to Q intersects the street alignment as shown in the sketch below. What is the length of line…

A:

Q: 6-33. Determine the force in members BC, HC, and HG of the bridge truss and state if the members are…

A: Determine the force in members BC, HC and HG of the truss.Let's using method of section.

Q: A rigid bar ABCD is pinned at end A and supported by two cables at points B and C (see figure). The…

A:

Q: 8. The looseness or denseness of sandy soils can be expressed numerically by the so-called relative…

A: Given data- Mass of the sample = 1830 g Volume of the sample = 0.001 m3 Sp.gravity (G) = 2.60 water…

Q: Air at 1000 mb and 18°C has a mixing ratio of 6 g/kg. What is its relative humidity and dew point…

A: Pressure, Temperature, Mixing ratio,

Q: Water flows at a depth of 0.8 m at a velocity of 0.9 m/s in a wide rectangular channel in a reach…

A: To calculate the surge velocity, we can use the Joukowsky equationThe acceleration due to gravity =…

Q: A soil profile is provided below. The estimated stresses from a spread footing overlying a 10 meter…

A: Average overburden pressure at the center of the clay layer, σ0'=17.3×3+19.82×5-9.81×5=101.95 kPa…

Q: Determine the x- and y-coordinates of the centroid of the shaded area. 60 -145- 60 130 -x Dimensions…

A: To find location of centroid

Q: An office building is planned to be built on the site shown below. The total weight of the building…

A:

Q: What is the maximum absolute shear for the following beam and load group? Use L = 20, a = 4, b = 3,…

A: L= 20 a = 4 b = 3  P1 = 4   , P2 = 2,   P3 = 3

Q: The diameter of pipe at the section 1 and 2 are 15 cm and 20 cm respectively. Find the discharge…

A: Given data : Diameter at section 1 (d1)=15 cmDiameter at section 2 (d2)=20 cmVelocity of water at…

Q: List at least 4 skills/knowledge of Home Maintenance/Construction

A: The four skills are : Good planner : The engineer should be good planner to get desired output in…

Q: 4. The wide of the dam is x m. a.Find the hydrostatic force on surface AB and its moment about C.…

A: Question is based on the gravity dam . Width, Height and specific gravity of dam are given in the…

Q: PLEASE HELP IN ANSWERING MY PROBLEM SET THANKYOU!!

A:

Q: 5. Determine the pressure head elevations at B and D and the discharges in the branches in the…

A: From question length and diameter of each pipe is given.Roughness coefficient of each…

Q: The following are the results of a field unit weight determination test on the same soil with the…

A: Draw the compaction curve from the given data from the laboratory test. The water content…

Q: A direct shear test is performed on a specimen of dry sand. The shear box is circular in cross-…

A: Given: