i need the answer quickly One disadvantage of the following network is:R&DTXDRxDU1TxBUART MSP430ATM4C UARTGadGndTxDU1RxTxDOOCTMS320SCIGndTXD TXDa. large networkb. ring networkc. if one node is disabled, all network is trippedd. small networkRxDRxDSelect one:

Dear learner, hope you are doing well , I will try my best to answer this question. Thank you!!!

One disadvantage of the following network is: RxD TxD RxD U1Tx B A UART MSP430 TM4C UART Gud Gnd TxD U1Rx C TMS320 SCI Gnd TxD TxD a. large network b. ring network c. if one node is disabled, all network is tripped d. small network TxD RxD Select one: O O O RxD

One disadvantage of the following network is: RxD TxD RxD U1Tx B A UART MSP430 TM4C UART Gud Gnd TxD U1Rx C TMS320 SCI Gnd TxD TxD a. large network b. ring network c. if one node is disabled, all network is tripped d. small network TxD RxD Select one: O O O RxD

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Create a spanning tree for the given topology. Label all ports with their status i.e. Root, designated or block. Note: STP link costs are shown in brackets
It is necessary to do research on connectionless protocols in order to determine whether or not they can successfully replace connection-based protocols.
Computer networking subject rcs817
Computer Networks - Internet Architecture & Application Layer
Connectionless protocols have pros and downsides.
Question 6 Router1 10.0.0.1 00:00:00:00:01 Switch 1 10.0.0.0/24 Switch 2 10.0.1.0/24 Alice 10.0.0.2 00:00:00:00:02 Bob 10.0.0.3 00:00:00:00:03 Charlie 10.0.1.2 00:00:00:00:05 Consider the following network. Suppose Charlie sends a packet to Bob. What are the packet's source and destination IP and MAC addresses when transmitted from Charlie's computer? A Source IP: 10.0.1.2 Destination IP: 10.0.0.3 Source MAC (last 2 digits): 05 Destination MAC (last 2 digits): 04 B Source IP: 10.0.1.2 Destination IP: 10.0.0.3 Source MAC (last 2 digits): 05 Destination MAC (last 2 digits): 03 Router2 10.0.1.1 00:00:00:00:04 C) Source IP: 10.0.1.2 Destination IP: 10.0.1.1 Source MAC (last 2 digits): 05 Destination MAC (last 2 digits): 04 D Source IP: 10.0.1.2 Destination IP: 10.0.1.1 Source MAC (last 2 digits): 05 Destination MAC (last 2 digits): 03 Danielle 10.0.1.3 00:00:00:00:06 ... Feedback The source IP address and destination IP address does not change no matter where a packet is along its…
There are 4 routers Router A, B, C and D Router B and D are connected in a network system, RIP is the routing protocol running on the routers, DV(distance vector) algorithm is the routing algorithm for RIP, a new link is added to the system to conect router A and C, will this addition trigger router A to re-compute its DV?
Write a Java TCP MultipleClient-Server Program for following scenario. NOTE Server Details are in the above figure Client-Server communicates continuously until the Client send Bye to the Server Use Multithreading for Multiple Clients NOTE : 1 cm = 0.39 inches 1 cm = 0.03 foot 1 cm = 0.01 meter Sample Ouput: Client Server 1 – cm to inches 2 – cm to foot 3 – cm to meter Enter length in cms (int) : 10 Received from Server 3.9 inches 1 – cm to inches 2 – cm to foot 3 – cm to meter Enter length in cms (int) : BYE Received from Server BYE Client DISCONNECTED Server Waiting for the Cline to be Connected… CONECTION ESTABLISHED Received From Client 10 cms Sent to Client 3.9 inches Received From Client BYE Sent to Client BYE HINT : When client choses 1 for cm to inches and enter 10, then the client sends the string 110 to the Server. Where the first char ‘1’ represents the cm to inches and the other 2 chars represents the 10.
Below is example simulation based on Cisco Packet Tracer! Try to make an interconnection between 3 pieces of network that are connected to a router. Innetwork-1 has a DNS Server and 1 workstation, on network-2 there is an HTTP Server(.com domain) and 1 work station, on network-3 there is an HTTP Server(on the domain .com) and 1 work station. Do such a configuration so that each work station can access the existing server services on the three those networks?
Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between the two nodes is 245 bit-times. Suppose A and B send Ethernet frames at the same time. Suppose the transmission time of the entire frame is 295 bit-times. So, the frames collide, and then A and B choose different values of K in the CSMA/CD algorithm. A node chooses the value of K at random from {0,1,2,...2n−1} where n is the number of collisions experienced on the channel – note n is set to 1 in this case). For Ethernet, the actual amount of time a node waits is K*512 bit times (i.e., K times the amount of time needed to send 512 bits into the Ethernet). Suppose A chooses a K value of 0 and B chooses a K value of 1. Assuming no other nodes are active, can the retransmissions from A and B collide? Justify your answer by showing all the intermediate steps of your calculations.
One of the advantages of hierarchical routing (HR) is easier duty cycling because O Nodes battery replacement in flat routing in harder that HR O Nodes are rarely routers in HR than Flat routing O Nodes are more powerful in HR than Flat routing Nodes are more organized in HR than Flat routing O Node have longer hops in HR than in flat routing
Assume a client is connected to the server and has already received an HTML webpage. It reads the webpage, and it now needs to get 3 new files, File A is 5 MB file B is 1 MB and file C is 1 KB. The client requests the files in the order A B C. The link has an RTT (round trip time) of 0.5 seconds and a bandwidth of 8 Mb/s(Megabits per second) (or 1 Megabyte per second). The client can reuse the open connection if the protocol allows it to. For all parts of this problem ignore header sizes, and start the timer when the client sends How long does it take to get file C under HTTP 0? How long does it take to get file C under HTTP 1 (assume the browser does not support pipeling)? How long does it take to get file C under HTTP 2 assuming a frame size of 1 KB and no server push? What event would make HTTP 3 faster than HTTP 2 for this use case (ignore TLS)?