On the axes below, make sketches of the kinetic energy (K), gravitational potential energy(Ugrav), and elastic potential energy (Uel) of the system on the y-axis as a function of the height ofm2 on the x-axis, where the location y = 0 is defined as the point where mass m2 collides withthe spring. Note that the start of the x-axis is height h, and the end of the x-axis is height -d.KhU grav0height of mass m₂ above the springhPO-d0-dheight of mass m₂ above the springh0height of mass m₂ above the spring-d

We are given the the mass which collides with spring. Just before collision, the kinetic energy is…

Answered: On the axes below, make sketches of the…

Similar questions

If a projectile with a mass of 9.90 g is traveling at a speed of 1.21km/s, determine the following. (a) kinetic energy of the projectile in kilojoules1 kJ(b) kinetic energy of the projectile in kilojoules, if its speed is reduced by a factor of two2 kJ(c) kinetic energy of the projectile in kilojoules, if its original speed is increased by a factor of three3 kJ
A Ballistic Spring is like a Ballistic Pendulum, but it uses elastic potential energy instead of gravitational potential energy to measure the incident velocity of a projectile. Questions 4 and 5 refer to the Ballistic Spring shown below, where a projectile of mass m travelling with an initial velocity v impacts and travels through a block with mass M, emerging with a velocity , and causing the spring with constant k that is attached to the block to be compressed a distance d. m Vo Before M wwwww M Wowwwww After
Please asap
A 7,300-kg truck runs into the rear of a 1,000-kg car that was stationary. The truck and car are locked together after the collision and move with speed 8 m/s. Compute how much kinetic energy was "lost" in this inelastic collision. answer using J (JOULE)
A 5.77-kg object passes through the origin at time t = 0 such that its x component of velocity is 5.45 m/s and its y component of velocity is -2.94 m/s. (a) What is the kinetic energy of the object at this time? (b) At later time t = 2.00 s, the particle is located at x = 8.50 m and y = 5.00 m. What constant force acted on the object during this time interval? magnitude direction ° measured from the +x axis (c) What is the speed of the particle at t = 2.00 s? m/s
A block of mass m 2 kg is dropped from a height of h-40 cm (measured from the tip of the linear vertical massless spring) onto a spring of spring constant k-196 N/m. Find the maximum velocity of the mass as it compresses the spring in downward direction? (g=9.8 m/s).
Lab cart A has a mass of 2.5kg. Lab cart B has a mass of 1.8kg. Both cares are at rest on a horizontal surface. Between them is a spring, k=150N/m, compressed 15cm. The system is help at rest and then released. (a) How much energy is initially stored in the spring? (b) After being released from rest, what is the velocity of each of the lab carts?
The ballistic pendulum used to be a common tool for the determination of the muzzle velocity of bullets as a measure of the performance of firearms and ammunition (nowadays, the ballistic pendulum has been replaced by the ballistic chronograph, an electronic device). The ballistic pendulum is a simple pendulum that allows one to record the maximum swing angle of the pendulum arm caused by the firing of a bullet into the pendulum bob. Let L = 1.5 m and mA = 7.5 kg. For George Washington’s 0.58-caliber pistol, which fired a roundball of mass mB = 87 g, it is found that the maximum swing angle of the pendulum is θmax = 46°. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Bullet B fired from a gun secured on a stand hits block A attached to a vertical rod of length L pivoted at the top.The illustration indicates that, after the impact of the bullet, the block moves upward to the right through an angular displacement theta.…
As shown in the figure, two boxes of mass and are connected by an essentially massless, non-elastic wire passing over a light, frictionless pulley. The box of mass m, is released from rest at height h above the table. Use the isolated system model to answer the following. (We assume m, > m,. Use any variable or symbol stated above along with the following as necessary: g.) (a) Determine the speed of m, just as m, hits the table. v= 5.77 Since the only force acting is the conservative force of gravity, mechanical energy is conserved. Write a statement of conservation of energy and the expressions for the change in kinetic energy and the change in gravitational potential energy. Combine these three expressions and solve for the speed in terms of known quantities. Note that you want the speed and not the velocity. (b) Find the maximum height above the table to which m, rises. hmax = 6.66 The maximum height is the distance h plus Ah the distance m, travels upward after m, lands on the…
Particle A has mass m. Particle B has twice the mass of Particle A. The same constant force F acts on both particles over distance Ax. Which particle has the larger kinetic energy? O EA > EB EA < EB EA = EB There is not enough information to tell.
In this question you will use an energy approach to determine how the mass of a spring affects its motion. Normally we assume the spring has zero mass. But if we realize real springs have mass we can find the contribution to the kinetic energy of the system due to the motion of the spring. What makes this hard is that different parts of the spring move at different velocities. So, we must use a little calculus to find the result.Consider a vertical spring of mass m that has a mass M attached at its end. Let the position of the mass at the end of the spring relative to the point of attachment be given by Y and its velocity be given by V. a) What is the velocity of a small segment of the spring at the point of attachment? b) What is the velocity of a small segment of the spring right next to the moving mass? c) What is the velocity of a small segment of the spring that is exactly halfway between the top and the bottom? d) Now let the mass of the spring be m and…
As shown in the figure, two boxes of mass and are connected by an essentially massless, non-elastic wire passing over a light, frictionless pulley. The box of mass m, is released from rest at height h above the table. Use the isolated system model to answer the following. (We assume m, > m,. Use any variable or symbol stated above along with the following as necessary: g.) (a) Determine the speed of m, just as m, hits the table. %3= (b) Find the maximum height above the table to which m, rises. hmax =

SEE MORE QUESTIONS