bandwidth 6 KHz is Sam pledat theA Signal of-Nyquist rate and quantized uni Formly. the quantization ertoris not to eXceed o.25%. of the signal Peak amplitude there sulting quantized Samples are now coded and transmitted by16-0ry PAM pulses Determine :O the minimum number of 16-ary PAM Pul ses required to encodeeach sample .the minimum transmission bandwidth vequired to transmitthis data© the resulting bit -rateO the required 16 -ary PAM power to Keep the same noiseimmunity as the binary PAM if the magnitude of binaryPAM Pulses is t5 mu.

Given - Bandwidth of signal = 6KHz

O the minimum number of 16-ary PAM Pul ses vequired to encode each sample. D the minimum transmission bandwisth required to transmit this data © the resulting bit -rate O the required 16-ary PA M Power to Keep the same noise immunity as the binary PAM if the magnitude of binary PAM Pulses is t5mu.

O the minimum number of 16-ary PAM Pul ses vequired to encode each sample. D the minimum transmission bandwisth required to transmit this data © the resulting bit -rate O the required 16-ary PA M Power to Keep the same noise immunity as the binary PAM if the magnitude of binary PAM Pulses is t5mu.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A source generates binary digits 0, 1, with probabilities P(0) = 0.3 and P(1) = 0.7. Calculate the…

A: given a source generates binary digits 0 , 1 with probabilities P0=0.3 & P1=0.7Here we have to…

Q: Determine the bit rate and quantization step of the ADC in the sampling of analog signal with x[n]…

Q: In PCM quantization, the magnitude of the sample is rounded off to the nearest valid level code…

A: B is the correct answer In pulse code modulation while doing the quantization after the sampling of…

Q: Q2): consider a 3 kHz band limited voice signal sampled at 8000 sample/sec to be transmitted over a…

Q: 2. You wish to implement a length 4, FIR filter with real coefficients whose frequency response is 3…

Q: A 4-bit DAC has failed in such a way that the MSB is stuck in the 0 state, Draw the analog output…

Q: [7] Convert the integer B53DF816 from hexadecimal to binary notation.

A: Conversion of Hexadecimal number into binary notation can be done with the help of following method.…

Q: The clock select register for channel A in an MC68681 DUART has bits 0 through 3 set to 0, 0, 0, and…

A: For the bits in clock register of the 0, 0, 0, 1 signal, the baud rate will be 2400.

Q: (1) In a PCM system, SN,R is to be held to minimum of 40dB. Determine the number of required…

A: The solution is given below

Q: The octal equivalent of the output of binary muliplication of (110) and (111) is

A: we need binary multiplication of the number then octal representation,

Q: Analog data having highest harmonic at 30-kHz generated by a sensor has been digitized using 6 level…

A: Sampling is process of converting Analog signal in to discrete signal. The sampling theorem states…

Q: Design ADC using VTC (Voltage to Time Converter) with clock generator fe-32Hz and the slope of…

A: Given data, Slope K=0.025 Maximum Analog Input VA=20V Frequency fc=32Hz

Q: In an ADC, the number of ADC internal clock cycles required to quantize a sampled signal is…

A: ADC's convert analogue signals—signals found in the physical world like as temperature, current,…

Q: Q1. Design asynchronous (ripple ) binary counter and timing diagram for the following sequence…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Why is the Nyquist sampling theorem important in analogue to digital conversion? It defines the…

Q: If A = 0011 and B = 1111 then the output of 4 –bit Magnitude comparator is

A: Given, A = 0011 & B= 1111 here,A3 = 0, A2=0, A1= 1, A0=1 And, B3 = 1, B2=1, B1=1, B0=1

Q: Write the binary pattern for the following modulated signal if it was modulated using differential…

Q: representation, the error of quantization, and the SNR when the input voltage is 4.2 Volt.

Q: 1) Convert from (i) Find the binary equivalent of the BCD number (0110 1001 1001.0100 0101 0011)…

A: In this question, We need to Convert from (i) Find the binary equivalent of the BCD number (0110…

Q: For Arduino ZERO, using 2.23 V built in reference, what is the input code if the default bit…

A: Default bit is 10 for Arduino ZERO.

Q: Output data ratio of 8 bit PCM TDM system sampling 24 voice channels, comparing these using meu law…

A: Given, Number of bit, n= 8 PCM-TDM system sampling having number of voice channels, N=24 Frequency,…

Q: For a CD audio system, the analog signal is digitized such that the signal to quantization ratio is…

A: Given data: Signal to quantization noise ratio SNQ≥96 dB Sampling frequency fs=44100 Hz

Q: Given the positive number 77. a) Represent the number as an eight–bit number in two’s–complement…

A: Represent the (+77) as an eight-bit number in two’s–complement form

Q: DAQ counters on Encoder Input (EI) channels limit the range of counts measured by an encoder. For an…

Q: Consider sampling (quantizing, digitizing) analog temperatures in the range from -17 to 17 °F. How…

A: Given, Sampling analog temperature in the range from -17 ° F to 17° F. The smallest difference…

Q: Example 1.3: A digital optical disc (CD) storage records video signals digitally by using PCM.…

Q: Draw the 4-bit shift right register circuit implemented with JK type F/Fs. Since the circuit has…

A: A flip flop is used to store 1 bit of information to store series of data registers are used.…

Q: a noiseless 4kHz channel is sampled every 1msec, What is the maximum data rate? How does the maximum…

Q: Q3) Sec b) Which shift keying technique is used in the following diagram? Briefly explain Amplitude…

A: The amplitude of the resultant output depends upon the input data is in the case of the amplitude…

Q: Consider there is a recording session to capture animal sounds in a particular region using a 3-bit…

A: The Analog to Digital converter is used to convert the analog signal into digital signal. The…

Q: You are given the following curve. If the signal to noise ration is 10dB per bit and QPSK is used as…

A: Given: The following curve is given: The signal to noise ratio is 10 dB per bit and QPSK is used as…

Q: Consider a binary sequence with a long sequence of Is followed by a single "0" and then a long…

Q: Determine the bit rate and quantization step of the ADC in the sampling of analog signal with x[n]…

A: We need to find out data rate and step size for given problems , we know direct formula for data…

Q: An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 3.2kHz.…

Q: The bit interval of a binary signal 300 usec. Determine the bit rate in kbps.

A: This question belongs to data communication . It is based on the relation between bit rate and bit…

Q: If the stream 10110 is passed through an even parity checker and the parity bit gets added to the…

A: The given stream data in binary is 10110 and it has an odd number (3) of 1's in it.

Q: Determine (a) the peak frequency deviation, (b) minimum bandwidth, and (c) baud for a binary FSK…

A: The Baud rate represents the number of data inputs which is transmitted per second.Whereas the Bit…

Q: ital recording system samples each of two stereo input signals with a 16bit ADC at 44.1k sample per…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Question

bandwidth 6 KHz is Sam pled
at the
A Signal of-
Nyquist rate and quantized uni Formly. the quantization ertor
is not to eXceed o.25%. of the signal Peak amplitude the
re sulting quantized Samples are now coded and transmitted by
16-0ry PAM pulses Determine :
O the minimum number of 16-ary PAM Pul ses required to encode
each sample .
the minimum transmission bandwidth vequired to transmit
this data
© the resulting bit -rate
O the required 16 -ary PAM power to Keep the same noise
immunity as the binary PAM if the magnitude of binary
PAM Pulses is t5 mu.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Digital Modulation Scheme (Amplitude-Shift Keying [ASK], Phase-Shift Keying [PSK], Frequency-Shift Keying [FSK])

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Compare the bit error probability performance of a BPSK and QPSK system
a) In an audio system music signal is band limited to 5kHz.It is digitized so that the peak signal power to quantization noise power is at least 104dB. Calculate: i) The sampling rate if the signal is sampled at a rate 3.5 times the Nyquist rate; b) c) ii) The number of quantization levels; iii) Number of bits per sample. iv) Bit rate; and
(7) An analog signal with a bandwidth of 4.2kHz is to be converted into binary PCM and transmitted over a channel. The peak signal to quantization ratio at the receiver output must be at least 55dB. (a) If we assume that Pg 0 and that %3D there is no ISI, what will be the word length and the number of quantization steps needed? (b) What will be the equivalent bit rate? (c) What will be the channel bandwidth required if rectangular pulse shapes are used?
An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 3.2kHz. If the system is operated at a bit rate of 36,000 bits per second (bps), answer the following: a) To avoid aliasing, the sampling frequency must be greater than or equal to kHz b) If the signal is sampled at the Nyquist rate, what is the Nyquist frequency? kHz h c) If the signal is sampled at the Nyquist rate, the number of bits per sample is number of quantization levels is and the Note: *When you use the formula bFs L in finding b, the result must be rounded up to the nearest integer.
PLEASE LECTURE NAME SIGNALS AND INBFIRAMTRINOS
Complete solution
3- If we increased 2 bits of the ADC quantizer, what is the improving in the SNR will be? Discussed your answer.
Four voice signals. each limited to 4 kHz and sampled at Nyquist rate are converted into binary PCM signal using 256 quantization levels. The bit transmission rate for the time-division multiplexed signal will be a) 8 kbps b) 64 kbps c) 256 kbps d) 512 kbps
need help
Q What is the output frequency of a 4-bit binary counter for an input clock of 160 MHz? What are the unused states in a 3-bit Johnson counter?
Ex (1):- A digital optical disc (CD) storage records video signals digitally by using PCM. Assume the video signal 20 KHz. 1- What is the Nyquist rate. 2- If the samples are quantized into L = 65536 levels and then binary coded, determine the number of binary digits required to encoded a sample. 3- Determine the number of binary digits per second (bit rate).
An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 3.2kHz. If the system is operated at a bit rate of 36,000 bits per second (bps), answer the following: a) To avoid aliasing, the sampling frequency must be greater than or equal to kHz b) If the signal is sampled at the Nyquist rate, what is the Nyquist frequency? kHz h c) If the signal is sampled at the Nyquist rate, the number of bits per sample is number of quantization levels is and the Note: *When you use the formula bFs L in finding b, the result must be rounded up to the nearest integer.