O O, O O O O O O O 4. In the figure to the right, the rod moves with a speed of 1.8 m/s, is 24 cm long, and has a resistance of 2.2 N. The magnetic field is 0.35T and the resistance of the U shaped conductor is 26 2 in this situation. Calculate a) the emf induced; b) the current flowing through the U shaped conductor, and qo o e ni ult c) the external force needed to keep the rod's velocity constant at that instant.

O O, O O O O O O O 4. In the figure to the right, the rod moves with a speed of 1.8 m/s, is 24 cm long, and has a resistance of 2.2 N. The magnetic field is 0.35T and the resistance of the U shaped conductor is 26 2 in this situation. Calculate a) the emf induced; b) the current flowing through the U shaped conductor, and qo o e ni ult c) the external force needed to keep the rod's velocity constant at that instant.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

As seen in Figure 2, a rod with minimal resistance rotates at an angular velocity of @= 5.0 rad/s across a circular area with a radius of a = 0.2 m. A second rod with low resistance is immobile. Two rods are interconnected in the middle of a circle. A magnetic field with a strength of B = 0.3 T permeates the paper. r = 0.40 m/m is the resistance per unit length of the circular arc. Determine the induced emf and current direction. Indicate the induced current and its direction on the diagram. X X X-X X X x xx xx x X X B xx x X XXX x x X X X X X X X Fig 2. Problem 2
Faradey’s law states that the EMF induced by a change in magnetic flux depends on the change in magnetic flux with respect to time and number of turns of coils. Mathematically it is defined like the figure. Why do we use ds in the line integral of Faradey’s law to calculate the electric field? Don,t copy from anywhere. Do all calculation step by step .Answer Must be correct.Read question all step.
A circular loop in the plane of the paper lies in a 0.60 T magnetic field pointing into the paper. The resistance of the coil is 1.55 Ω. If the loop's diameter changes from 20.5 cm to 9.00 cm in 0.40 s, what is the average induced current in milli-amps?
Microphones are used to convert sound vibrations to electrical signals. In one kind of microphone, sound waves move a coil of wire up and down in a magnetic field, as shown in (Figure 1). The coil shown has a diameter of 1.6 cm and has 100 turns; the 0.010 T magnetic field points radially out from the north pole to the south. Figure S N Wire coil 1 of 1 Part A If the microphone's emf at some instant is 10 mV, what is the speed of the coil? Express your answer with the appropriate units. V = Value Submit μÃ Provide Feedback Request Answer Units www ?
An electromagnet is used to produce a uniform magnetic field between its poles, shown in figure 3 below. The field outside the gap is negligible. The coil encloses the magnetic flux. The magnetic flux density through the coil is 0.04 T and the coil has 50 turn. i.Calculate the flux through the coil ii.The current through the coil is reduced to zero at a uniform rate over a time of 2.5 s. Find the average e.m.f. induced in the coil
In the figure (Figure 1) a conducting rod of length L = 40.0 cm moves in a magnetic field B of magnitude 0.410 T directed into the plane of the figure. The rod moves with speed v = 5.60 m/s in the direction shown. Part F What is the potential difference across the rod if it moves parallel to ab? Express your answer in volts. Figure < 1 of 1 ? V = 0.91 V B х ах
The circuit given is a square 20 cm on a side. The magnetic field increases steadily from 0 T to 0.50 T in 10 ms. What is the current in the resistor during this time?
At what speed must the sliding rod in the figure below move to produce an emf of 1.10 V in a 1.77 T field, given the rod’s length is 31.0 cm?
A metal rod moves with constant velocity along two parallel metal rails connected with strip of metal at one side as shown in Figure. A magnetic field B = 0.35 T points outof the page. If the rails are separated by distance ZL = 25 cm and the speed of the rod isv= 55 cm/s, find a) the induced emf and direction of induced currentb) the amount of heat released in this system in 3 min if the rod has resistance of 18 Qand the rails have negligible resistance.
The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor is R = 6.20 Q, and a 2.50-T magnetic field is directed perpendicularly downward, into the page. Let = 1.20 m. x * * Bin xx * X X * R x x x x x * * x X xxxxxx x x X x X X x * x XXXX * F app x X * (a) Calculate the applied force required to move the bar to the right at a constant speed of 2.50 m/s. N (to the right) (b) At what rate is energy delivered to the resistor? W
A circular coil enclosing an area of 140 cm? is made of 210 turns of copper wire (shown in the figure below). The wire making up the coil has no resistance; the ends of the wire are connected across a 3.00-N resistor to form a closed circuit. Initially, a 1.20-T uniform magnetic field points perpendicularly upward through the plane of the coil. The direction of the field then reverses so that the final magnetic field has a magnitude of 1.20 T and points downward through the coil. If the time interval required for the field to reverse directions is 0.200 s, what is the average current in the coil during that time? R
The magnetic field through a single loop of wire 14.0 cm in radius and of 11.5 Ω resistance changes with time as shown in the figure. Calculate the emf in the loop as a function of time. a)What is the emf at t = 1.0 s? For the sign take the loop in the plane of the paper, and the magnetic field out of the paper. Take clockwise to be positive emf. b)What is the emf at t = 3.0 s? c)What is the emf at t = 5.0 s? d)What is the current at t = 1.0 s?