O(+ 3r The homogeneous disc with a mass of 4m and radius of 3r is supported at point 0. For small oscillations, find the equations of motion of the two – degree – of – freedom system in terms of the given parameters (k, m, r), and show them in the matrix form. The system is in the static equilibrium position at the instant given. S.E.P. 4m 2k 5k Зт *(+)

O(+ 3r The homogeneous disc with a mass of 4m and radius of 3r is supported at point 0. For small oscillations, find the equations of motion of the two – degree – of – freedom system in terms of the given parameters (k, m, r), and show them in the matrix form. The system is in the static equilibrium position at the instant given. S.E.P. 4m 2k 5k Зт *(+)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q2B. In Figure Q2B, if h=700mm and d = 500mm and each spring has constant k = 600Nm, determine the equation of motion of the mass m. For what value of the mass m will the period of small oscillations be (i) 0.25 s (ii) Infinite Under damped Choral 04pr www Figure Q2B Xu) 20 (om wt +x)
A mass m is attached to both a spring (with given spring constant k) and a dashpot (with given damping constant c). The mass is set in motion with initial position x0 and initial velocity v0. Find the position function x(t) and determine whether the motion is over-damped, critically damped, or under-damped.
5. A mass on a spring is shown below. Let y(t) be the displacement of the spring as a function of time t. Position A is the equilibrium position corresponding to y = 0. As was done in class, we are taking the positive direction to be downward. The graph of the solution to an initial value problem for this spring is shown. Answer the following questions about this system. A m B A: y=0 C (a) The spring's starting position (at t = 0) could be at i. Position A (Equilibrium) ii. Position B (Above Equilibrium) iii. Position C (Below Equilibrium) iv. Not enough information to tell (b) The spring's starting velocity (at t = 0) is i. positive ii. zero iii. negative iv. Not enough information to tell (c) Immediately after being set in motion at t = 0) the spring
A thin cylindrical rod of uniform mass m and length L is suspended from the ends by two massless springs with constants k1 and k2 (Distance L1 and L2 on either side of the center of mass of the rod). The motion of the center of mass is constrained to move up and down parallel to the vertical y-axis. It also experiences rotational oscillations around an axis perpendicular to the rod and passing through the center of mass (I is the moment of inertia with respect to said axis). be y1 and y2 the displacements of the two ends from their equilibrium positions, as shown in Fig. a) Find the motion's equation (consider k1=k2=k)
4.Find equation of motion and the period of the mass-spring systen k₂ = 2k, m Fig 1 k₁ =3k₁
3- The single-degree-of-freedom "manipulator" shown below has total mass m = 1, with the center of mass at and has inertia tensor Rot ¹Pc: Ch= 100 020 002 'd From rest at t = 0, the joint angle 01 moves in accordance with the time function: 0₁ (t) = bt + ct² in radians. Give the angular acceleration of the link and the linear acceleration of the center of mass in terms of frame {1} as a function of t.
A mass m is attached to both a spring (with given spring constant k) and a dashpot (with given damping constant c ). The mass is set in motion with initial position xo and initial velocity vo. Find the position function x(t) and determine whether the motion is overdamped, critically damped, or underdamped. If it is underdamped, write the position function in the form x(t) =C, e - pt cos (0,t-a,). Also, find the undamped position function u(t) = Co cos (@ot - ao) that would result if the mass on the spring were set in motion with the same initial position and velocity, but with the dashpot disconnected (so c= 0). Finally, construct a figure that illustrates the effect of damping by comparing the graphs of x(t) and u(t). C = 1 m = - 4 c= 3, k= 8, x, = 7, vo = 0 x(t) = 14 e -4t - 7 e -8t , which means the system is overdamped. (Use integers or decimals for any numbers in the expression. Round to four decimal places as needed. Type any angle measures in radians. Use angle measures greater…
A three-blade wind turbine used for research is supported on a shaft so that it is free to rotate about O. One technique to determine the centroidal mass moment of inertia of an object is to place a known weight at a known distance from the axis of rotation and to measure the frequency of oscillations after releasing it from rest with a small initial angle. In this case, a weight of Wadd = 50 lb is attached to one of the blades at a distance R = 20 ft from the axis of rotation. Knowing that when the blade with the added weight is displaced slightly from the vertical axis, and the system is found to have a period of 7.6 s, determine the centroidal mass moment of inertia of the three-blade rotor.
Consider the double mass/double spring system shown below. - click to expand. Both springs have spring constants k, and both masses have mass m; each spring is subject to a damping force of Ffriction -cz' (friction proportional to velocity). We can write the resulting system of second-order DEs as a first-order system, t' (t) = Au(t), with = (₁, 21, 22, 2₂) I For values of k = 4, m = 1 and c = 1, the resulting eigenvalues and eigenvectors of A are -0.039-0.248i 0.813 A₁2=-0.5±3.2i, v₁ = 0.024 +0.153i -0.502 -0.134-0.302i 0.409 -0.2160.489 0.661 (a) Find a set of initial displacements (0), 2(0) that will lead to the fast mode of oscillation for this sytem. Assume that the initial velocities wil be zero. A3,4 -0.5± 1.13i, z = and (2₁ (0), ₂(0)) = Enter your answer using angle braces, (and). (b) At what frequency will the masses be oscillating in this mode? Frequency rad/s
A System is found to have the following equetion of motion mtJ x+Bkx = 2mg. Determine the natural frequency of oscillation , the system eppective mass position and the System equilibrium
system with m=20, c = 17 Suppose that the mass in a mass-spring-dashpot and k = 3 is set in motion with x(0) = 0 and x'(0) = 8. (a) Find the position function x(t) and show that its graph looks as indicated in the figure. (b) Find how far the mass moves to the right before starting back toward the origin. 3 5 160 (a) x(t) = 7 (Type an exact answer.) 160 7 300 (b) The mass moves 7.1344 units to the right before turning back. (Round to four decimal places as needed.) 0 10 20 30 40 50
Mechanical vibrations