Note: assume ideal op-amp behaviors for Problems 1-4. Which of the following op-amp circuits can be considered to have negative feedback. For those that have negative feedback, write down Vinvand Vout. You may assume the op-amps are powered by +9V. a) Vin c) +1.2V Vout Vout b) d) Vin Vin +1.2V out Vout

Note: assume ideal op-amp behaviors for Problems 1-4. Which of the following op-amp circuits can be considered to have negative feedback. For those that have negative feedback, write down Vinvand Vout. You may assume the op-amps are powered by +9V. a) Vin c) +1.2V Vout Vout b) d) Vin Vin +1.2V out Vout

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q.3 (a) Figure Q. 3(a) shows a basic op amp circuit. (i) State current and voltage assumptions that are used to analyse the op amp circuit. (ii) Explain the function of +Vcc and -Vcc in the linear op amp operation. (iii) Give one advantage of using op amp compared to a single BJT transistor in amplifier circuit. +Vc V+ I- Vo V- - Vec Figure Q. 3(a) SITI NOLOC
Choose the correct answer. *Please answer it ASAP if you can*
Figure 6 (a) shows the circuit diagram for a differential amphfier. You may assume that M and M, have identical parameters. Referring to Figure 6 (a): (a) What kind of amplifier is it? What is its role in a three-stage op amp? Draw the small signal equivalent eircuit and derive the differential voltage gain Aag. For the analysis consider RDI RD2 >>Rp State any assumption. (b) RD. gml gm gm, and r re=r What is the new Adr in the circuit of Figure 6 (b), where a PMOS current source has replaced the two drain resistors Ror R Rp and a NMOS current sink has replaced the source resistor Rs? (c) What are the advantages in using the circuit of Figure 6 (b) instead of Figure 6 (a) to realize an op amp? (d) Ven Ms Mg Rp1 Rpa Vo HM, My M Ma M3 Vss 0 V Vss 0 V Figure 6(b) Figure 6 (a)
11)This multiple choice question from MEASUREMENTS INSTRUMENTATIONS course.
Choose the correct answer. *Please answer it ASAP if you can*
Q2. Distinguish between an Inverting and Non-inverting op-amp.
+Vcc Vin VI Vo Vref VN -Vcc Ry RxL Figure Q.A2(e). Inverting Schmitt-trigger circuit. (ii) The operational-amplifier (op-amp) of the inverting Schmitt-trigger in Figure Q.A2(e) has saturation voltages of +Vsat = +11 V and -Vsat = -11 V. The voltage divider circuit has the relationship of Rx = 2RY with the value of RY being 100 kn. Using the relationships derived above: (a) Calculate the values of the upper threshold point (UTP or Vi*), lower threshold point (LTP or Vr). (b) Now, sketch the input-output characteristic of the inverting Schmitt- trigger. Clearly label axes, the threshold voltages and the saturation voltages in your sketch.
3A Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is connected to the non-inverting input of the first op-amp. Both the 2nd and 3rd op-amps operates as inverting amplifiers. All feedback resistors are 420 KOhms while the input resistances are 71.4kOhms, 19.1kOhms, and 14KOhms respectively. 3H Determine the total gain of the circuit in Problem No. 1 (P1) a.792.105 b.9000 c.792 V d.792
Given the four statements, which of the following statements are not true about the operation of an op-amp? i. Op-amp's close loop operation employs negative feedback that takes portion of the output and applies it back out of phase with the input. 1i. In an op-amp, amplification of the common input signals is much less than that of the opposite input signals. iii. In open-loop operation, the output of the op-amp is driven to saturation with Vo- +Vsat. iv. Op-amp's close loop operation employs positive feedback that takes portion of the output and applies it back out of phase with the input. O i, iii, iv O i, iv O i i, ii O i, iv
An inverting op-amp circuit has a voltage gain of 10 and a source resistance of 5k. What is the value of the feedback resistors? Note: Enter numeric answer only ohms
A. Design an Op-Amp based electronic circuit that can produce a uniform square waveform with peak values of 10V in positive and -10V in negative if the input signal is Vin = sin2nt?
please do question 2 and 3