need a clear answer by hand, not by keyboard and fast answer within 20 minutes. Thank you | dybala For the beam loaded as shown, draw shear force bending moment diagrams, and find the maximum bending stress and maximum shearing stress. IN.A-1.96 10mm' 9 20 ܤܛܒܝܐ 218/w 4KN 3kN.m 3kN/m

Q: (Problem 3.8 from the text book) The solid spindle AB has a diameter ds = 1.5 in. and is made of a…

A:

Q: Calculate the stress in each segment

A: Segment AB Reaction at C = 9.65 +12.32 - 4.45 = 17.52 kN (Right Side) Force acting on the portion AB…

Q: The center of gravity of the 800N highway sign is at point G. It has been determined that it can…

A:

Q: Ah G Av E 60° 49 30 Bh B x F x D x •METHOD OF JOINTS 20 N Tabulation of forces from Method of…

A:

Q: I section steel profile is not symmetrical as shown. If the tensile stress on the upper side of the…

A:

Q: Determine the bolt diameter if the shear stress is 150 MPa and the bearing stress is 337.50 MPa.

A: The values and diagram given in the question are as follows: Shear stress(t)=150 MPa Bearing…

Q: 5ft B 1.5ft The AB bar, whose material is Copper Hard Drawn, and the BC bar, whose material is 6061…

A: Length of copper bar, length of the aluminum bar, area of each bar,

Q: A 1.5" high by 2" wide rectangular bar is attached to a channel section by 3/8" diameter mach screws…

A:

Q: write the equation for shear that you need to estimate the shear's magnitude at D. Estimate the…

A:

Q: Problem 2: For the beam shown, determine the maximum tensile and compressive bending stress. 10 ft…

A: Cantilever beam is given. We need to calculate maximum tensile and compressive bending stress

Q: Per missible As in section to ensure tensile Compute the design strength of beam shown if fy = 420…

A: To find : design strength

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.