Name: 18. What is the total area of gross exposed walls of the provided house drawing? NOTE 1: The wall height for all rooms is 8 feet. NOTE 2: When calculating heat gain and loss for the provided drawing, Round U factor 3 decimals NOTE 3: For each window, door or surface area, round off square feet to the nearest whole number. 个N_ 2′8 X 4'0 2'8 X 4'0 Answer Room 3 10' X8' 50 X 60 Room 4 22' X16' Room 2 18' X14' 5'0 X 6'0 2'8 X 6'8" 3'0 X 6'8" Room 5 26' X20' Room 1 30' X18' Room 6 8' X8' 5'0 X 6'0 2'8 X 4'0 0,9 X 0.5

Q: Name: 4. What is the total area of windows located on the South side of the of the provided house…

A: To find the total window area of the south side of the provided house drawing.From the drawing, the…

Q: water flow by an angle 0 = 45° from the flow direction while accelerating it. The elbow the inlet…

A: To Determine What is the magnitude of the resultant force in the x direction FRx  What is the value…

Q: Question 4 a) Determine the rise in water level h as a result of surface tension between two glass…

A:

Q: Locate the centroid y of the shaded area. y 100 mm -100 mm- y=x

A: fig is given equation of curve lineFINDlocate the centroid of the shaded area

Q: ame: 3. Find the total glass area of the North side of the provided house drawing? NOTE 1: The wall…

A: To find the total glass area of the north side of the provided house drawing.From the drawing, the…

Q: A base line was measured in four lengths giving 30.126, 29.973, 30.066, and 22.536 m. The…

A:

Q: A tape 30 m long, 0.6 cm wide and 0.5 mm thick was used to measure a distance of -1000 m at a…

A:

Q: A 200m x 300m building is to be laid out in a sloping ground. A height of 3.45m is measured along…

A:

Q: What is the outside perimeter length, centerline perimeter length of the walls and the area (to…

A: To determine:Outside perimeter lengthCenterline perimeter length of the wallsArea (to outside of…

Q: Question #12 Determine the centerline length_{wall is 600 mm thick, Ø=20800 not R) 7600 7400 |-…

A: thickness of wall, t = 600mm Diameter of semicircle, ∅ = 20800mm

Q: 1. Fire resistant ratings for buildings are seen in units of: a. Degrees Fahrenheit b. Material…

A: Using definition of rating of fire resistant building

Q: This is a multi-part question. Once an answer is submitted, you will be unable to return to this…

A:

Q: Niebel's Methods, Standards, and Work Design by Freivalds, Andris   What is the luminance of a…

A: Given data,  Reflection of surface= 50%  Illumination= 4 fc = 4 foot candle Luminance = ?  Luminance…

Q: boater considers dropping the motor Into the water to create waves , describe the resulting of the…

A: The phenomenon of motion is when an object changes its position over time. Displacement, distance,…

Q: A tape 30 m long, 0.6 cm wide and 0.5 mm thick was used to measure a distance of -1000 m at a…

A:

Temperature Difference and Heat Transfer

Whenever there is a flow of heat flux resulting from a temperature gradient within the material or between two materials, there is heat transfer. Heat transfer primarily arises due to temperature differences between two bodies or within bodies. The term temperature gradient denotes temperature differences or variation of temperature due to change in some quantity. The fundamental use of the concept of temperature is found in the zeroth law of thermodynamics.