n Dean applies a current to a molten mixture of ZnCl₂, PbF₂, and MgI₂, the cations Zn²+, Pb²+, and Mg²+ all compete for ction at the cathode. nge the cations present in the mixture from most to least favorably reduced. Most favorable reduction

Q: The instructor reveals that the weak acid is hypochlorous acid, HOCl. The known Ka for HOCl is…

A:

Q: It takes 27 microliters of solution to produce a spot with a 1.2 cm diameter. If the Cu(NO3 )2…

A: This is an example of paper chromatography. Given, It takes 27 microliters of solution to produce a…

Q: 55. Volume of Titram (ml) 24.70 24.80 24.90 25.00 25.10 25.20 25.30 Potential (mV) (A) 24.96 mL (B)…

A: Given is a table of potential vs volume.To find the volume of the titrant needed to reach the…

Q: Use the following concentrations to calculate your experimental Ksp value for Ca(OH) 2 [Ca^ 2+…

A: We have to calculate the solubility product for Ca(OH)2

Q: Based on the analysis of a vinegar solution via titration with 0.1 M NaOH. Results are as follows:…

A: According to the mole concept, in terms of mass, the amount of substance in moles is equal to the…

Q: You begin preparation of the calibration curve to measure absorbance vs concentration of FeSCN²+. To…

A: The objective of this question is to calculate the resulting concentration of FeSCN2+ after the…

Q: Opioid dependence is described in the Australian Medicines Handbook as a chronic frequently…

A: Here we have to predict the frug A and B from the list .

Q: If a red blood cell is placed into a solution with a low concentration of salt, what type of…

A:

Q: The density of water varies with temperature.       T / oC            Density / g mL–1       19.00…

A: Linear interpolation is a method of curve fitting used to estimate the value of a function for an…

Q: pka E

A:

Q: a dilution is needed to prepare a standard of 10 mg Zn/L from 0.5g Zn/L. To carry out the dilution…

A: We will discuss which bulb pipette and which corresponding volumetric flask you would choose to…

Q: We leached 200 g of our soil with 500 mL of NH4CI. The collected solution contained: 320 mg L-1 Ca2+…

A:

Q: O Macmillan Learning A chemist needs to create a series of standard Cu² (aq) solutions for an…

A: Molarity of the Cu+2 stock solution= 2.71 M Dilution formula isM₁V₁ = M₂V₂where M₁ and V₁ represent…

Q: What is the mass in grams of NaCN in 120.0 mL of a 2.40 x 10s M solution?

A: Mass of NaCN = ? Molar Mass of NaCN = 49 g mol-1 Molarity of NaCN = 2.40 × 10-5 M…

Q: The following experimental data was collected by a student: 0.0020 M Fe(NO3)3 mL Trial 1 2 3 4 Blank…

A:

Q: The pH of a solution is 6.10 + 0.03. What is the concentration of H* in the solution and its…

A:

Q: Use your average AA concentration to calculate the mass percent of acetic acid in vinegar.

A: Mass percent = Mass of soluteMass of sample×100 Here solute is acetic acid and the sample is…

Q: Es specific conductance?

A:

Q: Plate F 1 2 3 4 5 6

A: This is a paper chromatography  Paper chromatography is a simple and widely used technique for…

Q: The analysis shows different concentrations based on replicate determinations of Zn in a water…

A: Absolute error is the difference between the measured value and actual value. Its modulus i.e.…

Q: The pH of a solution is 6.70 ± 0.02. What is the concentration of H* in the solution and its…

A:

Q: You begin preparation of the calibration curve to measure absorbance vs concentration of FeSCN2+. To…

A: Molarity is the way of expressing concentrations which is defined as moles of solute dissolved per…

Q: .. We want to determine the purity of alum sample bought in a local pharmacy in Miagao. A Chem 28…

A: A numerical problem based on quantitative analysis, which is to be accomplished.

Q: QUESTION 10 A student combined two colorless chemical compounds in a test tube. Immediately a yellow…

A: When two chemical are mixed with each other they will react with each other and a new substance is…

Q: Which analytical separation technique is suitable to separate dissolved heavy metals from rivers.…

A: Water consists of many impurities.  But particulate matter and the heavy metals are very poisonous…

Q: (b) 3Zn(s) + 2Cr³+ (aq) = 3Zn²*(aq) + 2Cr(s) where [Cr³+] = 0.020 M and [Zn²+] = 0.0065 M 0 E E AG=

A: Given-> [Cr3+] = 0.020 M [Zn2+] = 0.0065 M

Q: The Ksp of magnesium hydroxide is 1.7x10-11. If 5.0 grams of the solid are placed into a flask…

A: The objective of this question is to determine how much of the magnesium hydroxide will dissolve in…

Q: (b) Shown below are three different van Deemter curves for particles of varying sizes. Propose…

A: Van Deemter equation: It describes various factors that affect H/HETP (height equivalent theoretical…

Q: Volumetric Target concentration Mass of mixture Amount of ammonia flask added required 0.43 gl)…

A:

Q: Stock or starting Serial dilutions done Total dilution factor Final concentration concentration…

A: For first we are provided starting concentration and total dilution factor. We are required to find…

Q: A solution of FESCN2+ has a concentration of 1.00 x 10-4M and an absorbance of 0.755. What is the…

A: Given, A1 = 0.755 A2 = 0.491 C1 = 1 X 10-2 C2 = ? To calculate C2.

Q: When a Vitamin C (ascorbic acid; MM = 176.12 g mol-1) tablet is crushed, dissolved and titrated with…

A: The number of moles of I2 is used to get the endpoint of the titration is determined as follows.…

Q: The pH of a solution is 5.30 + 0.01. What is the concentration of H* in the solution and its…

A: Given data is as follows: The pH of the solution =5.30±0.01 As we know that; pH=-logH+ The hydronium…

Q: The pH of a solution is 5.84 + 0.05. What is the concentration of H* in the solution and its…

A: From given datas  Molar concentration of H+ and absolute uncertainty is calculated with suitable…

Q: If the pH of a solution is 2.78 with an absolute uncertainty of ±0.05, what is the [H+] and its…

A:

Q: Starting from the primary standard solution in Question 4 and using the dilution scheme in Figure 1,…

A: The amount of solute that is dissolved in a specified volume of a solvent yields a solution. The…

Q: Given: Volume of Ca(OH)2 (mL) Initial burette reading (mL) Final burette reading (mL) Volume of HCl…

A: This question belongs to the titration of Ca(OH)2 and HCl.  3 trials are done and volume is…

Q: The fictitious salt MX₂ has a Ksp of 5.0 x 10-10. If 19.1 mL of a 0.0010 M solution of M2+ and 15.0…

A: Answer: For a sparingly soluble salt it is considered that all its dissolved part its in ionized…

Q: solution will be diluted to create 5 standard solutions: Volume of FeSCN2+ Stock Solution (mL) 0.00…

A: Reaction involved:         Fe3+ (aq)        +      SCN- (aq) <------> FeSCN2+ (aq)    from…

Q: A stock solution of 0.225 +/- 0.003 M NaNO2 was transferred to a 100 mL volumetric flask (class A)…

A: Given that, Concentration of stock NaNO2 = 0.225 ± 0.003M 7 ml of stock NaNO2 is added to 100 mL…

Q: Tyler the titrating student did not rinse his buret properly and residual water (not titrant) was…

A: The closeness of a measured value towards accepted or correct value is defined as accuracy. The…

Q: Write a step-by-step procedure for this serial dilution. The stock concentration of the blue dye…

A:

Q: a dilution is needed to prepare a standard of 10 mg Zn/L from 0.5g Zn/L. To carry out the dilution…

A: a) Concentration of stock solution, C1 = 0.5 g Zn/l Concentration of standard solution, C2 = 10 mg…