Multiple concept problem: A bike wheel having a moment of inertia of 0.09 kg-m2 has an initial angular speed of 3 rev/s and gradually comes to rest due to a frictional force. The frictional force is caused by a torque of 1.0 N-m. Assuming the angular deceleration remains constant during the entire period, determine how much time it would require for the wheel to come to a stop.

Multiple concept problem: A bike wheel having a moment of inertia of 0.09 kg-m2 has an initial angular speed of 3 rev/s and gradually comes to rest due to a frictional force. The frictional force is caused by a torque of 1.0 N-m. Assuming the angular deceleration remains constant during the entire period, determine how much time it would require for the wheel to come to a stop.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A discus thrower moves the discus in 2.30 complete revolutions about his body in 1.32 s (starting from rest). The radius of the circular path of the discus is 0.900 m, and the mass of the discus is 2.00 kg. Assume that a constant torque is applied to the discus by the athlete. A) What is the angular speed of the discus just before release? in rad/s B) What torque does the athlete apply to move the discus about his body? in N*m C) Approximately how far from the athlete does the discus land if it is released at a 45.0° angle to the horizontal until it returns to the same height as it was released? in m
During a drive by golfer Brooke Henderson, the angular velocity of her club is zero at the top of the backswing and 1620 deg/s at the bottom of the downswing just before impact with the ball. b) If the downswing lasts 0.32 s, what is the average angular acceleration of the club during the downswing in deg/s2? B) What is the average angular acceleration of the club during the same downswing in rad/s2?
A wheel starts from rest and rotates with constant angular acceleration to reach an angular speed of 11.9 rad/s in 3.10 s. (a) Find the magnitude of the angular acceleration of the wheel. rad/s2(b) Find the angle in radians through which it rotates in this time interval. rad
A student holds a bike wheel and starts it spinning with an initial angular speed of 9.0 rotations per second. The wheel is subject to some friction, so it gradually slows down. In the 10.0 s period following the inital spin, the bike wheel undergoes 77.5 complete rotations. Assuming the frictional torque remains constant, how much more time At, will it take the bike wheel to come to a complete stop? Ats = S The bike wheel has a mass of 0.825 kg and a radius of 0.315 m. If all the mass of the wheel is assumed to be located on the rim, find the magnitude of the frictional torque 7† that was acting on the spinning wheel. N- m
Suppose a yo-yo has a center shaft that has a 0.290 cm radius and that its string is being pulled. (a) If the string is stationary and the yo-yo accelerates away from it at a rate of 1.70 m/s?, what is the angular acceleration of the yo-yo in rad/s?? |rad/s² (b) What is the angular velocity in rad/s after 0.750 s if it starts from rest? rad/s (c) The outside radius of the yo-yo is 3.60 cm. What is the tangential acceleration in m/s? of a point on its edge? |m/s²
A wheel, starting from rest, has a constant angular acceleration of 0.5 rad/s2. In a 2.9-s interval, it turns through an angle of 84 rad. How long has the wheel been in motion at the start of this 2.9-s interval? Needs Complete typed solution with 100 % accuracy.
A spinning wheel steadily slows from an initial angular velocity of 1.60 rev/s to 0.490 rev/s in 10.2 s. (a) Calculate the wheel's angular acceleration in radians per second squared. 0.562 rad/s² (b) What angle does it go through during that time? rad
In order to move the rectangular stones which built the pyramids the ancient Egyptians used a system of cylindrical logs placed close to each other on the ground which rolled along (without slipping) as the stone on top was pulled by slaves (it also did not slip). If the radii of the logs were all 19 cm and their maximum angular velocity about their axis was 7 radians per second, what was the maximum linear speed (in m/s) of the pyramid stones
An ultracentrifuge accelerates from rest to 100,000 rpm in 2.50 min. (a) What is its angular acceleration in rad/s2? rad/s2 (b) What is the tangential acceleration (in m/s2) of a point 10.00 cm from the axis of rotation? m/s2 (c) What is the radial acceleration in m/s2 and multiples of g of this point at full rpm? a in m/s m/s2a as a multiple of g g
Cyclist! A cyclist starts from rest and pedals such that the wheels of his bike have a constant angular acceleration. After 14 s, the wheels have made 48 rev. What is the angular velocity of the wheels after 14 s in rad/s ? rad/s Submit Answer Tries 0/2 What is the angular acceleration of the wheels in rad/s² ? rad/s² Submit Answer Tries 0/2 If the radius of the wheel is 37 cm, and the wheel rolls without slipping, how far has the cyclist (in m) traveled in 14 s? m Submit Answer Tries 0/2
A circular disk has a rotational inertia of 1.4 kg.m? and a constant angular acceleration of 4.4 rad/s2. If it starts from rest the work done during the first 8.1 s by the net torque acting on it is:
Suppose a yo-yo has a center shaft that has a 0.260 cm radius and that its string is being pulled. (a) If the string is stationary and the yo-yo accelerates away from it at a rate of 1.70 m/s2, what is the angular acceleration of the yo-yo in rad/s2? rad/s2 (b) What is the angular velocity in rad/s after 0.750 s if it starts from rest? rad/s (c) The outside radius of the yo-yo is 3.40 cm. What is the tangential acceleration in m/s2 of a point on its edge? m/s2