Modern commercial airliners are largely made of aluminum, a light and strong metal. But the fact that aluminum is cheap enough that airplanes can be made out of it is a bit of historical luck. Before the discovery of the Hall-Héroult process in 1886, aluminum was as rare and expensive as gold. What would happen if airplanes had to be made of steel? The fuselage of the Boeing 747, which can carry 400 passengers, is approximately a hollow aluminum cylinder without ends, 70.7 m long, 6.5 m wide, and 2.5 mm thick see sketch at right). The fuselage of an airplane Suppose this fuselage was made of steel (density 7.87 g/cm³) instead of aluminum (density 2.70 g/cm³), and let's say the average passenger has a mass of 79 kg. We'll also assume the engines can't lift any greater mass than they already do. Calculate the number of passengers that the Boeing 747 could carry if its fuselage was made of steel. 0 X S

Modern commercial airliners are largely made of aluminum, a light and strong metal. But the fact that aluminum is cheap enough that airplanes can be made out of it is a bit of historical luck. Before the discovery of the Hall-Héroult process in 1886, aluminum was as rare and expensive as gold. What would happen if airplanes had to be made of steel? The fuselage of the Boeing 747, which can carry 400 passengers, is approximately a hollow aluminum cylinder without ends, 70.7 m long, 6.5 m wide, and 2.5 mm thick see sketch at right). The fuselage of an airplane Suppose this fuselage was made of steel (density 7.87 g/cm³) instead of aluminum (density 2.70 g/cm³), and let's say the average passenger has a mass of 79 kg. We'll also assume the engines can't lift any greater mass than they already do. Calculate the number of passengers that the Boeing 747 could carry if its fuselage was made of steel. 0 X S

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: A 80-kg man stands at the left end of a 20-kg, 7.0-m-long uniform wooden plank. The plank is sitting…

Q: In the figure below, a uniform plank, with a length L of 6.20 m and a weight of 460 N, rests on the…

A: The coefficient of static friction between the plank and the ground. given,angle of…

Q: A board sits in equilibrium. On the left end, there is a wire that supports the board from the…

Q: When using a ladder, it is important to place it against a wall at a safe angle. A ladder could tip…

A: For safe angle, the ratio of working length to distance away from wall = 4:1 To find; Value of safe…

Q: In the figure, a lead brick rests horizontally on cylinders A and B. The areas of the top faces of…

Q: 6. The Earth has a mass of 5.97 * 1044 kg and the Sun has a mass of 2.00 * 1030 kg. If they are…

A: Given value--- mass of earth = 5.97 × 1024 kg. mass of sun = 2 × 1030 kg. separation = 1.5 × 108…

Q: Two cylindrical rods, AC made of aluminum and CD made of steel, are joined at C and restrained by…

A: The objective of this question is to determine the deflection of point C in a system of two…

Q: A device used for mixing consists of three identical thin rods extending from a central axle, all in…

Q: A board that is a meter long is held up at the 26.0 cm mark. the board is equilibrium when a 0.26 kg…

Q: A 39.4 g mouse has gotten into a peculiar situation. Somehow, the mouse has found itself hanging off…

Q: A board sits in equilibrium. On the left end, there is a wire that supports the board from the…

Q: A 2×12 board is about 2.18 kg per linear foot. A 16-foot length board of Southern Yellow Pine is…

A: Given: Length density of the board: 2.18 kg per linear foot. The length of the board: 16 feet=4.88…

Q: In the figure, a lead brick rests horizontally on cylinders A and B. The areas of the top faces of…

A: Given that: AA=2.3ABEA=1.8EBLet the weight of the brick is W.

Q: A wooden plank (3 m long) is supported at each end by two support beams. The plank has a mass of 55…

Q: A tire, which is mounted on a car, has a radius of 0.23m0.23m. A nail with a mass of 11.4g11.4g is…

Q: A playground merry-go-round has a disk-shaped platform that rotates with negligible friction about a…

A: Angular motion is one in which a body will rotate around an axis. As in linear motion velocity of a…

Q: What is the position, along this line, of the CM of this system? Assume the cubes are made of the…

A: Given the center of mass of first cube x1 =0.5 lo the center of mass of second cube x2 = 2lo the…

Q: A uniform 10.0 m beam of mass 300 kg extends over a ledge, as in Figure. The beam is not attached…

A: A uniform beam of length and massextends over the ledge. The beam is not attached but rests over the…

Q: For the cantilever beam and the loads shown in the figure, determine the slope and deflection at the…

A: Step 1: Calculate the Moment at Point B Given that M=PL, where P is the load at the free end, we…

Q: tires need to be strong for a reason. Suppose the tread on a tire with a radius of 40cm has a mass…

Q: Countries with excellent wind energy sources decide on national projects for the development of wind…

A: Figure 10.18 (ideal) provides the average crosswind distance and wind turbine spacing. As a function…

Q: cat is balanced on the edge of a see-saw. The plank of the see-saw is 1m long, and the wedge is…

Q: 4 spheres, each of diameter D = 0.05 m (spheres are identified as 1, 2, 3, 4), are placed on the end…

A: The rigid assembly is pivoted without friction about the axis O. Sphere 1 has covered with the…

Q: A medical technician uses a pair of 0.125m long tweezers to remove a wood sliver from a patient. The…

A: What is the mechanical advantage?

Q: A solid uniform 45-kg ball of diameter 32.0 cm is supported against a vertical, frictionless wall…

Question

Modern commercial airliners are largely made of aluminum, a light and strong
metal. But the fact that aluminum is cheap enough that airplanes can be made out
of it is a bit of historical luck. Before the discovery of the Hall-Héroult process in
1886, aluminum was as rare and expensive as gold. What would happen if airplanes
had to be made of steel?
The fuselage of the Boeing 747, which can carry 400 passengers, is approximately a
hollow aluminum cylinder without ends, 70.7 m long, 6.5 m wide, and 2.5 mm thick
(see sketch at right).
The fuselage of an airplane
Suppose this fuselage was made of steel (density 7.87 g/cm³) instead of aluminum (density 2.70 g/cm³), and let's say the average passenger has a mass of
79 kg. We'll also assume the engines can't lift any greater mass than they already do.
Calculate the number of passengers that the Boeing 747 could carry if its fuselage was made of steel.
0
X

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A ruler with the length of 100 cm and mass of 100g has the pivot point at 35 Cm. Jason suspends an object at 10 cm mark and the system stayed balanced. What is the object mass in grams?
Find the cross product →A × →C for (a) A = 2.0 ^i − 4.0 ^j + ^k and C = 3.0 ^i + 4.0 ^j + 10.0 ^k (b) A = 3.0 ^i + 4.0 ^j + 10.0 ^k and →C = 2.0 ^i − 4.0 ^j + ^k (c) A = −3.0 ^i − 4.0 ^j and →C = −3.0 ^i + 4.0 ^j (d ) →C = −2.0 ^i + 3.0 ^j + 2.0 ^k and A = −9.0 ^j Answer a and b
On a part-time job, you are asked to bring a cylindrical iron rod of density 7800 kg/m^3, length 89.2 cm and diameter 2.45 cm from a storage room to a machinist. Calculate the weight of the rod, w. Assume the free-fall acceleration is g = 9.80 m/s^2. Express you answer in N.
400 4 The amount of mass shown on the triple beam riders is – F 401.4 g G 404.5 g H 414.5 g J 444.5 g cm 0 2 3 4 6. 7 8 9 10 11 12 13 14 15 What is the length of the metal rod? A 7.0 cm B 7.5 cm C 8.0 cm D 8.5 cm
mass in a physics experiment, a metal bar is balanced on a fulcrum. A 5.0 kg. is placed on the bar, 45.0 cm from the fulcrum, and on the same side a 2.0 kq mass is placed an unmeasured distance away from the fulcrum. Another mass (12 kq) is placed on the other side of the fulcrum, 50.0 cm away. away How far fulcrum! is the 2.0 kg mass from the 45.0cm 50.0 cm 5.0kg 2.0kg 12 kg
let's consider the three atoms composing the molecule have different masses and coordinate, while the axis of rotation is still y-axis. The first atom has a mass of 8.61 kg, with x coordinate at 3.063 m and y coordinate at 3.826 m. The second atom has a mass of 63.048 kg, with x coordinate at 87.738 m and y coordinate at 51.326 m. The third atom has a mass of 26.317 kg, with x coordinate at 42.334 m and y coordinate at 23.115 m. What is the moment of inertia in the unit of kg m2 with respect to the y axis?
The 600-kg uniform I-beam supports the load shown. Determine the reactions at the supports. Answers: Ax Ay = = By = p -7.5 m- +4.5 m 285 kg N N N B
45° Tz T2 T. A cat burglar is planning a daring heist. He will lower himself from a beam as shown in the figure on the left. The burglar weighs 150 lbs. He plans to use a long rope that can withstand a tension of 100 lbs to suspend himself from a shorter rope, reasoning that each segment of the longer rope will only need to support half his weight. (The short rope segment is Kevlar and can easily support the burglar's full weight.) (a) Despite your moral outrage, you decide to set the burglar straight. Compute the tensions T1, T2, and T3 and explain why the plan will not work. (b) As a strictly intellectual exercise, you design an alternative arrangement of ropes that will support the burglar's weight using the same long rope from part (a). In the configuration on the right, what is the maximum angle 0 that will result in a tension of less than 100 lbs in each segment of rope? You may ignore the mass of the rope in parts (a) and (b).
The crew on peg leg Petes' ship have mutinied. Now Pete finds himself walking the plank. The plank is 4.5m long and has a mass of 13kg. 3.6 meters of the plank extend out over the waters. The plank pivots on a small rail at the edge of the ship, this is the only point of the plank in direct contact with the ship. The remaining meter of the plank is held in place over the deck by the metal bar. The bar is .6m from the pivot. If Pete has a mass of 111kg, what is the torque provided by the bar when Pete is at the end of the plank?