Methane fuel is burned with air in a boiler system. Temperature and pressure values of combustion environment of air and fuel of the inlet are 25C and latm respectively, the thermal efficiency of the boiler is 60%. Calculate the flue gas temperature value of the boiler with given. Given: METHANEAD = 50000 kJ / kg Excess air coefficient = 1.4 All reacts and products are perfect gases.

Methane fuel is burned with air in a boiler system. Temperature and pressure values of combustion environment of air and fuel of the inlet are 25C and latm respectively, the thermal efficiency of the boiler is 60%. Calculate the flue gas temperature value of the boiler with given. Given: METHANEAD = 50000 kJ / kg Excess air coefficient = 1.4 All reacts and products are perfect gases.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A damped harmonic oscillator with m = 10 kg, k = 250 N/m, and c = 6 driving force given by F, cos…

A: Calculate the angular frequency of the system. ω0=km Here, m is the mass of the oscillator and k is…

Q: how do you apply the 80 percent of the exceeded air to the combustion equation, as there is a ratio…

A: The solution for the problem provided previously is attached below.

Q: An SI engine operating on stoichiometric propane fuel burns 0.00005 kg of fuel in each cylinder…

Q: Consider an ideal Hampson-Linde cycle in which no heat is lost to the environment. Use the data in…

A: The Linde-Hampson cycle, is a type of refrigeration cycle that allows gases to reach very low…

Q: 576rty

A: First, we need to write down the stoichiometric equation for the combustion of propylene (C3H6) with…

Q: Define the Exergy Destroyed During Stirring of a Gas.

A: Exergy has been a primary tool under the second law of thermodynamics. Exergy efficiency becomes…

Q: The "typical" coal in Example 7.10 is being burned under the conditions in that example, a rate of…

A: Given Flow rate = 1000 kg/hr Temperature = 400 F To find Flow rate in scfm Flow rate in acfm

Q: A- Draw a common diagram of exhaust heat reuse stages in: Economizer, R. H, S.H. B- What is the…

A: A- Economizer- An economizer is a mechanical device that reduces energy consumption by acting as a…

Q: Describe what is done in the combustion process in the combustion chamber of a gas turbine to…

A: The compression system of a gas turbine engine feeds high-pressure air to the combustor or…

Q: (b) Is the 0.03 lb/10° Btu rule more or less restrictive than the 1 percent emission rule?

A: As shown in Table 3.1, there are two cases: (1) the plant began operations on September 18, 1978,…

Question

100%

Methane fuel is burned with air in a boiler system. Temperature and pressure values of combustion
environment of air and fuel of the inlet are 25C and latm respectively, the thermal efficiency of the
boiler is 60%.
Calculate the flue gas temperature value of the boiler with given.
Given:
METHANEAID = 50000 kJ / kg
Excess air coefficient = 1.4
All reacts and products are perfect gases.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A reheater cycle with two stages of reheating is executed with steam expandinginitially from 20.547 Mpa and 540 oC. The pressures of two reheaters are 3.2547 Mpaand 0.85547 Mpa, and the steam leaves each reheater at 540oC. Condensation occurs at 70oC. Calculate W, ec and ee. Put state 1, 2 and so on, the cycle analysis. Make it clear format.
Methane fuel is burned with air in a boiler system (open system). For this system, the HFK value for the air supplied to the combustion environment is 1.4. If the temperature and pressure of the air and fuel entering the combustion environment is 25 ° C and 1atm, we calculate the flue gas temperature value of the boiler, assuming that the boiler's thermal efficiency is 60%. All reacting species and reaction products are perfect gases. There is no water condensation in the products. METANAID = 50000 kJ / kg HFK = Air excess coefficient All reacting species and reaction products are excellent gas. Products "no water condensation.
Example 2: Consider constant pressure complete combustion of stoichiometric liquid octane-air and octane air with 10% excess air mixture initially at 298K and 1 atm. Compare the adiabatic flame temperature vlaues.
a f Hydrogen is used as a is burned with stoichiometeric chemical reaction equention. He Calculate : 22 and A/F + a-Fuel-air-(fuel-oxygen) ratio: b- Equivalence ratio act 4.2_ in an experimental engine c oxygen. Write the balanced as .26 - XH12+ Ats=1
Solve the given problem
1. Propylene C3H6, is burned with 150 % theoretical air in a steady state combustion chamber at constant pressure. Reactants enter the combustion chamber at reference temperature and pressure at Po, To. Find the adiabatic flame temperature?
8. Write short notes on the following : (a) Optimal stage pressure ratio on reciprocating compressor (b) Effect of inter-cooling on reciprocating compressor. Liquid octane at 25°C is burned with 350% theoretical air at 25°C in a steady-flow process. Determine the adiabatic flame temperature. Take enthalpy of formation, P, of liquid Octane, CO, and H,0 are – 250105, – 393522, – 241826 kJ/kmol respectively. TК) дСо, (kJkmol) ДhН,О (kJkmol) AhO, (kJ/kmol) AN, (kJ/kmol) 900 28030 21892 19249 18222 1000 33400 25956 22710 21461
3) Isooctane (C,H8) is burned with air in an engine at an equivalence ratio of 0.833, find air-fuel ratio and write the balanced chemical reaction equation.
7 A four-cylinder, four-stroke SI engine, having a bore of 10 cm and stroke 9 cm runs at 4000 rpm. The fuel used has a carbon content of 84.50 per cent and hydrogen content of 15.50 per cent by weight. The volumetric efliciency of the engine at Tuế of full thrott l at 4041 lan is 0.85 referred to 300 K and 1 batue ve engine is to pplied we of air coeflicient 0.95 when finning at 75% of full throttle. Calculate the throat diaweter of the vent uri if the air velocity at broat is not to exceed 200 1 rate of fuel flicien kg/s at the pressure drop at venturi o 1at. Discharge coellicient for the venturi is 0,8 and the area ratio of the venturi s 0.8. Take R for air as 0.287 kJ/kg K and for luel vapour is 0.09 kJ/kg K. а mixture iender the above operating conditions. vealculate the lution
Consider the extraction of energy from the tail gases from a nitric acid adsorption tower, such as that described in Chapter 4, Example 4.4. Gas composition, kmol/h: 0₂ N₂ NO NO₂ H₂O 371.5 10,014.7 21.9 Trace saturated at 250°C If the gases leave the tower at 6 atm, 25°C, and are expanded to, say, 1.5 atm, calculate the turbine exit gas temperatures without preheat, and if the gases are preheated to 400°C with the reactor off-gas. Also, estimate the power recovered from the preheated gases.
Q3
Please answer this question ASAP! Thanks!