Methane (CH4) gas is to be compressed at 273 K from atmospheric pressure to 30 MN/m2 in a four stage compressor. Calculate the ideal intermediate pressures and the work required per mol of gas. Assume the compression is isentropic and gas behaves as an ideal gas.

Q: 50 grams of water at 20ºC is converted into steam at 250ºC at constant atmospheric pressure.…

A: The temperatures during the process are, The average temperature of steam is The specific heat of…

Q: An ideal gas at 27°C expands isothermally and reversibly from 10 to 1 bar against a pressure that is…

A: We need to calculate change in enthalpy (dH)

Q: FInd T, S, and V for steam and 10 atm with H=3240 kJ/kg

A:

Q: Consider filling a gas cylinder from with ethane from a high-pressure supply line as shown below.…

A: Write the given data. P=3 MPa=3×106 Pav=50 liters=0.05 m3Bethane'=-2.8×10-8R=319.3 J/kgK

Q: A rigid tank contains 7 kg of saturated vapor steam at 100°C. The steam is cooled to the ambient…

A: Given Data:Initial temperature of the saturated vapour steam, T1 = 100 C = 373 KFinal temperature of…

Q: Problem Derive enthalpy and entropy departure functions for a van der Waals fluid

A: The phase change from interactions between particles is predicted for the first time by this theory.…

Q: Oxygen enters an insulated 12-cm-diameter pipe with a velocity of 50 m/s. At the pipe entrance, the…

A:

Q: (That's the complete question an

A:

Q: 2 Hot Cold water water STATE DATA FOR SYSTEM di 210 3 T1 mm vi m/s °C 95 P1 1.0 bar d2 180 mm V2 m/s…

A:

Q: A car tire, which should normally be at 36 psia pressure, has 25 0,C 0.10 kg N2 gas at 32 psia…

A: Given data as per question Initial temperature = 250 c Initial mass = 0.10 kg Initial pressure = 32…

Q: One mole of an ideal monatomic gas, occupying 5 L at 3270 °C, is carried through a Carnot cycle. It…

A:

Q: For a process with 1500 kJ of heat transfered out of a system at an interface temperature of 300K,…

A: The heat transfer from the system, (QR)=-1500 kJThe interface temperature, (Ti)=300 KDetermine the…

Q: rature of the gas, you are asked to use various polytrophic compression process. Calculate the final…

A: Given:P1=100 KPaT1=30°C  =293 KP2=10 bar =1000 KPa NOTE: According to Bartleyby's policy we shall…

Q: A 50kg copper block is thrown into an isolated tank holding 80 L of water at a temperature of 75…

A:

Q: What is the temperature, in K, of the O2 in the final state?

A:

Q: a closed system contained a copper block of density 9.96g/cm3 at 25 degrees celsius in reversible…

A:

Q: CO2 gas enters the pipe at a flow rate of 2 kg / s, 3 MPa pressure and 500 K temperature. While the…

A: Given,Initial state of gas:P1=3MPa=3×106PaT1=500Km.=2 KgsFinal state of…

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.