force and bending moment for the beam shown Q3-A reinforced concrete column of 250mm x 250am cross section shown in Fig. (3) is designed to carry an axial compressive load of 400kN. Determine the required area or reinforcing steel if the allowable stresses are 8MPa for concrete and 150MPa for steel. Use Ee-14GPa and Est-2006Pa. 250mm 250mm Reinforcing Bars

Q: Q6. A simply-supported beam spans 10 m and is made from a 700WB150 steel section. A static vertical…

A:

Q: 3

A: Given:- factor of safety =1.6 force=100kips To find:- most economical option

Q: When solving the problems for Section 1.6, assume that the material behaves linearly elastically.…

A: Given data in question  Diameter  Elasticity modulus  Poissons ratio  To find out  Largest force P

Q: 40 mm Q9. A steel pipe and an aluminum pipe are securely bonded together to form the composite beam…

A:

Q: A W6 x 15 structural steel column is 24 ft tall and is fixed at its base and top. It is braced…

A: In construction, a steel column provides the essential support for vertical structures. It is…

Q: The collapse load for the beam as shown in figure is to G. 3. A. Mp 3. - L/2 L2 He L2

A:

Q: A composite shaft arrangement of brass and steel is shown below. The allowable shear stress are 100…

A: A composite shaft made of brass and steel.The diameter of the steel part is 80 mm.The diameter of…

Q: A steel beam is reinforced by three steel rods. The modulous of elasticity for concrete is 20Gpa and…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Q-5) A composite beam is subjected to a couple moment M-5kN m. Knowing that the modulus of…

A: Given:Required:Maximum bending stress at point A and B

Q: The round bar shown in the figure has steel, brass and aluminum sections. Axial loads are applied at…

A: Draw the FBD of each section such that each part is in equilibrium. Then using the definition of…

Q: A composite drive shaft is made up of two sections: a solid steel core and a brass tube encasing the…

A: A composite shaft made of brass and steel.The diameter of the steel part is 80 mm.The diameter of…

Q: 10

A: Given:- F.S.=1.6 To find:- most economical section

Q: Question 4 A 100mm diameter solid aluminium post is subjected to a bending moment of 2KNm, and a…

A:

Q: 9.18 A steel rodin. in diameter and 25 ft long is subjected to an axial tensile load of 15,000 lb.…

A: Given: Rod diameter, D = 3/4 in  Length of the bar, L = 25 ft Load, P = 15000 lb Take young's…

Q: A simply supported wood beam, reinforced with steel plates, has the cross section shown. The beam…

A:

MATLAB

MATLAB software is a registered trademark, multi-model programming language, and numerical computing environmental system created by MathWorks. 'MATLAB' is the short-form of "Matrix Laboratory". The MATLAB software permits the utilization of matrix operations, graphical representation of data, execution of algorithms, development of user interface, and linking programs created in other languages. Even though MATLAB is developed mainly for numerical computing, there is an optional toolbox that uses a symbolic engine known as MuPAD giving access to all the symbolic computing abilities. In addition to this, a Simulink package delivers graphical multi-domain simulation and design that is model-based for embedded and dynamic systems. MATLAB users are spread worldwide across the world and use MATLAB extensively.