Answered: measure the velocity of water. The…

measure the velocity of water. The differential manometer reading is 10 mm of liquid column with a relative density of 10 Assuming g

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A differential manometer is attached to two tanks, as shown in Fig. between chambers A and B.…

A: Given:Liquid 1=SAE 30 OIlLiquid 2 =carbon tetrachloride

Q: (Answer: m = 2.578 kg/s) 8) A venturi meter measures the flow of water in a 75 mm diameter pipe. The…

Q: An experiment to measure the viscosity of liquid using a funnel with a cylindrical reservoir

A: …

Q: A three-fluid system (immiscible) is connected to a vacuum pump. The specific gravity values of the…

A: The gauge pressure value of P1. Given: The specific weight of water is γw== 9.81 kN/m2. The specific…

Q: An orifice meter with orifice area 969 mm2 is inserted in a pipe of area 1938 mm2 The pressure…

A: Given data: The orifice area is ao=969 mm2=9.69×10-4 m2 The pipe area is ap=1938 mm2=19.38×10-4 m2…

Q: * For measuring flow by aventurimeter, if should be installed :in Inclined line. O Vertical line. O…

A: Option (e) : In any direction and in any location

Q: 10.Compute the pressure difference between 'm' and 'n' as shown by the differential manometer in KPa…

Q: Determine the specific gravity of the air in a room at p=6428.0 kPa absolute and 25°C. Given: The…

Q: A liquid (S.D. =2.8 is flowing in a 150mm diameter pipe. The total energy at a given point is found…

A: The horsepower. Given: The specific gravity of the fluid is SD=2.8. The density of the fluid is…

Q: isobaric non-flow heating process at a pressure of „P“ (= 95 × Reg. No.) kPa and temperature changes…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: 1 For pumps and turbines, mechanical efficiency is expressed as A. Power input/Fower output B. Power…

A: Answer: ◆ Question 1: The correct answer is option (B). ◆ Question 2: The correct answer is option…

Q: Q1 / B: 2. Convert the velocity of (2400 cm/min) to (Km/hr), since; Im =100 cm, 1Km=1000 m & 1hr-60…

A: Given, Velocity, V=2400 cm/min Since, 1m=100cm,1 km=1000m1 hr=60min Therefore, 1…

Q: Gasoline specific mass: 0,82 g/cm3 Diameter 1 = 150mm Diameter 2 = 100mm Calculate the volumetric…

A: Given that d1=150mmd2=100mmρgasoline=0.82g/cm3

Q: Figure shows the schematic representation for the measurement of velocity of air (density= 1.2…

Q: manometer attached to a pitot static tube used to measure air velocity shows a reading of 0.1 m.…

Q: Using the volume graph detemine the aproximate Vt 1. 250 ml 2. 500 ml 3. 750 ml 4. 1000 ml cm H₂O ml…

A: Given:The graphs are given below;

Q: 1. The deformation of the fluid will continue as long as the 2. When designing gates, vessels, dams…

A: As per our guidelines, we are supposed to answer only first three subparts in case of multiple…

Q: y aer. A Pitot tube is used to measure the air flow rate in a circular duct 8.5 m I.D. The "riowing…

Q: Find the difference in pressure head and velocity of flow of an oil through a pipe, when the…

Q: Determine the height of an oil column of specific grav 0.8 in meter of Hg 2) in meter of oil column…

A: Here, p=25 kPa, S01.8i.e. ρoil=ρ0=ρwS0=1000×=8000 kg/m3

Q: A mercury-water (Shg=13.6) U-tube manometer has a gage difference of 500 mm. The difference in…

Q: If four different closed-end manometers were created for the same sample with the same diameter for…

A: According to hydrostatic pressure, the pressure in the sample can be written in terms of vertical…

Q: 5. A manometer with arms of unequal diameters have cross sectional areas of 10 cm² and 5 cm²,…

Q: The surface tension of water in contact with air is given as 0.71 N/m. Pressure inside a droplet of…

A: Given data σ=0.71 N/m∆P=120 N/m2

Q: 2. Two-fluid U tube. In Fig. 2.2-4b a two-fluid U tube is shown, which is a sensitive device for…

A: Solution: Given Data:

Q: Predict the changes of the differential height in the manometer if a fluid with the density lower…

Q: Industrial Application of differential U tube manometer?

Q: What is the pipe pressure (pa)? Given the S for Mercury is 13 and S for fluid =0.6 Patm Air fluid 30…

Q: Calculate the gas pressure, of air density is 1.22 Kg/m3, L-200 mm * Patm Gas at pressure p Tank…

A: Given:- L = 200 mm = 0.2 m Air density = 1.22 kg/m3 To Find:- Gas Pressure (P)

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe…

Q: 1-In-compressible fluid flow in pipe line, there are two kinds...... a-Transition & turbulent flow…

A: This question is based on the concept of surface tension and fluid flow from fluid mechanics.

Q: Q2: A 1.78 L four-stroke petrol engine was tested at 2500 rpm. The developed brake power is 28 kW…

A: Given Volume, V= 1.78 L = 0.00178 m3 Brake power, BP = 28 kW Speed, N = 2500 rpm…

Q: A differential manometer connects two pipelines as shown. Fluid 1 is water and fluid 2 is glycerin…

Q: B4. An orifice meter with orifice area 913 mm2 is inserted in a pipe of area 1826 mm2 The pressure…

Q: The cross-sectional area of one limb of a U-tube manometer (figure shown below) is made 500 times…

A: Answer: The percentage error involved is 0.2 %.

Q: best fits between the options of the graph A, B, C, D and F,

A: Given:- Static head= 85 Capacity= 195 To Find:- Best impeller & Expected Power consumption

Question

APrandtl tube (Pitot-static tube with C= 1) is used to measure the velocity of water. The differential manometer reading is 10 mm of liquid column with a relative density of 10 Assuming g-9.8m/ the velocity of water (in m/s) is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

please solve the termodynamcis question. NOTE: PREVIOUS QUESTİON HAS AN ERROR WİTH THE EQUATION OF P P=C.(V^(1/3)) AS INDICATED IN THE PHOTO.
Find the difference in pressure head and velocity of flow of an oil through a pipe, when the difference of mercury level in a different U-tube manometer connected to the two tappings of the pitot tube as 108 mm. Take co-efficient of the pitot tube ("L" shaped measuring instrument) as 0.9 and sp. gr of oil = 0.8 Difference in pressure head (unit in mm) = Velocity of flow (unit in km/hr) =
8 P Flag question Two ends of an U-tube manometer which contains mercury, is connected between two pipes (A & B), that carries of oil of specific gravities 1.8 & 1.2 respectively. The center of the pipe A (left limb) is 12 cm above the pipe B (right limb). The mercury level difference in the right limb is 3.1 cm and the height of fluid in the right limb is 6.2 cm. Find the pressure difference between these two pipes in Kilo Pascal (kPa). Draw the diagram. (diagram (Please solve the problem in a paper and upload in the separate submission link provided and also fill the answers without the unit in the box below) The difference of pressure between the pipes A & B in (kPa) = Question 13 II
Q5: A U-shaped tube contains water, if it rotates around one of its arms at a speed of 100 rpm, what will be the difference between the fluid levels in the arms? 100 rpm 2 -0.5m h
If the viscosity of water at 68 oF is 0.01008 poise, then its absolute viscosity expressed in terms of pound-second per square feet (lb-sec/ft^2) must be
Convert
The U Tube manometer is widely used to measure the differencelin pressure between tMo donta in a given flow system. As an example, a manometer connected betweeti pipesA and B is stiowti devermi pressure difference in the two pipes. All dimensions shown are in centimeters. Kerosene Benzene P 20 Mercury Weter
using: Step 1: Known, UnknownStep 2: SchematicStep 3: FormulaStep 4: CalculationsStep 5: Discussion find