Match the following. ✓ Engines ✓ Power cycles ✓ Gas cycles - Closed cycles ✓ External combustion engines ✓ Internal combustion engines - heat pumps ✓ Air conditioners A. the working fluid is returned to the initial state at the end of the cycle and is recirculated B. heat is supplied to the working fluid from an external source such as a furnace, a geothermal well, a nuclear reactor, or even the sun C. D. fluid exists in the vapor phase during one part of the cycle and in the liquid phase during another part. E. the working fluid is renewed at the end of each cycle instead of being recirculated F. used to produce a net power input G. the working fluid remains in the liqid-gaseous phase throughout the entire cycle H. devices or systems used to produce a refrigeration effect 1. devices or systems used to produce a net power output. J- thermodynamic cycles that shows the operation of engines. K. working fluid remains in the gaseous phase throughout the entire cycle. L- heat supplied by burning the fuel within the system boundaries

Match the following. ✓ Engines ✓ Power cycles ✓ Gas cycles - Closed cycles ✓ External combustion engines ✓ Internal combustion engines - heat pumps ✓ Air conditioners A. the working fluid is returned to the initial state at the end of the cycle and is recirculated B. heat is supplied to the working fluid from an external source such as a furnace, a geothermal well, a nuclear reactor, or even the sun C. D. fluid exists in the vapor phase during one part of the cycle and in the liquid phase during another part. E. the working fluid is renewed at the end of each cycle instead of being recirculated F. used to produce a net power input G. the working fluid remains in the liqid-gaseous phase throughout the entire cycle H. devices or systems used to produce a refrigeration effect 1. devices or systems used to produce a net power output. J- thermodynamic cycles that shows the operation of engines. K. working fluid remains in the gaseous phase throughout the entire cycle. L- heat supplied by burning the fuel within the system boundaries

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

As shown in the figure, Refrigerant 22 enters the compressor of an air conditioning unit operating at steady state at 40°F, 80 lbp/in² and is compressed to 160°F. 200 lb/in?. The refrigerant exiting the compressor enters a condenser where energy transfer to air as a separate stream occurs, and the refrigerant exits as a liquid at 200 lb/in², 90°F. Air enters the condenser at 75°F, 14.7 lb/in² with a volumetric flow rate of 1000 ft3/min and exits at 110°F. Neglect stray heat transfer and kinetic and potential energy effects, and assume ideal gas behavior for the air. Step 1 Compresser 1+R22 Hint Step 2 mg22 = 7.026 7-11 wwwww www Wa= 7₂=160 F P-200 7₁-4FF P-80² Your answer is correct. Determine the mass flow rate of refrigerant, in lb/min. Determine the mass flow rate of refrigerant, in lb/min, and the compressor power, in horsepower. * Your answer is incorrect. 2.125 -Condemer lb/min Determine the compressor power, in horsepower. Aus at T P 1471² (AV) 7₁-90°F Py = 200 m² hp P == 300…
Water is the working fluid in a vapor power plant. Steam enters the turbine at 4 MPa, 540 °C, and exits the turbine as a two-phase, liquid vapor mixture at 27 °C. The condensate exits the condenser at 25 °C. The turbine efficiency is 90% and the pump efficiency is 80%. The power developed is 1 MW. ▾ ▼ Part A Determine the steam quality at the turbine exit. Express your answer to four significant figures. x = Submit Part B m = Determine the mass flow rate. Express your answer to two decimal places. Submit VAZ Ivec h A Part C Request Answer | ΑΣΦ | | vec S Request Answer Determine the thermal efficiency, Express your answer to four significant figures. 1971 ΑΣΦ | | | vec ← O C pw! 229 ? ? ? kg/s
Steam enters the turbine of a vapor power plant at 600 lbf/in.², 1000°F and exits as a two-phase liquid-vapor mixture at 90°F. Condensate exits the condenser at 85°F and is pumped to 600 lbf/in.² The turbine and pump isentropic efficiencies are 90 and 80%, respectively. The net power developed is 1 MW. Determine: (a) the percent steam quality at the turbine exit. (b) the percent thermal efficiency. (c) the steam mass flow rate, in lb/h.
As shown in the figure, Refrigerant 22 enters the compressor of an air conditioning unit operating at steady state at 40°F, 80 lb;/in? and is compressed to 160°F, 200 Ib;/in?. The refrigerant exiting the compressor enters a condenser where energy transfer to air as a separate stream occurs, and the refrigerant exits as a liquid at 200 Ib:/in?, 90°F. Air enters the condenser at 70°F, 14.7 lb:/in? with a volumetric flow rate of 750 ft/min and exits at 110°F. Neglect stray heat transfer and kinetic and potential energy effects, and assume ideal gas behavior for the air. Condenser Air at T P4=14.7 1bf'in.? (AV), 5 4 wwww T I; =110°F 3 p2 = p3 = 200 ib/in = 60°F T,= 160°F P2= 200 lbfin. T3- 90'F P=200 Ibf/in2 T3 = 90°F pi = 80 lbrin? T1 Compressor = 40°F 1+ R22 at Iz = 40°F Pi - 80 Ibf/in.? Determine the mass flow rate of refrigerant, in Ib/min, and the compressor power, in horsepower.
Q1: An engineer claimed that his device produces two streams of 1 am air (outlet 1) and 1.5 atm (outlet 2) at temperatures of 460 °R and 635 °R, respectively, if he enters 530 °R of the air at 5.1 atm. If the ratio of outlet 2 to outlet 1 is 0.6, justify the engineer's claim. Assume ideal gas process with a constant heat capacity of 0.24 Btu/lb.°R.
a.Draw a schematic diagram with labels of states of a substance; b.For uniformity purposes, assign STATE 1 at the inlet of a high-pressure turbine. The states must be arranged in a chronological order; c.Plot each cycle in a t-s diagram with the states consistent to the states assignment in the schematic diagram; d.Show a detailed solution. Consider a regenerative vapor power cycle with a single open feedwater heater. Steam enters the first turbine stage at 12MPa, 500 0C, and expands to 0.3MPa where some steam is extracted and fed to the feedwater heater. The remainder expands through the second-stage turbine and exits at the condenser pressure of 0.01 MPa. Saturated liquid at 0.3 MPa leaves the open feedwater heater. If the net power output of the cycle is 100 MW,and the turbine stages and pumps are isentropic, determine (a) the thermal efficiency, and(b) the mass flow rate of steam entering the first turbine, in kg/h.
PLEASE FOLLOW THE INSTRUCTION.
→Gas supply line- Gas A 1.4 m3 tank initially contains a gas at 130 kPa, 330 K. The tank is connected a line carrying same gas at 1300 kPa and 330 K. What should be heat transfer during this process, in kJ, so that the final pressure and temperature are 1300 kPa and 330 K, respectively. (cp=0.68 kJ/kg.K, cv=0.46 kJ/kg.K).
Steam enters the turbine of a vapor power plant at 600 lbf/in.2, 1000°F and exits as a two-phase liquid–vapor mixture at 90°F. Condensate exits the condenser at 85°F and is pumped to 600 lbf/in.2 The turbine and pump isentropic efficiencies are 90 and 80%, respectively. The net power developed is 1 MW.Determine:(a) the percent steam quality at the turbine exit.(b) the percent thermal efficiency.(c) the steam mass flow rate, in lb/h.
The components of a Steam Power Plant are Boiler, Turbine, Pond, Pump Boiler, Turbine, Condenser, Pump Boiler, Turbine, Condenser, Motor Boiler, Gas turbine, Condenser, Pump
Refrigerant 22 is the working fluid in a Carnot refrigeration cycle operating at steady state. The refrigerant enters the condenser as saturated vapor at 36°C and exits as saturated liquid. The evaporator operates at -30°C. Determine, in kJ per kg of refrigerant flowing, the net work in the cycle. A 20.37 B 36.47 18.37 24.37
Thermodynamics 1 Pls asap Po thankyou