Match the following attributes ofa city with the appropriate scale ofmeasurements:Attribute(P) Average temperature (°C)of a city(Q) Name of a city(S)(R) Population density of a cityRanking of a city basedon ease of BusinessScale ofMeasurement(I) Interval(II) Ordinal(III) Nominal(IV) RatioWhich one of the followingcombinations is correct?A) (P)-(I), (Q)-(III), (R)-(IV), (S)-(II)B) (P)-(II), (Q)-(I), (R)-(IV), (S)-(III)c) (P)-(II), (Q)-(III), (R)-(IV), (S)-(I)D) (P)-(I), (Q)-(II), (R)-(III), (S)-(IV)

Average temperature of city is measured in - Interval Name of a city - Nominal

Match the following attributes of a city with the appropriate scale of measurements: Attribute (P) Average temperature (°C) of a city Name of a city Population density of a city (Q) (R) (S) Ranking of a city based on ease of Business Scale of Measurement (I) Interval (II) Ordinal (III) Nominal (IV) Ratio Which one of the following combinations is correct? A) (P)-(I), (Q)-(III), (R)-(IV), (S)-(II) B) (P)-(II), (Q)-(I), (R)-(IV), (S)-(III) c) (P)-(II), (Q)-(III), (R)-(IV), (S)-(I) D) (P)-(I), (Q)-(II), (R)-(III), (S)-(IV)

Match the following attributes of a city with the appropriate scale of measurements: Attribute (P) Average temperature (°C) of a city Name of a city Population density of a city (Q) (R) (S) Ranking of a city based on ease of Business Scale of Measurement (I) Interval (II) Ordinal (III) Nominal (IV) Ratio Which one of the following combinations is correct? A) (P)-(I), (Q)-(III), (R)-(IV), (S)-(II) B) (P)-(II), (Q)-(I), (R)-(IV), (S)-(III) c) (P)-(II), (Q)-(III), (R)-(IV), (S)-(I) D) (P)-(I), (Q)-(II), (R)-(III), (S)-(IV)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Convert 2500 inches /hour to feet/ min
Q= 1.Explain the term “Atmospheric pressure”. 2.Explain the basic components of air pollution problem Civil Engineering Subject= Enviromental Engineering 2
Using the information given in Table 10.4 , determine the ratio of local pressure and density to sea-level values. Estimate the value of air density at the cruising altitude of most commercial airliners.
An object was left in a room of unknown surrounding temperature. The temperature of the object was summarized below with respect to the time t (in minutes) the object was initially observed. Predict and complete the information, i.e. determine the temperature in Celsius when t= 30 minutes. Put your answer accurate up to four decimal places. When t= 0, the temperature of the object is 30 degrees Celsius. • When t= 10 minutes, the temperature of the object is 32 degrees Celsius. • When t= 20 minutes, the temperature of the object is 33.6 degrees Celsius. • When t= 30 minutes, the temperature of the object is unknown. Assume the system obeys Newton's Law of Cooling and the surrounding temperature of the room did not change.
I need the answer as soon as possible
Answer question 6 subject is Environmental Engineering
If a user runs the engine for 1.55 hrs, determine the estimated fuel consumption using the newton and Lagrange interpolation methods with step ty...
QI: Convert to SI units, using any convenient prefix like u, m, e, k, M, G, etc. Show how you did it, displaying all the needed conversion factors that you used, with their units. a) 1.00 day b) 65 miles/hour Q2: A long freight train travelling at 120 km/h (towards the cast on a straight track) needs a distance of 1.6 km to brake to a stop. a) (6) Find the acceleration that is required, in m/s (also give its dircction). b) (6) How much time does it take for the train to stop? Q3: A car is accelerated from rest to a velocity of 66 km/h over a distance of 2000 m. (a) How long did the acceleration last? (b) Calculate the acceleration. Q4: 1) Find the value of x that makes a perpendicular with b if a =i+j+3k. , b= 2i + 7j - xk 2) Find the angle between e and d when c= 3i + 2j - 3k. , d=i+ 4j +k
A weather reports indicates the barometers pressure is 28.54 inches of mercury. What is the atmospheric pressure in pounds per inch?