You must show all pertinent solutions and the illustration that supporting the answer. Please list the given and the formula that had been used. Box the answer. Please complete the prodecure and the solution and the figure. A zoology graduate student is provided with a bow and arrow tipped with a syringe of sedative and isassigned to measure the temperature of a black rhinoceros. The range of his bow when it is fully drawnand aimed 45* above the horizontal is (91 + 4.2) m. An aggressive rhino suddenly charges straighttowards him at (21 + 2.4) km/hr. If he fully draws his bow and in panic, he aimed at 20" above thehorizontal, how far away should the rhino be when the student releases the arrow?20

initially the fully drawn bow is at 45 degree reaches a range R = 100 M P = ζ0 cos α) time and…

Answered: m. An aggressive rhino suddenly ca he…

m. An aggressive rhino suddenly ca he fully draws his bow and in panic, he aimed at e rhino be when the student releases the arrow

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter8: Time And Time-related Variables In Engineering

Section: Chapter Questions

Problem 31P

See similar textbooks

Related questions

Q: A closed cylindrical vessel, axis vertical 4m high and Im in diameter is just filled with water. At…

Q: Solve for the centroid of the given composite structural section and determine the moments of area…

Q: An auto A is moving at 6m/s and accelerating at 1.5m/s^2 to overtake an auto B which is 115.2m…

Q: 3. Water flows at the rate of 5 ft/s through an inclined pipe. At point A, where the diameter is 12…

Q: e AB has a width of 1.5 m and m. Determine the horizontale ical components of reaction

A: According to given data Plate AB has a width of 1.5 m and a radius of 3 m. To , Determine the…

Q: What percentage of the BOD is being removed by this treatment plant (6)?

A: BOD means biochemical oxygen demand.It is the amount of oxygen required for microorganisms to…

Q: Two 3/16" E70 fillet welds of 15 in. Iong are subjected to a load P. Using LRFD, compute the…

A: Answer (a) Minimum weld length requirement Minimum weld length may not be less than 4 times the…

Q: The bell crank in (Figure 1) is pinned at A and supported by a short link BC. It is subjected to the…

A: The given data is: F=80 KN At the point D: The area will be A=0.04*0.0193=7.72*10-4 m2

Q: The 600-kg uniform beam is subjected to the three external loads shown. Compute the reactions at the…

A: Using equilibrium equation

Q: a Find the distance x between the points (1,4) and (5, –8).

A: Distance X between two points is calculated as follow

Q: A very long, 10.0-ft-wide, concrete rectangular channel with a slope of 0.001 ends with a free…

A: A concrete rectangular channel, with uniform flow Slope, S = 0.001 Width, B = 10.0 ft As per the…

Q: Compute the moment about point A. Use F1-300 lb, F2-250 lb and F3-200 lb. Show all work on your…

A: Newton's third law states that when two bodies interact, they apply forces to one another that are…

Q: Situation 4: Given the adjusted latitude and departure of the closed traverse. Determine the length…

Q: Determine the state of stress at point B on the cross section of the post at section a-a. Indicate…

A: solution attached below

Q: Determine the external reactions at A and F for the roof truss loaded as shown. The vertical loads…

Q: For the plate and loadings shown, determine the reaction at A and B. 75 lb in. 60 lb 10 in. B A. -…

Q: Draw the FBD of beam AB. Indicate the distances, angles, forces, appropriately. 30° 0.6 m 0.9 m…

Q: . A platinum bar increases in length by 0.2% when its temperature increases to 222°C. a. Draw the…

Q: You must show all pertinent solutions and the illustration that supporting the answer. Please list…

A: To determine: acceleration of each block tension in the cable Given, Mass of block A (MA) = (21…

Q: SITUATION 17: A short column is subjected to a factored axial load Pu = 3790 kN, fc' = 27.6 MPa and…

A: Given a short column carrying a factored axial load of 3790kN Required- to find minimum gross…

Q: Determine the maximum value of Qof the Transverse Shear Stress formula (T (VQ)/(1t)] in mm for the…

Q: A pump delivers water through a smooth pipe 150mm in diameter and 250m long to a hydrant to which is…

A: Given, Cv = 0.97 f = 0.025 for smooth pipe and 0.02 for hose

Q: The uniform beam weighs 200 kg and carries a 500 kg crate as shown. Determine the reaction at the…

Q: Problem 1: A rectangular magnesium bar having a cross section width of 4.8mm and its length is six…

Q: A) Length of BC (round to 2 decimal places) B) Length of AB (round to 2 decimal places) C) Area of…

A: (A) BC= 244.92 m (B) AB=334.59 m (C) Area= 35486.09 sqm

Q: Situation 3: The diagram illustrates a chute in a factory used for sliding boxes to a lower floor.…

Q: etermine the position of the centroid for the following figures shown below and compute the moment…

A: Given a hollow rectangular beam and it is required to compute the moment of inertia with respect to…

Q: Please solve it very correctly. I need the correct solution. Thank you. Last two digit of the…

Q: The pipeline is 25 cm in diameter, 1000 m long and friction factor of the pipe is 0.020. If 120…

A: Diameter of pipeline = 25 cm = 0.25 mLength of pipeline = 1000 mFriction factor of pipe, f =…

Q: Determine the support reactions and draw the Shear and Moment Diagram. Note: All upward forces are…

Q: Draw the influence lines for the shear in panel BC and the moment at F. B A FG 2 m 2 m

A: Data Given: Asked: Influence Line for the shear in panel BC Moment at F

Concept explainers

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.

Question

You must show all pertinent solutions and the illustration that supporting the answer. Please list the given and the formula that had been used. Box the answer. Please complete the prodecure and the solution and the figure.

A zoology graduate student is provided with a bow and arrow tipped with a syringe of sedative and is
assigned to measure the temperature of a black rhinoceros. The range of his bow when it is fully drawn
and aimed 45* above the horizontal is (91 + 4.2) m. An aggressive rhino suddenly charges straight
towards him at (21 + 2.4) km/hr. If he fully draws his bow and in panic, he aimed at 20" above the
horizontal, how far away should the rhino be when the student releases the arrow?
20

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 10kg boy jumps on the ground from a 1.3m high table. The magnitude of impulse (in N-sec) that he receives on hitting the ground is....... N-S (take g = 9.8/s²) (Round of to one decimal places)
A man fires a target with a bullet's velocity of 920m/s. After 2.30 seconds, he hears the sound of the bullet that strikes the target. Assuming sound has a constant velocity of 360m/s, how far is the target from the man in meters?
The projectile with a velocity of 10m/s is fired at a certain angle such that it can reach the farthest point on the ground. Which of the following most nearly gives the time for the projectile to reachcthe gdkund surface?
I need the answer as soon as possible
The temperature-controlled environment in a hospital intensive care unit is monitored by an intelligent nstrument that measures temperature every minute and calculates the mean and standard deviation of he measurements. If the mean is 50°C and the standard deviation (o) is 2.15, (a) What percentage of the time is the temperature less than 45°C? (b) What percentage of the time is the temperature between 47°C and 53°C? (c) Determine the value of r such that 90% of measurements lie within the boundaries of txo.
A fireworks show is choreographed to have two shells cross paths at a height of 172 feet and explode at an apex of 220 feet under normal weather conditions. If the shells have a launch angle 0 = 63° above the horizontal, determine the common launch speed vo for the shells, the separation distanced between the launch points A and B, and the time t from launch at which the shells explode.
Two rockets are launched at a fireworks display. Rocket A is launched with an initial velocity v0 = 120 m/s and rocket B is launched t1 seconds later with the same initial velocity. The two rockets are timed to explode simultaneously at a height of 350m as A is falling and B is still rising. a) The time t1 (so that A&B will explode at the same time) b) The relative velocity of A with respect to B at the time of the explosion. note: please use 3 decimal places
A projectile is fired from the top of a cliff 100m high with a velocity of 450 m/s directed at 45 degrees to the horizontal. Based from this problem, find the value of vx. A 318.200m/s B 320.500m/s c) 350m/s D 450m/s E) none
7. A projectile is shot vertically upward with a speed of 100 m/s. How long does it take to reach the maximum altitude? * О a.3.1 s O b. 5.0 s O e. 15.2 s O d. 12.0 s O c. 10.2 s
A nozzle inclined at an angle of 60° with the horizontal issues a 114.31-mm diameter water jet at the rate of 14 m/s. Neglecting air resistance, what is the area (in m2) of the jet at the highest point of the projectile? Round off to four decimal places.
Kindly answer all the question and box your answers thank you
O1