M Consider the figure above... A clay block has a mass of 1.0 kg. It rests upon on a friction-less, horizontal surface. The blokc is attached to a rigid rod of length 0.45 m, and of negligible mass. The rod is pivotted at the other end. A bullet of mass 3.3 g traveling parallel to the horizontal surface and perpendicular to the rod with speed 223 m/s hits the block and becomes embedded in it. (a) What is the angular momentum of the bullet/block system about a vertical axis through the pivot? (b) What fraction of the original kinetic energy of the bullet is converted into internal energy in the system during the collision?

M Consider the figure above... A clay block has a mass of 1.0 kg. It rests upon on a friction-less, horizontal surface. The blokc is attached to a rigid rod of length 0.45 m, and of negligible mass. The rod is pivotted at the other end. A bullet of mass 3.3 g traveling parallel to the horizontal surface and perpendicular to the rod with speed 223 m/s hits the block and becomes embedded in it. (a) What is the angular momentum of the bullet/block system about a vertical axis through the pivot? (b) What fraction of the original kinetic energy of the bullet is converted into internal energy in the system during the collision?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The figure shows an overhead view of a 2.70 kg plastic rod of length 1.20 m on a table. One end of the rod is attached to the table, and the rod is free to pivot about this point without friction. A disk of mass 53.0 g slides toward the opposite end of the rod with an initial velocity of 20.5 m/s. The disk strikes the rod and sticks to it. After the collision, the rod rotates about the pivot point. (a) What is the angular velocity, in rad/s, of the two after the collision? rad/s (b) What is the kinetic energy, in joules, before and after the collision? KEi = J KEf = J
The figure shows a small piece of clay colliding into a disk. The disk is initially at rest, but can rotate about a pivot fixed at its center. The collision is completely inelastic.1) The disk has mass M = 4.73 kilograms and radius R = 0.755 meters. The clay has mass m = 279 grams and is moving horizontally at vi = 3.66 m/s just before colliding with and sticking to the disk. The clay strikes the edge of the disk at a location of b = 0.505 meters offset from the center of the disk. Note that the size of the clay is negligible compared to the radius of the disk. 2) Calculate the angular velocity (rad/s) of the disk just after the collision.
A solid cylinder of mass M = 42 kg, radius R = 0.17 m and uniform density is pivoted on a frictionless axle coaxial with its symmetry axis. A particle of mass m = 2.2 kg and initial velocity vo = %3D %3D 12 m/s (perpendicular to the cylinder's axis) flies too close to the cylinder's edge, collides with the cylinder and sticks to it.Before the collision, the cylinder was not rotating. What is the magnitude of its angular velocity after the collision? Your answer
A 2.5 kg wooden block hangs from the end of a 1.4 kg, 1.0 m long iron rod that swings from a frictionless hinge at the top end of the rod. A 12 g bullet is shot horizontally into the block where it sticks, causing the pendulum system to swing out to a 33° angle. What was the speed of the bullet? The moment of ML2 3 where M is the mass and Lis inertia of the iron rod is the length of the rod. O 367 332 436 458 8 S m S m S
A turntable s pins on a frictionless bearing. Its moment of inertia is 3.00 x 10-2 kg m2. It initially rotates at 25.0 rev/min about an axis through its center. Then, a 0.6-kg ball of putty is dropped vertically onto the turntable. It lands and sticks at a point 0.10 m from the center. By what factor does this collision change the angular momentum of the system? That is, Lafter = [factor] x Lpefore- (Hint: Since it moves vertically the putty has initial angular momentum of zero.) O a. 1.22 b.0.820 c. 1.00 (no change) d. 1.20
A 1.7 m wide door (mass 4.0 kg) is hinged at one side so that it can rotate without friction about a vertical axis. It is unlatched. A police officer fires a bullet with a mass of 80 g and a speed of 450 m/s into the edge of the door, in a direction perpendicular to the plane of the door. Find the angular speed of the door just after the collision if the bullet embeds itself in the door. The moment of inertia of a door rotating about its edge is equal to MW2 where M is the mass of the door and W is its width. Before After W W W W
A. A light, rigid rod of length L = 1.00 m joins two particles, with masses m_1 = 4.00 kg and m_2 = 3.00 kg, at its ends. The combination rotates in the xy-plane about a pivot through the center of the rod (see figure below). Determine the angular momentum of the system about the origin when the speed of each particle is 7.40 m/s. B. What would be the new angular momentum of the system (in kg · m2/s) if each of the masses were instead a solid sphere 13.5 cm in diameter?
While sunbathing on the balcony of your 3rd floor apartment, you notice a gorilla drop a m = 38.2 kg crate from rest from the roof of the 5-story building across the street. Since you just completed a course on surveying, you know that the two identical buildings are d = 29 m apart, and have floors that are h = 5.1 m tall. The first floor is at ground level, as shown.a. Determine the magnitude of the angular momentum of the crate, in kilogram meters squared per second, as observed by you as it passes the floor of the 4th floor balcony of the other building. Lb =b. Determine the magnitude of the angular momentum of the crate, in kilogram meters squared per second, as observed by you as it passes the floor of the 3rd floor balcony of the other building, directly across from you. Lc =c. Determine the magnitude of the angular momentum of the crate, in kilogram meters squared per second, as observed by you as it passes the floor of the 2nd floor balcony of the other building. Ld =d.…
Chapter 11, Problem 067 The figure is an overhead view of a thin uniform rod of length 0.690 m and mass M rotating horizontally at 82.0 rad/s counterclockwise about an axis through its center. A particle of mass M/3.20 and traveling horizontally at speed 43.0 m/s hits the rod and sticks. The particle's path is perpendicular to the rod at the instant of the hit, at a distance d from the rod's center. (a) At what value of d are rod and particle stationary after the hit? (b) In which direction do rod and particle rotate if d is greater than this value? Rotation axis Particle (a) Number Units (b) Use correct number of significant digits; the tolerance is +/-2%
A bird flies overhead from where you stand at an altitude of 310.0ĵ m and at a velocity horizontal to the ground of 14.0î m/s. The bird has a mass of 1.8 kg. The radius vector to the bird makes an angle ? with respect to the ground. The radius vector to the bird lies in the xy-plane. What is the bird's angular momentum (in kg · m2/s) about the point where you are standing? (Express your answer in vector form.)
On a frictionless table, a 0.56 kg glob of clay strikes a uniform 1.26 kg bar perpendicularly at a point 0.35 m from the center of the bar and sticks to it. If the bar is 1.06 m long and the clay is moving at 9.30 m/s before striking the bar, what is the final speed of the center of mass?
A rod of mass M = 3.25 kg and length L can rotate about a hinge at its left end and is initially at rest. A putty ball of mass m = 65 g, moving with speed v = 5.63 m/s, strikes the rod at angle θ = 55° from the normal at a distance D = 2/3 L, where L = 1.25 m, from the point of rotation and sticks to the rod after the collision. a) What is the initial angular momentum of the ball, in kilogram meters squared per second, right before the collision relative to the pivot point of the rod? b)What is the total moment of inertia If with respect to the hinge, of the rod-ball-system after the collision, in terms of the variables from the problem statement? c) What is the angular speed ωf of the system immediately after the collision, in radians per second?