loving to another question will save this response. con 37 A pressure gage 10.82 m. above the bottom of a tank containing a liquid reads 58.09 kPa; another gage at height 3.39 m. reads 83.33 kPa. Determine the density of the liquid. Round off to three decimal places. Question 37 of 48>

loving to another question will save this response. con 37 A pressure gage 10.82 m. above the bottom of a tank containing a liquid reads 58.09 kPa; another gage at height 3.39 m. reads 83.33 kPa. Determine the density of the liquid. Round off to three decimal places. Question 37 of 48>

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. At ground level the atmospheric pressure is 101.3 KPa at 15°C. Calculate the pressure at a point 6500m above the ground, assuming no density variation. 2. The gage at the suction side of a pump shows a vacuum of 25cm of mercury. Compute a. Pressure head in meter of water b. Pressure in KPa c. Absolute pressure in KPa if the barometer reads 755cm of mercury 3. A piece of timber 3m long and having a 30cm by 30cm section is placed in a body of water in a vertical position. If the timber weighs 6.5 KN/m² what vertical force is required to hold it with its upper end flush with the water surface. 4. A glass tube 1.6m long and having a diameter of 2.5cm is inserted vertically into a tank of oil (s.g. = 0.80) with the open end down and the closed end uppermost. If the open end is submerged 1.30m from the oil surface, determine the height to which the oil will rise in the tube. Assume barometric pressure is 100 KPa and neglect vapor pressure.
An inverted U-tube of the form shown in Fig. 2.18 is used to measure the pressure difference between two points A and B in an inclined pipeline through which water (density1000 kg/m³) is flowing. The difference of level h = 0.3 m, a = 0.25 m and b = 0.15 m. Calculate the pressure difference PB - PA if the top of the manometer is filled with (a) air, (b) oil of relative density 0.8. Fluid, density Pman 4 D. Liquid, density p Figure 2.18 Inverted U-tube manometer
X=1, y=5
A pressure gauge at elevation 3 m at the side of a tank containing a liquidreads 88 kPa. Another gauge at elevation 11 m. reads 122 kPa. Computethe specific gravity of the liquid. Use 2 decimal places.
bai 9
SUBJECT IS HYDRAULICS SHOW DETAILED AND COMPLETE SOLUTION USED 3 DECIMALS FOR THE FINAL ANSWER A manometer is attached to a vessel containing different fluids as shown below. Compute the value of "y" in meters. ELEV 9.0 m Air pressure = 30 kPa ELEV 6.5 m Oil spgr = 0.7 ELEV 1.0 m- Water Elev. O m 1.00 m - Mercury (s.g. = 13.6)
A closed compartment shown contains water h= 2 m deep at the left side and H =9 m deep on the right side. If the pressure at point A is 92 kPa abs on the closed compartment, what is the absolute pressure in kPa at point B considering specific weight of air = 0.118 kN/m3. Image not to scale. Round your answers in 3 decimal places.
I need the answer as soon as possible
The tank in figure shown, contains oil of specific gravity of 0.82. Determine the reading of gage A in KPa. If the tank is compressed with a gage pressure reading of 61.7 kg/sq.m., what will be the final reading in gage A (reading in absolute pressure), assuming no change in reading at gage B.
For the following inverted manometer setup, if the pressure at x is 200 kPa, what is the pressure at y? Oil(SG 0.90) 60 in. Px 10 in. Water Py 20 in.
As shown in the figure, a pump draws water from reservoir A (EI 25m) and lifts it to reservoir B (El 60m). The loss of head from A to 1 is 2 times the velocity head in the 200 mm pipe and the loss of head from 2 to B is 10 times the velocity head in the 150 mm pipe. Calculate the pressure head at point 1 when the discharge is 0.030 m³/s. Round off your answer to one decimal place. E1 25 7 Pl Answer: = 4 200 mm 2 m 150minh EL O El 60 B
A canal is cut into a soil with a stratigraphy shown below. Assume flow takes place laterally and vertically through the sides of the canal and vertically below the canal. The vaues of k = kx = k, in each layer are given. a.) What is the equivalent permeability in the horizontal direction through the sides of the canal, in cm/day. b.) What is the equivalent permeability in the vertical directions through the sides of the canal, in cm/day. c.) Determine the equivalent permeability in the vertical directions below the bottom of the canal, in cm/day.