Los valores de los elementos son: R1 = R2 = 1.5 KN y C = 100nF. R2 R2 C VENT W VENT W R1 VSAL ●VSAL C R1 +1 +,

Q: A low noise amplifier used in a satellite receiver generates an output signal power of 25.XY mW with…

A:

Q: The BER for a NRZ equally likely signal with ay = {o, 5} mV and noise power of 2 uWis approximately…

A: It is known that the nose bandwidth for an NRZ signal is half of the bit rate and the expression for…

Q: (b) A passive band-pass filter was used to filter out some noises and unwanted stray signals.…

A:

Q: Describe in your words the definition of bandwidth

A: Bandwidth:  It is the maximum data rate which transfer from the fixed channel over a particular…

Q: Find the size of the C-filter in an FWR needed to keep ripple values within 3%; the circuit is…

A:

Q: High Speed Digital : A single 10V pulse is sent down a 150 transmission line with a load resistance…

A: We need to calculate  the voltage when the signal reaches the load.

Q: filter specification a. What kind of filter is this? b. What is the transition band of the filter c.…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Q2: Channel I of two channels PAM system handles 8KHZ signal. Channel 2 handles 10KHZ signals. The…

A: Here is it given that frequency of channel 1 is 8 KHZ and frequency of channel 2 is 10KHZ and both…

Q: The relation between analog frequency 'F and digital frequency 'f is? a) F=f*T(where T is sampling…

A: Given, Analog frequency is F Digital frequency is f

Q: Explain the operation of frequency demodulation by using the PLL method.

A: According to the question, we need to explain the operation of frequency demodulation by using the…

Q: Q3/ Analyze and explain with drawing the sigma-delta ADC work?

A: Working of sigma-delta ADC work: The sigma delta modulator is a negative feedback system,…

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.